Active oxygen sensors used a quartz crystal microbalance (QCM) with sputter-coated and spin-coated poly(tetrafluoroethylene) thin films

Yamada, 1993, X-ray photoelectron spectroscopy of fluorocarbon films deposited by RF sputtering, Japanese Journal of Applied Physics, 32, 5090, 10.1143/JJAP.32.5090 Biederman, 2000, RF sputtering of polymers and its potential application, Vacuum, 59, 594, 10.1016/S0042-207X(00)00321-3 Iwamori, 2007, Poly(tetrafluoroethylene) thin films deposited by a vacuum evaporation and RF sputtering, vol. 3, 21 Iwamori, 2008, Molecular structures and tribological properties of sputtered poly(fluorocarbon) thin films, Journal of the Society of Materials Science (Japan), 57, 611, 10.2472/jsms.57.611 Simon, 1998, Chemical recycling of polytetrafluoroethylene by pyrolysis, Polymer Degradation and Stability, 62, 1, 10.1016/S0141-3910(97)00097-9 Sauerbrey, 1959, Verwendung von Schwingquarzen zur Wägung dünner Schichten und zur Mikrowägung, Zeitschrift für Physik, 155, 206, 10.1007/BF01337937 Syritski, 1999, Environmental QCM sensors coated with polypyrrole, Synthetic Metals, 102, 1326, 10.1016/S0379-6779(98)01047-9 Hirayama, 2002, Preparation of a sensor device with specific recognition sites for acetaldehyde by molecular imprinting technique, Sensors and Actuators B, 86, 20, 10.1016/S0925-4005(02)00107-7 Noda, 2005, Simple analytical methods for the detection of trichloroethylene by applying oxidizing agents to the quartz crystal microbalance sensor, IEEJ Transactions on Sensors and Micromachines, 125, 50, 10.1541/ieejsmas.125.50 Su, 2008, Low-humidity sensor based on a quartz-crystal microbalance coated with polypyrrole/Ag/TiO2 nanoparticles composite thin films, Sensors and Actuators B, 129, 915, 10.1016/j.snb.2007.10.006 Ying, 2008, Polymer coated sensor array based on quartz crystal microbalance for chemical agent analysis, European Polymer Journal, 44, 1157, 10.1016/j.eurpolymj.2008.01.015 Iwamori, 2010, Adsorption properties of fluorocarbon thin films prepared by physical vapor deposition methods, Surface and Coatings Technology, 204, 2803, 10.1016/j.surfcoat.2010.02.041 Iwamori, 2010, Adsorption properties of thin films prepared by r.f. sputtering with a BPDA-PDA polyimide target, Japanese Journal of Applied Physics, 49, 04DK18, 10.1143/JJAP.49.04DK18 Ono, 2005, Behaviour of atomic oxygen in a pulsed dielectric barrier discharge measured by laser-induced fluorescence, Journal of Physics D: Applied Physics, 38, 2812, 10.1088/0022-3727/38/16/011 Takashima, 1999, Vacuum ultraviolet absorption spectroscopy employing a microdischarge hollow-cathode lamp for absolute density measurements of hydrogen atoms in reactive plasmas, Applied Physics Letters, 75, 3929, 10.1063/1.125497 Nagai, 2003, Measurement of oxygen atom density employing vacuum ultraviolet absorption spectroscopy with microdischarge hollow cathode lamp, Review of Scientific Instruments, 74, 3453, 10.1063/1.1582386 Matsumoto, 2009, Development of an active oxygen detector using a quartz crystal microbalance with a carbon/silver layer, Chemistry Letters, 38, 216, 10.1246/cl.2009.216 Matsumoto, 2009, Investigation of silver oxidation behavior under active oxygen processing utilizing the quartz crystal microbalance method, Chemistry Letters, 38, 1146, 10.1246/cl.2009.1146 Noda, 2003, Sensitivity improvement in the detection of trichloroethylene by applying oxidizing agents to the quartz crystal microbalance method, Chemistry Letters, 32, 1128, 10.1246/cl.2003.1128 Iwamori, 2008, Adhesion and friction properties of fluorocarbon polymer thin films coated onto metal substrates, Key Engineering Materials, 384, 311, 10.4028/www.scientific.net/KEM.384.311 Iwamori, 2009, Friction and adhesion properties of fluorocarbon polymer thin films prepared by magnetron sputtering, Vacuum, 84, 592, 10.1016/j.vacuum.2009.04.044 Nishiyama, 2005, Study on depth profiling mechanical property by surface and interfacial cutting method, Bulletin of the Japanese Society of Printing Science and Technology, 42, 285 Wei, 2005, Evaluation of plasma deposited fluorocarbon films using experimental design methodology, Surface and Coatings Technology, 200, 2214, 10.1016/j.surfcoat.2005.04.028 Daikhin, 1997, Influence of surface roughness on the quartz crystal microbalance response in a solution – new configuration for QCM studies, Faraday Discussions, 107, 27, 10.1039/a703124f Okabe, 1987