Running-In of Systems Protected by Additive-Rich Oils

Meng, H.C., Ludema, K.C.: Wear models and predictive equations their form and content. Wear 181–183, 443–457 (1995) Archard, J.F.: Contact and rubbing of flat surfaces. J Appl Phys 24, 981–988 (1953) Põdra, P., Andersson, S.: Simulating sliding wear with finite element method. Tribol Int 32, 71–81 (1999) Olofsson, U., Andersson, S., Björklund, S.: Simulation of mild wear in boundary lubricated spherical roller thrust bearings. Wear 241, 180–185 (2000) Sfantos, G.K., Aliabadi, M.H.: Wear simulation using an incremental sliding boundary element method. Wear 260, 1119–1128 (2006) Shakhvorostov, D., Pohlmann, K., Scherge, M.: Structure and mechanical properties of tribologically induced nanolayers. Wear 260, 433–437 (2006) Shakhvorostov, D., Gleising, B., Büscher, R., Dudzinski, W., Fischer, A., Scherge, M.: Microstructure of tribologically induced nanolayers produced at ultra-low wear rates. Wear 263, 1259–1265 (2007) Hahn, H., Mondal, P., Padmanabhan, K.A.: Plastic deformation of nanocrystalline materials. Nanostruct Mater 9, 603–606 (1997) Kato, H., Sasase, M., Suiya, N.: Friction-induced ultra-fine and nanocrystalline structures on metal surfaces in dry sliding. Tribol Int 43, 925–928 (2009) Lu, L., Sui, M.L., Lu, K.: Superplastic extensibility of nanocrystalline copper at room temperature. Science 287, 1463–1466 (2000) Schiotz, J., Tolla, F.D.D., Jacobsen, K.W.: Softening of nanocrystalline metals at very small grain sizes. Nature 391, 561–563 (1998) Schiotz, J., Jacobsen, K.W.: A maximum in the strength of nanocrystalline copper. Science 301, 1357–1359 (2003) Lu, L., Li, S.X., Lu, K.: An abnormal strain rate effect on tensile behavior in nanocrystalline copper. Scripta Mater 45, 1163–1169 (2001) Wang, Z.B., Tao, N.R., Li, S., Wang, W., Lui, G., Lu, J., Lu, K.: Effect of surface nanocrystallization on friction and wear properties in low carbon steel. Mater Sci Eng 352, 114–119 (2002) Wang, Y., Lei, T., Liu, J.: Tribo-metallographic behavior of high carbon steels in dry sliding: III. Dynamic microstructural changes and wear. Wear 231, 20–37 (1999) Chen, X.H., Lu, J., Lu, L., Lu, K.: Tensile properties of a nanocrystalline 316L austenitic stainless steel. Scripta Mater 52, 1039–1044 (2005) Umemoto, M.: Nanocrystallization of steels by severe plastic deformation. Mater Trans 44, 1900–1911 (2003) Garbar, I.: Microstructural changes in surface layers of metal during running-in friction processes. Meccanica 36, 631–639 (2001) Nelias, D., Boucly, V., Brunet, M.: Elastic-plastic contact between rough surfaces: proposal for a wear or running-in model. J Tribol 128, 236–244 (2006) Jacq, C., Nelias, D., Lormand, G., Girodin, D.: Development of a three-dimensional semi-analytical elastic-plastic contact code. J Tribol 124, 653–667 (2002) Nelias, D., Antaluca, E., Boucly, V., Cretu, S.: A three-dimensional semianalytical model for elastic-plastic sliding contacts. J Tribol 129, 761–771 (2007) Godfrey, D.: Boundary lubrication. Nasa Sp-118. 335-373 (1968) Liu, S., Wang, Q.: Studying contact stress fields caused by surface tractions with a discrete convolution and fast Fourier transform algorithm. J Tribol 124, 36–45 (2002) Kim, H.S., Bush, M.B.: The effects of grain size and porosity on the elastic modulus of nanocrystalline materials. Nanostruct Mater 11, 361–367 (1999) Wang, F., Keer, L.M.: Numerical simulation for three dimensional elastic-plastic contact with hardening behavior. J Tribol 127, 494–502 (2005) Bosman, R., Schipper, D.J.: Running in of metallic surfaces in the boundary lubricated regime. Wear (in review) (2010) Liu, S.B., Wang, Q.: Elastic fields due to eigenstrains in a half-space. J Appl Mech Trans ASME 72, 871–878 (2005) Polonsky, I.A., Keer, L.M.: A numerical method for solving rough contact problems based on the multi-level multi-summation and conjugate gradient techniques. Wear 231, 206–219 (1999) Zhang, Z., Yamaguchi, E.S., Kasrai, M., Bancroft, G.M.: Tribofilms generated from ZDDP and DDP on steel surfaces: part I. Tribol Lett 17, 211–220 (2005) Ye, J.P., Araki, S., Kano, M., Yasuda, Y.: Nanometer-scale mechanical/structural properties of molybdenum dithiocarbamate and zinc dialkylsithiophosphate tribofilms and friction reduction mechanism. Jpn J Appl Phys 1 44, 5358–5361 (2005) Martin, J.M., Grossiord, C., Le Mogne, T., Bec, S., Tonck, A.: The two-layer structure of zndtp tribofilms part 1: AES, XPS and XANES analyses. Tribol Int 34, 523–530 (2001) Minfray, C., Martin, J.-M., Lubrecht, T., Belin, M., Mogne, T.L.: A novel experimental analysis of the rheology of ZDDP tribofilms, Tribology and Interface Engineering Series, pp. 807–817. Elsevier, Amsterdam (2003) So, H., Lin, Y.C.: The theory of antiwear for ZDDP at elevated temperature in boundary lubrication condition. Wear 177, 105–115 (1994) Cutiongco, E.C., Chung, Y.-W.: Prediction of scuffing failure based on competitive kinetics of oxide formation and removal: application to lubricated sliding of AISI 52100 steel on steel. Tribology Transactions 37, 622–628 (1994) Oila, A., Bull, S.J.: Assessment of the factors influencing micropitting in rolling/sliding contacts. Wear 258, 1510–1524 (2005) Boucly, V.: Semi-analytical modeling of the transient-elastic-plastic contact and its application to asperity collision, wear and running in of surfaces, PhD Thesis, Lyon, 2008 p 203 Evans, R.D.: Transmission Electron Microscopy of Boundary-Lubricated Bearing Surfaces. Part: II Mineral Oil Lubricant with Sulfur and Phosphorus-Containing Gear Oil Additives. Tribology Trasnsactions 48, 299–307 (2005) Willner, K.: Fully Coupled Frictional Contact Using Elastic Halfspace Theory. J Tribol 130, 031405–031408 (2008) Nicholls, M.A., Norton, P.R., Bancroft, G.M., Kasrai, M., Do, T., Frazer, B.H., Stasio, G.D.: Nanometer scale chemomechanical characterization of antiwear films. Tribol Lett 17, 205–336 (2003) Kasrai, M., Fuller, M.S., Bancroft, G.M., Yamaguchi, E.S., Ryason, P.R.: X-ray adsorption study of the effect of calcium sulfonate on antiwear film formation generated from neutral and basic ZDDPs: part 1—phosphorus species. Tribology Transactions 46, 434–442 (2003) Nicholls, M.A., Do, T., Norton, P.R., Kasrai, M., Bancroft, G.M.: Review of the lubrication of metallic surfaces by zinc dialkyl-dithiophosphates. Tribol Int 38, 15–39 (2005) Aktary, M., McDermott, M.T., McAlpine, G.A.: Morphology and nanomechanical properties of ZDDP antiwear films as a function of tribological contact time. Tribol Lett 12, 155–162 (2002) Nicholls, M.A., Bancroft, G.M., Norton, P.R., Kasrai, M., De Stasio, G., Frazer, B.H., Wiese, L.M.: Chemomechanical properties of antiwear films using X-ray absorption microscopy and nanoindentation techniques. Tribol Lett 17, 245–259 (2004) Ye, J.P., Kano, M., Yasuda, Y.: Evaluation of nanoscale friction depth distribution in ZDDP and MoDTC tribochemical reacted films using a nanoscratch method. Tribol Lett 16, 107–112 (2004) Ji, H.B., Nicholls, M.A., Norton, P.R., Kasrai, M., Capehart, T.W., Perry, T.A., Cheng, Y.T.: Zinc-dialkyl-dithiophosphate antiwear films: dependence on contact pressure and sliding speed. Wear 258, 789–799 (2005) Bec, S., Tonck, A., Georges, J.M., Coy, R.C., Bell, J.C., Roper, G.W.: Relationship between mechanical properties and structures of zinc dithiophosphate anti-wear films. In: Proceedings of the Royal Society of London Series A—Mathematical Physical and Engineering Sciences, vol 455, pp. 4181–4203, 1999 Komvopoulos, K., Do, V., Yamaguchi, E.S., Ryason, P.R.: Nanomechanical and nanotribological properties of an antiwear tribofilm produced from phosphorus-containing additives on boundary-lubricated steel surfaces. J Tribol Trans ASME 126, 775–780 (2004) Warren, O.L.: Nanomechanical properties of films derived from zinc dialkyldithiophosphate. Tribol Lett 4, 189–198 (1998) Minfray, C., Martin, J.M., Esnouf, C., Le Mogne, T., Kersting, R., Hagenhoff, B.: A multi-technique approach of tribofilm characterisation. Thin Solid Films 447, 272–277 (2004) Pereira, G., Munoz-Paniagua, D., Lachenwitzer, A., Kasrai, M., Norton, P.R., Capehart, T.W., Perry, T.A., Cheng, Y.-T.: A variable temperature mechanical analysis of ZDDP-derived antiwear films formed on 52100 steel. Wear 262, 461–470 (2007) Bancroft, G.M., Kasrai, M., Fuller, M., Yin, Z., Fyfe, K., Tan, K.H.: Mechanisms of tribochemical film formation: stabilityof tribo- and thermally-generated ZDDP films. Tribol Lett 3, 47–51 (1997) Topolovec-Miklozic, K., Forbus, T., Spikes, H.: Film thickness and roughness of ZDDP antiwear films. Tribol Lett 26, 161–171 (2007)