Effects of extended punching on wear of the WC/Co micropunch and the punched microholes

Fecht HJ, Werner M (2004) The nano-micro interface: bridging the micro and nano worlds. Wiley-VCH, Weinheim

Mark JJ (2006) Microfabrication and nanomanufacturing. CRC/Taylor & Francis, Boca Raton FL

Christophe G (2003) Microsystems engineering: metrology and inspection III. SPIE, Bellingham Wash

Madou MJ (2004) Microfabrication challenge. Anal Bioanal Chem 378:11–14

Knobloch H, Kaminorz Y (2004) MicroNano integration. Springer, Berlin Heidlberg

Mohamed GH (2006) The MEMS handbook. CRC/Taylor & Francis, Boca Raton FL

Oliver G, Henning K, Pieter T (2004) Microsystem engineering of lab-on-a-chip devices. J Angewandte Chemie 43:4382–4390

Johnstone RW, Parameswaran M (2004) An introduction to surface-micromachining. Kluwer, Netherlands

Edwards SA (2006) The nanotech pioneers. J Angewandte Chemie 45:7116–7117

Haberstroh E, Hoffmann WM, Poprawe R, Sari F (2006) 3 laser transmission joining in microtechnology. J Microsyst Technol 12:632–639

Smolka G, Gillner A, Bosse L, Lützeler R (2004) Micro electron beam welding and laser machining—potentials of beam welding methods in the micro-system technology. J Microsyst Technol 10:187–192

Luo SY (1999) Effect of the geometry and the surface treatment of punching tools on the tool life and wear conditions in the piercing of thick steel plate. J Mater Process Technol 88:122–133

Bahloul R, Ayed BL, Potiron A, Batoz JL (2010) Comparison between three optimization methods for the minimization of maximum bending load and springback in wiping die bending obtained by an experimental approach. Int J Adv Manuf Tech 48:1185–1203

Delpozo D, López de Lacalle LN, López JM, Hernández A (2008) Prediction of press/die deformation for an accurate manufacturing of drawing dies. Int J Adv Manuf Tech 37:649–656

Mucha J (2010) An experimental analysis of effects of various material tool's wear on burr during generator sheets blanking. Int J Adv Manuf Tech 50:495–507

Joo BY, Rhim SH, Oh SI (2005) Micro-hole fabrication by mechanical punching process. J Mater Process Technol 170:593–601