Growth of short fatigue cracks in HY130 steel in 3.5% NaCl solution
Tài liệu tham khảo
El Haddad, 1979, Fatigue crack propagation of short cracks, Trans. ASME, J. Engng Mater. Tech., 101, 42, 10.1115/1.3443647
Nakai, 1980, Grain size effect on growth threshold for small surface-cracks and long through-cracks under cyclic loading, 106
Taylor, 1981, Fatigue crack propagation behavior of short cracks; the effect of microstructure, Fatigue Engng Mater. Structure, 4, 147, 10.1111/j.1460-2695.1981.tb01116.x
Tanaka, 1981, Fatigue growth threshold of small cracks, Int. J. Fracture, 17, 519, 10.1007/BF00033345
Lankford, 1983, The growth of small fatigue cracks in 7075-T6 aluminum, Fatigue Engng Mater. Structure, 5, 233, 10.1111/j.1460-2695.1982.tb01251.x
Gangloff, 1981, The criticality of crack size an aqueous corrosion fatigue, Res. Mechanica Lett., 1, 299
Vosilovsky, 1978, Frequency, stress ratio and potential effects on fatigue crack growth of HY130 steel in salt water, J. Test. Evaluation, JTEVA, 6, 175, 10.1520/JTE10939J
Barsom, 1970, Corrosion-fatigue crack propagation below KIscc in four high-yield-strength steels
Ryder, 1974, Temperature influence on corrosion fatigue behavior on 5 NiCrMoV Steel, J. Test. Evaluation, 2, 180, 10.1520/JTE10096J
Clark, 1974, The effect of hydrogen gas on the fatigue crack growth rate behavior of HY80 and HY130 steels, 149
Ateya, 1975, On the nature of electrochemical reactions at a crack tip during hydrogen charging of a metal, J. Electrochem. Soc., 122, 1018, 10.1149/1.2134388
Doig, 1978, Limitations of potentiostatic control in stress corrosion crack growth measurements, Met. Trans., 9A, 357, 10.1007/BF02646385
Turnbull, 1982, A model of crack electrochemistry for steels in the active state based on mass transport by diffusion and ion migration, J. Electrochem. Soc., 129, 1412, 10.1149/1.2124176
Pickering, 1972, On the mechanism of localized corrosion of iron and stainless steel, Int. Electrochem. Studies, J. Electrochem. Soc., 119, 1297, 10.1149/1.2403982
Taunt, 1978, Fluid compositions within fatigue cracks, Mater. Sci. Engng, 35, 219, 10.1016/0025-5416(78)90124-6
Gilbey, 1966, Measurement of the length of a center or edge crack in a sheet of metal by an electric resistance method, RAE Tech. Rep. No. 66402
Li, 1966, Calibrating the electrical potential method for studying slow crack growth, Mater. Res. Standards, 6, 392