The time and strain required for development of minimum strain rates in ice

Cold Regions Science and Technology - Tập 8 - Trang 261-268 - 1984
T.H. Jacka1
1Antarctic Division, Department of Science and Technology, Kingston, Tasmania 7150 Australia

Tài liệu tham khảo

Baker, 1982, A flow equation for anisotropic ice, Cold Reg. Sci. Technol., 6, 141, 10.1016/0165-232X(82)90006-4 Budd, 1969, The Dynamics of Ice Masses, ANARE Scientific Reports Budd, 1972, The development of crystal orientation fabrics in moving ice, Z. Gletscherk. Glazialgeol., Bd. VIII, 65 Budd, 1974, Short report: On preferred orientation of polycrystalline ice by biaxial creep test, Low Temp. Sci., 32, 261 Hooke, 1980, Mechanical properties of polycrystalline ice: an assessment of current knowledge and priorities for research, Cold Reg. Sci. Techn., 3, 263, 10.1016/0165-232X(80)90033-6 Jacka, 1983, Sample preparation techniques and compression apparatus for ice flow studies, Cold Reg. Sci. Technol. Lile, 1978, The effect of anisotropy on the creep of polycrystalline ice, J. Glaciol., 21, 475, 10.1017/S0022143000033621 Lile, 1978 Mellor, 1980, Mechanical properties of polycrystalline ice, 217 Mellor, 1982, Deformation and failure of ice under constant stress or constant strain-rate, Cold Reg. Sci. Technol., 5, 201, 10.1016/0165-232X(82)90015-5 Morgan, 1979, A system for accurate temperature control of small fluid baths, J. Glaciol., 22, 389, 10.1017/S0022143000014362 Pickering, 1976 Russell-Head, 1979, Ice-sheet flow properties derived from bore-hole shear measurements combined with ice-core studies, J. Glaciol., 24, 117, 10.1017/S0022143000014684 Steinemann, 1954, Flow and crystallization of ice, IASH Pub. No. 39, 449