Luminescence

The contamination of beach waters occurs from the discharge of storm water and sanitary sewer overflows containing faecal material. Additional faecal material derives from discharge of animals and waterfowl. In order to protect public from exposure to faecal‐contaminated water, it is required to test enteric indicators in beach water. The problem is that the traditional culture‐based methods cannot meet this goal because it takes too long (>24 h), so the results are not available until a day later. A rapid method for testing beach water for Escherichia coli within 1 h has been developed. Immunomagnetic separation (IMS) and ATP bioluminescence were used for selective capture and quantification, respectively. This rapid method was compared to the current method (m‐TEC) using beach water samples. The beach samples were prefiltered with a 20 µm pore size filter in order to remove algae, plant debris and large particles. The results showed that the prefiltration step did not trap the bacteria which were present in the original water samples. The prefiltered water was then passed through a 0.45 µm pore size filter for concentration. The deposited bacteria were resuspended and then mixed with superparamagnetic polystyrene beads (diameter of 0.6 µm) that were coated with E. coli antibodies. After IMS, the quantification of the E. coli was done by ATP bioluminescence. The results obtained with IMS‐ATP bioluminescence correlated well with the plate count method (Rsq = 0.93). The detection limit of the assay was about 20 CFU/100 mL, which is well below the US EPA limits for recreational water. The entire procedure can be completed in less than 1 hour. The necessary equipment is portable and was tested on‐site. Copyright © 2004 John Wiley & Sons, Ltd.

The new borate phosphor CaB₂O₄:Eu³⁺ was synthesized by solid‐state method and their photoluminescence properties were investigated. The results show that the pure phase of CaB₂O₄ could be available at 900°C, CaB₂O₄:Eu³⁺ phosphor could be effectively excited by the near ultraviolet light (NUV) (392 nm), and the luminescent intensity of CaB₂O₄:Eu³⁺ phosphor reached to the highest when the doped‐Eu³⁺ content was 4 mol%. The emission spectra of CaB₂O₄:Eu³⁺ phosphor could exhibit red emission at 612 nm and orange emission at 588 nm, which are ascribed to the ⁵D₀–⁷F₂ and ⁵D₀–⁷F₁ transitions of Eu³⁺ ions. Copyright © 2009 John Wiley & Sons, Ltd.

We report, in this article, a piperidin‐4‐one derivative carrying pyrenyl fluorescent reporter groups which acts as a Cd²⁺ ion sensor. The compound is synthesized and characterized using IR and NMR spectral techniques. The compound forms an inclusion complex with β‐cyclodextrin. It selectively binds to Cd²⁺ ions in water and aqueous β‐cyclodextrin media. The stoichiometry of the host–guest complex of the compound with β‐cyclodextrin is 1:2. The ligand–metal ion binding stoichiometry is 1:1 both in water and in β‐cyclodextrin. The linear concentration range of detection of the metal ion is reported. Cyclodextrin complex formation does not affect the metal ion selectivity of the compound.

In this study, tri‐functional immunofluorescent probes (Ce6–IgG–QDs) based on covalent combinations of quantum dots (QDs), immunoglobulin G (IgG) and chlorin e6 (Ce6) were developed and their photodynamic ability to induce the death of cancer cells was demonstrated. Strategically, one type of second‐generation photosensitizer, Ce6, was first coupled with anti‐IgG antibody using the EDC/NHS cross‐linking method to construct the photosensitive immunoconjugate Ce6–IgG. Then, a complex of Ce6–IgG–QDs immunofluorescent probes was obtained in succession by covalently coupling Ce6–IgG to water soluble CdTe QDs. The as‐manufactured Ce6–IgG–QDs maintained the bio‐activities of both the antigen–antibody‐based tumour targeting effects of IgG and the photodynamic‐related anticancer activities of Ce6. By way of polyclonal antibody interaction with rabbit anti‐human epidermal growth factor receptor (anti‐EGFR antibody, N‐terminus), Ce6–IgG–QDs were labelled indirectly onto the surface of human hepatocarcinoma (HepG2) cells in cell recognition and killing experiments. The results indicated that the Ce6–IgG–QDs probes have excellent tumour cell selectivity and higher photosensitivity in photodynamic therapy (PDT) compared with Ce6 alone, due to their antibody‐based specific recognition and location of HepG2 cells and the photodynamic effects of Ce6 killed cells based on efficient fluorescence resonance energy transfer between QDs and Ce6. Copyright © 2015 John Wiley & Sons, Ltd.

A simple, low‐cost and convenient method was developed for the synthesis of highly luminescent CdSe quantum dots (QDs) in an aqueous medium. Compared with previous methods, this synthesis was carried out in one pot using ascorbic acid (C₆H₈O₆) to replace NaBH₄ or N₂H₄ · H₂O as a reductant, and selenium dioxide to replace selenium or its other hazardous, expensive and unstable compounds as a precursor. The mechanism of CdSe QDs formation was elucidated. The influence of various experimental variables, including refluxing time, Cd/MSA and Cd/Se molar ratios, on the luminescent properties of the QDs were systematically investigated. X‐Ray powder diffraction and transmission electron microscopy characterization indicated that the QDs had a pure cubic zinc‐blended structure with a spherical shape. Copyright © 2015 John Wiley & Sons, Ltd.

Quantum dots (QDs) have been encapsulated within gelatin nanoparticles (GNPs), which gives GNPs fluorescent properties and improves the biocompatibility of QDs. Hydrophilic CdSe QDs were produced through thermodecomposition following the ligand‐exchange method, and were then encapsulated in GNPs. The results of high‐resolution transmission electron microscopy and transmission electron microscopy show that CdSe QDs and QDs‐encapsulated GNPs (QDs‐GNPs) have average diameters of 5 ± 1 and 150 ± 10 nm, respectively. Results of both high‐resolution transmission electron microscopy and confocal laser scanning microscopy indicate that CdSe QDs are successfully encapsulated within GNPs. The QDs‐GNPs have distinctive fluorescent properties with maximum emission at 654 nm, with a 24 nm red‐shift comapred with hydrophilic mercaptoundecanoic acid (MUA)‐modified QDs. In addition, an in vitro cytotoxicity test shows that QDs‐GNPs do not have any toxic effect on cells. It is expected that QDs‐GNPs might be an excellent candidate as a contrast agent in bio‐imaging. Copyright © 2013 John Wiley & Sons, Ltd.

In this study, we report for the first time a one‐pot approach for the synthesis of new CdSeTeS quaternary‐alloyed quantum dots (QDs) in aqueous phase by microwave irradiation. CdCl₂ was used as a Cd precursor during synthesis, NaHTe and NaHSe were used as Te and Se precursors and mercaptopropionic acid (MPA) was used as a stabilizer and source of sulfur. A series of quaternary‐alloyed QDs of different sizes were prepared. CdSeTeS QDs exhibited a wide emission range from 549 to 709 nm and high quantum yield (QY) up to 57.7 %. Most importantly, the quaternary‐alloyed QDs possessed significantly long fluorescence lifetimes > 100 ns as well as excellent photostability. Results of high‐resolution transmission electron microscopy (HRTEM), energy dispersive X‐ray spectroscopy (EDX) and powder X‐ray diffraction (XRD) spectroscopy showed that the nanocrystals possessed a quaternary alloy structure with good crystallinity. Fluorescence correlation spectroscopy (FCS) showed that QDs possessed good water solubility and monodispersity in aqueous solution. Furthermore, CdSeTeS QDs were modified with alpha‐thio‐omega‐carboxy poly(ethylene glycol) (HS‐PEG‐COOH) and the modified QDs were linked to anti‐epidermal growth factor receptor (EGFR) antibodies. QDs with the EGFR antibodies as labeling probes were successfully applied to targeted imaging for EGFR on the surface of SiHa cervical cancer cells. We believe that CdSeTeS QDs can become useful probes for in vivo targeted imaging and clinical diagnosis. Copyright © 2012 John Wiley & Sons, Ltd.

OX40 plays a prominent role in the onset and development of solid tumors, and OX40‐targeted monoclonal antibodies (mAbs) have entered clinical trials for various tumors. Bioactivity determination of therapeutic mAbs is of great significance in product quality, however, mechanism of action‐based bioassays to determine the bioactivity of anti‐OX40 mAbs is still lacking. Here, we established a reporter gene assay system based on two cell lines, namely Jurkat‐OX40‐NFκB‐Luc which stably expresses NFκB‐controlled luciferase, and Raji cells which inherently express FcγRs. In the model, FcγRs on Raji cells could crosslink the Fc of anti‐OX40 mAbs, which leads to the further crosslinking between Fab of anti‐OX40 mAbs and OX40 on Jurkat‐OX40‐NFκB‐Luc cells. OX40 crosslinking could activate Jurkat‐OX40‐NFκB‐Luc cells, and induce the expression of NFκB‐controlled luciferase, the extent of which could reflect the bioactivity of anti‐OX40 mAbs in a dose‐dependent manner. After the optimization of various assay conditions, the validation of the cell‐based bioassay showed good assay performance characteristics, including specificity, accuracy, precision, linearity, and stability. This innovative assay that is based on the OX40‐NFκB pathway can be a powerful pool to measure the bioactivity of OX40‐targeted mAbs.

In this work, an automated flow‐based procedure for the screening of the effect of the different phenolic compounds on the chemiluminescence (CL) luminol–hydrogen peroxide–horseradish peroxidase (HRP) system is presented. This procedure involves the combination of multisyringe flow injection analysis (MFSIA) and sequential injection analysis (SIA) techniques and exploits the ability of the different subgroups of phenols, such as cholorophenols, nitrophenols, methylphenols and polyphenols, to enhance or inhibit the described CL system. The implementation of this reaction in the SIA–MSFIA system enabled favourable and precise conditions to evaluate the effect of phenolic compounds, as it involves an in‐line reaction between the phenolic derivative, hydrogen peroxide and peroxidase and subsequent oxidized HRP intermediates generation prior to the fast reaction with the chemiluminogenic reagent. Several studies were then performed with the aim of establishing the appropriate flow system configuration and reaction conditions. It was shown that phenol and chlorophenols produce an enhanced CL response and nitrophenols, methylphenols and polyphenols are inhibitors within the range of concentrations studied (1–100 mg/L). Based on these studies, the developed method was applied to the determination of total polyphenol and phenol content in wine/grape seeds and water samples, respectively, and the results obtained showed good agreement with those furnished by the corresponding Folin–Ciocalteu and 4‐aminoantipyrine reference methods. The developed approach is further pursued by designing an automated generic tool for performing studies of peroxidase‐catalysed CL reactions of luminol focused on the detection of compounds that will affect the rate of those reactions. Copyright © 2011 John Wiley & Sons, Ltd.