Tuning Interface to Improve Corrosion Resistance of Electroless Ni-P Coating on AZ31B Alloy

Metals - Tập 8 Số 5 - Trang 328
Beilei Ma1, Ruihong Wang1
1School of Materials Science and Engineering, Xi’an University of Technology, Xi’an, 710048, China

Tóm tắt

Interface is crucial to enable desirable service performances of coatings on substrates. In this paper, Ni-P coatings were prepared on AZ31B alloy by using electroless plating, with the coating/substrate interface being tuned to improve the corrosion resistance. The interface tuning involved a phosphate treatment prior to the electroless plating, which created a uniform surface of the Mg substrate and finally led to Ni-P plating coatings with enhanced density during the electroless plating. Electrochemical testing was performed to compare the corrosion properties between the Ni-P coatings with and without phosphate treatment. The experimental results evidently showed that the introduction of phosphate treatment, especially after an annealing treatment, greatly improved the corrosion resistance. The underlying mechanisms, revealed by microstructural examinations, were that the phosphate treatment reduced the substrate surface roughness and likely promoted a high and uniform nucleation intensity of the Ni-P coating. Corrosion processes of the unannealed and annealed Ni-P coatings with an interfacial phosphate layer were further clarified for comparison.

Từ khóa


Tài liệu tham khảo

Gu, 2005, Electroless Ni-P plating on AZ91D magnesium alloy from a sulfate solution, J. Alloys Compd., 391, 104, 10.1016/j.jallcom.2004.07.083

Liu, 2006, Electroless nickel plating on AZ91 Mg alloy substrate, Surf. Coat. Technol., 200, 5087, 10.1016/j.surfcoat.2005.05.023

Guo, 2005, Growth of ceramic coatings on AZ91D magnesium alloys by micro-arc oxidation in aluminate-fluoride solutions and evaluation of corrosion resistance, Appl. Surf. Sci., 246, 229, 10.1016/j.apsusc.2004.11.031

Hornberger, 2012, Biomedical coatings on magnesium alloys—A review, Acta Biomater., 8, 2442, 10.1016/j.actbio.2012.04.012

Hu, 2012, Recent progress in corrosion protection of magnesium alloys by organic coatings, Prog. Org. Coat., 73, 129, 10.1016/j.porgcoat.2011.10.011

Ranganatha, 2010, Development of electroless Ni-Zn-P/nano-TiO2 composite coatings and their properties, Appl. Surf. Sci., 256, 7377, 10.1016/j.apsusc.2010.05.076

Bakkar, 2008, Electroless Ni-P coating of different magnesium alloys, Surf. Coat. Technol., 202, 5151, 10.1016/j.surfcoat.2008.05.037

Seifzadeh, 2013, Environmentally-friendly method for electroless Ni-P plating on magnesium alloy, Surf. Coat. Technol., 218, 119, 10.1016/j.surfcoat.2012.12.039

Yuan, 2017, Preparation and corrosion resistance of Ni-P bilayer on magnesium alloy, Mater. Corros., 68, 1377, 10.1002/maco.201709515

Winiarski, 2015, Corrosion resistance of Ni-P\CePO4 coatings obtained from sol solutions, Mater. Corros., 66, 557, 10.1002/maco.201307570

Guo, 2017, Characteristics and corrosion behavior of nickel-phosphorus coatings deposited by a simplified bath, Mater. Corros., 68, 468, 10.1002/maco.201609155

Vitry, 2010, Initiation and formation of electroless nickel-boron coatings on mild steel: Effect of substrate roughness, Mater. Sci. Eng. B, 175, 266, 10.1016/j.mseb.2010.08.003

Yan, 2015, An innovative procedure of electroless nickel plating in fluoride-free bath used for AZ91D magnesium alloy, J. Alloys Compd., 653, 271, 10.1016/j.jallcom.2015.08.210

Gou, 2010, Influence of pH values on electroless Ni-P-SiC plating on AZ91D magnesium alloy, Trans. Nonferrous Met. Soc. China, 20, s674, 10.1016/S1003-6326(10)60560-2

Zuleta, 2017, Study of the formation of alkaline electroless Ni-P coating on magnesium and AZ31B magnesium alloy, Surf. Coat. Technol., 321, 309, 10.1016/j.surfcoat.2017.04.059

Zhao, 2008, Influence of pH and chloride ion concentration on the corrosion of Mg alloy ZE41, Corros. Sci., 50, 3168, 10.1016/j.corsci.2008.08.023

Li, 2007, Preparation and property evaluation of electroless Ni-P coatings on AZ91D magnesium alloy, Trans. Nonferrous Met. Soc. China, 17, s835

Dhinakaran, 2013, Effect of nanoadditives with surfactant on the surface characteristics of electroless nickel coating on magnesium-based composites reinforced with MWCNT, Adv. Tribol., 2013, 1, 10.1155/2013/315965

Sahoo, 2008, Optimization of electroless Ni-P coatings based on multiple roughness characteristics, Surf. Interface Anal., 40, 1552, 10.1002/sia.2945

Vitry, 2012, Experimental study on the formation and growth of electroless nickel-boron coatings from borohydride-reduced bath on mild steel, Appl. Surf. Sci., 263, 640, 10.1016/j.apsusc.2012.09.126

Xavior, 2014, Influence of process parameters on multiple roughness characteristics of Ni-P-TiO2 composite coatings, Procedia Eng., 97, 439, 10.1016/j.proeng.2014.12.268

Krolikowski, 1993, Anodic behavior of Ni P alloys studied by impedance spectroscopy, Electrochim. Acta, 38, 1979, 10.1016/0013-4686(93)80327-V

Crobu, 2008, The corrosion resistance of electroless deposited nano-crystalline Ni-P alloys, Electrochim. Acta, 53, 3364, 10.1016/j.electacta.2007.11.071

Meenan, 1994, Characterisation of a PdCl2/SnCl2 electroless plating catalyst system adsorbed on barium titanate-based electroactive ceramics, Appl. Surf. Sci., 74, 221, 10.1016/0169-4332(94)90003-5

Stallard, 2006, The study of the adhesion of a TiN coating on steel and titanium alloy substrates using a multi-mode scratch tester, Tribol. Int., 39, 159, 10.1016/j.triboint.2005.04.011

Ranjbar, 2010, Electroless plating of palladium on WO3 films for gasochromic applications, Sol. Energy Mater. Sol. Cells, 94, 201, 10.1016/j.solmat.2009.09.002

Zhao, 2007, A new method for electroless Ni-P plating on AZ31 magnesium alloy, Surf. Coat. Technol., 202, 133, 10.1016/j.surfcoat.2007.05.001

Liu, 2006, The effect of substrate on the electroless nickel plating of Mg and Mg alloys, Surf. Coat. Technol., 200, 3553, 10.1016/j.surfcoat.2004.12.001

Lendvai, 2001, Nanocrystallization Studies of an Electroless Plated Ni-P Amorphous, Alloy. J. Electrochem. Soc., 148, C715, 10.1149/1.1405518

Totlani, 2000, Electroless Nickel for Corrosion Control in Chemical, Oil and Gas Industries, Corros. Rev., 18, 155, 10.1515/CORRREV.2000.18.2-3.155

Elsener, 2004, From Chemical to Structural Order of Electrodeposited Ni22P Alloy: An XPS EDXD Study, Chem. Mater., 16, 4216, 10.1021/cm030606x

Chipatecua, 2012, Corrosion behaviour of CrN/Cr multilayers on stainless steel deposited by unbalanced magnetron sputtering, Vacuum, 86, 1393, 10.1016/j.vacuum.2012.01.016

Song, 2008, High corrosion resistance of electroless composite plating coatings on AZ91D magnesium alloys, Electrochim. Acta, 53, 2135, 10.1016/j.electacta.2007.09.026

Chen, 2008, Deposition of electroless Ni-P/Ni-W-P duplex coatings on AZ91D magnesium alloy, Trans. Nonferrous Met. Soc. China, 18, s323, 10.1016/S1003-6326(10)60225-7

Thông tin
Thông tin xuất bản

Metals

Tập 8 Số 5

328

Thông tin tác giả