Modelling and simulation of explosions in soil interacting with deformable structures
Tóm tắt
A detonating explosive interacting with a deformable structure is a highly transient and non-linear event. In field blast trials of military vehicles, a standard procedure is often followed in order to reduce the uncertainties and increase the quality of the test. If the explosive is buried in the ground, the state of the soil must meet specific demands. In the present work, laboratory experiments have been performed to characterize the behaviour of a soil material. Soil may be considered a three-phase medium, consisting of solid grains, water and air. Variations between the amounts of these phases affect the mechanical properties of the soil. The experimental outcome has formed input data to represent the soil behaviour included in a three-phase elastic-plastic cap model. This unified constitutive model for soil has been used for numerical simulations representing field blast trials, where the explosive load is interacting with a deformable structure. The blast trials included explosive buried at different depths in wet or dry sand. A dependence of the soil initial conditions can be shown, both in the past field trials along with the numerical simulations. Even though some deviations exist, the simulations showed in general acceptable agreement with the experimental results.
Tài liệu tham khảo
Lekarp F., Richardson I.R., Dawson A., Influences on permanent deformation behavior of unbound granular materials, Transportation research record. 1997, 68–75
Wang Z., Hao H., Lu Y., A three-phase soil model for simulating stress wave propagation due to blast loading, Int. J. Numer. Anal. Meth. Geomech., 2004, 28, 33–56
AEP-55 Procedures for evaluating the protection level of logistic and light armoured vehicles, 1st ed., NATO, 2006
Fišerová D., Numerical analyses of buried mine explosions with emphasis on effect of soil properties on loading, PhD Thesis, Cranfield University, 2006
Hawkins A.B., Aspects of rock strength, Bulletin of Engineering Geology and the Environment, 1998, 57, 17–30
Laine L., Sandvik A., Derivation of mechanical properties for sand, In: 4th Asia-Pacific Conference on Shock and Impact Loads on Structures, Singapore, CI-Premier PTE LTD, 2001, 361–368
Grujicic M., Pandurangan B., Qiao R., Cheeseman B.A., et al., Parameterization of the porous-material model for sand with different levels of water saturation, Soil Dynamics and Earthquake Engineering, 2008, 28, 20–35
Wu W., Thomson R., A study of the interaction between a guardrail post and soil during quasi-static and dynamic loading, Int. J. Impact Eng., 2007, 34, 883–898
Gabet T., Malécot Y., Daudeville L., Triaxial behaviour of concrete under high stresses: Influence of the loading path on compaction and limit states, Cement Concr. Res., 2008, 38, 403–412
Chapman D.J., Tsembelis K., Proud W.G., The behaviour of water saturated sand under shock-loading, In: Proceedings of the Conference of the American Physical Society Topical Group on Shock Compression of Condensed Matter, Baltimore, Maryland, 2005, 834–840
Bragov A.M., Lomunov A.K., Sergeichev I.V., Tsembelis K., et al., Determination of physicomechanical properties of soft soils from medium to high strain rates, Int. J. Impact Eng., 2008, 35, 967–976
Grujicic M., Pandurangan B., Coutris N., Cheeseman B.A., et al., Computer-simulations based development of a high strain-rate, large-deformation, high-pressure material model for STANAG 4569 sandy gravel, Soil Dynamics and Earthquake Engineering, 2008, 28, 1045–1062
Zakrisson B., Wikman B., Johansson B., Half scale experiments with rig for measuring structural deformation and impulse transfer from land mines, In: Bless S., Walker J.D., (Ed.), Proceedings of the 24th International Symposium on Ballistics, (September 22–26, New Orleans USA), DEStech Publications Inc, 2008, 497–504
Zakrisson B., Wikman B., Häggblad H.-Å., Numerical simulations of blast loads and structural deformation from near-field explosions in air, Int. J. Impact Eng., 2011, 38, 597–612
Hallquist J.O., LS-DYNA Keyword user’s manual, Version 971/Rev 5 (Beta), Livermore Software Technology Corporation, 2010
Fung Y.C., Tong P., Classical and computational solid mechanics, Advanced series in engineering sience Vol. 1, World Scientific, New York, USA, 2001
Häggblad H.-Å., Constitutive models for powder materials, Powder Technology, 1991, 67, 127–137
Jonsén P., Häggblad H.-Å., Modelling and numerical investigation of the residual stress state in a green metal powder body, Powder Technology, 2005, 155, 196–208
An J., Soil behaviour under blast loading, PhD thesis, University of Nebraska, Lincoln, USA, 2010
Cole R.H., Underwater explosions, Princeton University Press, New Jersey, USA, 1948
Lee E.L., Hornig H.C., Kury J.W., Adiabatic expansion of high explosive detonation products, UCRL-50422, Lawrence Radiation Laboratory, 1968
Helte A., Lundgren J., Örnhed H., Norrefeldt M., Evaluation of performance of m/46, FOI-R-2051-SE, Swedish Defence Research Agency, 2006, (in Swedish)
Sonntag R.E., Borgnakke C., Van Wylen G.J., Fundamentals of thermodynamics, 6th ed., Wiley cop., New York, USA, 2003
Børvik T., Hopperstad O.S., Berstad T., Langseth M., A computational model of viscoplasticity and ductile damage for impact and penetration, Eur. J. Mech. A: Solids, 2001, 20, 685–712
Børvik T., Dey S., Clausen A.H., Perforation resistance of five different high-strength steel plates subjected to small-arms projectiles, Int. J. Impact Eng., 2009, 36, 948–964
Geoscience parameter data base handbook: granites and basalts, UCRL-15152, Owens (Willard) Associates Inc., Wheat Ridge, CO, USA, 1979
Hondros G., The evaluation of Poisson’s ratio and the modulus of materials of a low tensile resistance by the Brazilian (indirect tensile) test with particular reference to concrete, Aust. J. Appl. Sci., 1959, 10, 243–268
Jonsén P., Häggblad H.-Å., Sommer K., Tensile strength and fracture energy of pressed metal powder by diametral compression test, Powder Tech., 2007, 176, 148–155
Chafi M.S., Karami G., Ziejewski M., Numerical analysis of blast-induced wave propagation using FSI and ALE multi-material formulations, Int. J. Impact Eng., 2009, 36 1269–1275