Thermal crystallization kinetic and electrical properties of partly crystallized amorphous indium oxide thin films sputtering deposited in the presence or the absence of water vapor

Journal of Thermal Analysis - Tập 111 - Trang 1457-1461 - 2012
Meihan Wang1, Hao Lei2, Yoshiyuki Seki3, Shigeyuki Seki4, Yutaka Sawada3, Yoichi Hoshi3, Shaohong Wang1, Lixian Sun5
1Scientific Research Center, Shenyang University, Shenyang, China
2Department of Surface Engineering of Materials, Institute of Metal Research, CAS, Shenyang, China
3Center for Hyper Media Research, Tokyo Polytechnic University, Atsugi, Japan
4Department of Electronic Engineering, Sendai National College of Technology, Sendai, Japan
5Materials and Thermochemistry Laboratory, Dalian Institute of Chemical Physics, Chinese Academy of Sciences, Dalian, China

Tóm tắt

Partly crystallized amorphous indium oxide thin films were deposited under water vapor atmosphere by magnetron sputtering. XRD analysis revealed that appropriate water vapor could suppress the film’s crystallinity. In situ thermal crystallization process was monitored by high-temperature XRD. The crystallization data were analyzed using the Kolmogorov–Johnson–Mehl–Avrami equation. The kinetic exponent n is determined to be approx. 1/2 and 3/2 for film deposited in the absence and the presence of water vapor, respectively. The activation energy of crystallization for film deposited under 1 × 10−5 Torr water vapor pressure was determined to be 30.7 kJ mol−1, which is higher than 18.9 kJ mol−1 for film deposited in the absence of water vapor. The increased activation energy caused by the chemically bonded hydrogen and embedded O–H bonds from the water vapor resulted in the suppression of crystallization. Introduction of appropriate water vapor during the deposition decreased the resistivity because of the increase of Hall mobility. The resistivity of the films after annealing increased due to the evaporation of water vapor resulted in crystal defects.

Tài liệu tham khảo

Hosono H. Recent progress in transparent oxide semiconductors: materials and device application. Thin Solid Films. 2007;515:6000–14. Uchida T, Kasahara Y, Otomo T, Seki S, Wang MH, Sawada Y. Transparent conductive electrode deposited by Cs-incorporated RF magnetron sputtering and evaluation of the damage in OLED organic layer. Thin Solid Films. 2008;516:5907–10. Seki Y, Sawada Y, Wang MH, Lei H, Hoshi Y, Uchida T. Electrical properties of tin-doped indium oxide thin films prepared by a dip coating. Ceram Int. 2012;38S:S613–6. Kondo T, Funakubo H, Akiyama K, Enta H, Seki Y, Wang MH, Uchida T, Sawada Y. Deposition of undoped indium oxide thin films on stripe-patterned substrates by spray CVD. J Cryst Growth. 2009;311:642–6. Ow-Yang CW, Spinner D, Shigesato Y, Paine DC. A time-resolved reflectivity study of the amorphous-to-crystalline transformation kinetics in dc-magnetron sputtered indium tin oxide. J Appl Phys. 1998;83:145–54. Ishibashi S, Higuchi Y, Ota Y, Nakamura K. Low resistivity indium–tin oxide transparent conductive films. Effect of introduction H2O gas or H2 gas during direct current magnetron sputtering. J Vac Sci Technol A. 1990;8:1399–402. Nishimura E, Ando M, Onisawa K, Takabatake M, Minemuba T. Structural change during annealing of amorphous indium-tin oxide films deposited by sputtering with H2O addition. Jpn J Appl Phys. 1996;35:2788–92. Nishimura E, Ohkawa H, Song PK, Shigesato Y. Microstructures of ITO films deposited by d.c. magnetron sputtering with H2O introduction. Thin Solid Films. 2003;445:235–40. Ando M, Nishimura E, Onisawa K, Minemura T. Effect of microstructures on nanocrystallite nucleation and growth in hydrogenated amorphous indium–tin–oxide films. J Appl Phys. 2003;93:1032–8. Wang MH, Onai Y, Hoshi Y, Lei H, Kondo T, Uchida T, Singkarat S, Kamwanna T, Dangtip S, Aukkaravittayapun S, Nishide T, Tokiwa S, Sawada Y. Thermal change of amorphous indium tin oxide films sputter-deposited in water vapor atmosphere. Thin Solid Films. 2008;516:5809–13. Wang MH, Sawada Y, Lei H, Seki Y, Hoshi Y, Uchida T, Konya T, Kishi A. Thermal crystallization kinetics and crystallite size distribution of amorphous ITO film deposited in the presence or absence of water vapor. Thin Solid Films. 2010;518:2992–5. Wang MH, Tokiwa S, Nishide T, Kasahara Y, Seki S, Uchida T, Ohtsuka M, Kondo T, Sawada Y. Thermally induced changes in amorphous indium-tin-oxide thin films: gas evolution and crystallization. J Therm Anal Cal. 2008;91:249–54. Kim D, Han Y, Cho JS, Koh SK. Low temperature deposition of ITO thin films by ion beam sputtering. Thin Solid Films. 2000;377–378:81–6. Vyazovkin S, Burnham AK, Criado JM, Perez-Maqueda LA, Popescu C, Sbirrazzuoli N. ICTAC kinetic committee recommendations for performing kinetic computations on thermal analysis data. Thermochim Acta. 2011;520:1–19. Christian JW. The theory of transformations in metals and alloys. Formal theory of transformation kinetics. Pergamon: Oxford; 2002. p. 529–52. Kato K, Omoto H, Tomioka T, Takamatsu A. Changes in electrical and structural properties of indium oxide thin films through post-deposition annealing. Thin Solid Films. 2011;520:110–5.