The sensing mechanism of N-doped SWCNTs toward SF6 decomposition products: A first-principle study

Tang, 2012, Partial discharge recognition through an analysis of SF6 decomposition products part 1: Decomposition characteristics of SF6 under four different partial discharges, IEEE Trans. Dielectr. Electr. Insul., 19, 29, 10.1109/TDEI.2012.6148499 P. Bolin, H. Koch, Introduction and applications of gas insulated substation (GIS), in: Power Engineering Society General Meeting, 2005, IEEE, IEEE, 2005, pp. 920–926. Tang, 2013, Correlation analysis between formation process of SF6 decomposed components and partial discharge qualities, IEEE Trans. Dielectr. Electr. Insul., 20, 864, 10.1109/TDEI.2013.6518956 Liu, 2009, Investigation on SF6 decomposition products in GIS and affecting factors, Power Syst. Technol., 33, 58 Qiu, 2009, Study on SF6 gas impurities and potential faults diagnosis, Southern Power Syst. Technol. Chu, 1986, SF6 decomposition in gas-insulated equipment, IEEE Trans. Electr. Insul., EI-1, 693, 10.1109/TEI.1986.348921 Okabe, 2008, Detecting characteristics of SF6 decomposed gas sensor for insulation diagnosis on gas insulated switchgears, IEEE Trans. Dielectr. Electr. Insul., 15, 251, 10.1109/T-DEI.2008.4446758 Hoshino, 2001, A novel technique for detecting electromagnetic wave caused by partial discharge in GIS, Power Eng. Rev. IEEE, 21, 70, 10.1109/MPER.2001.4311486 E. Haque, A.B. Darus, M.M. Yaacob, F. Ahmed, Application of acoustic sensing and signal processing for PD detection in GIS, in: International Conference on Information, Communications and Signal Processing, vol. 742, 1997, pp. 745–749. Ling, 2009, Partial discharge detection system based on very wide bandwidth pulse current method, Adv. Technol. Electr. Eng. Energy, 28, 54 Judd, 2005, Partial discharge monitoring of power transformers using UHF sensors Part I: sensors and signal interpretation, IEEE Electr. Insul. Mag., 21, 5 Xie, 2013, Location of partial discharge in transformer oil using circular array of ultrasonic sensors, IEEE Trans. Dielectr. Electr. Insul., 20, 1683, 10.1109/TDEI.2013.6633698 Zhang, 2014, A simulation of Pd-doped SWCNTs used to detect SF6 decomposition components under partial discharge, Appl. Surf. Sci., 315, 196, 10.1016/j.apsusc.2014.07.056 Zhang, 2016, Analysis of adsorption properties of typical partial discharge gases on Ni-SWCNTs using density functional theory, Appl. Surf. Sci., 379, 47, 10.1016/j.apsusc.2016.04.048 Zhang, 2016, Preparation and application of TiO2 nanotube array gas sensor for SF6-insulated equipment detection: a review, Nanoscale Res. Lett., 11, 302, 10.1186/s11671-016-1516-4 Ding, 2006, Calibration methods of carbon nanotube gas sensor for partial discharge detection in SF6, IEEE Trans. Dielectr. Electr. Insul., 13, 353, 10.1109/TDEI.2006.1624280 Minagawa, 2003, Development of SF6 decomposition gas sensor, Surf. Coat. Technol., 169, 643, 10.1016/S0257-8972(03)00095-1 X. Zhang, F. Meng, Z. Wang, J. Li, Gas-sensing simulation of single-walled carbon nanotubes applied to detect gas decomposition products of SF6 in PD, in: Electrical Insulation Conference, 2011, pp. 132–135. Wang, 2007, A novel aluminum-doped carbon nanotubes sensor for carbon monoxide, J. Mol. Struct. Theochem, 806, 93, 10.1016/j.theochem.2006.11.012 Bai, 2007, Computational study of B- or N-doped single-walled carbon nanotubes as NH3 and NO2 sensors, Carbon, 45, 2105, 10.1016/j.carbon.2007.05.019 Zhou, 2010, Adsorption sensitivity of Pd-doped SWCNTs to small gas molecules, Sens. Actuators, B, 151, 56, 10.1016/j.snb.2010.09.054 Zhou, 2006, Doping effects of B and N on hydrogen adsorption in single-walled carbon nanotubes through density functional calculations, Carbon, 44, 939, 10.1016/j.carbon.2005.10.016 Asad, 2016, Highly sensitive wireless H2S gas sensors at room temperature based on CuO-SWCNT hybrid nanomaterials, Sens. Actuators, B, 231, 474, 10.1016/j.snb.2016.03.021 Wang, 2004, Multi-walled carbon nanotube-based gas sensors for NH3 detection, Diam. Relat. Mater., 13, 1327, 10.1016/j.diamond.2003.11.070 Dong, 2013, Detection of a CO and NH gas mixture using carboxylic acid-functionalized single-walled carbon nanotubes, Nanoscale Res. Lett., 8, 12-12, 10.1186/1556-276X-8-12 Battie, 2011, Selective differential ammonia gas sensor based on N-doped SWCNT films, Physica Status Solidi, 248, 2462, 10.1002/pssb.201100067 Majeed, 2013, Synthesis and electrochemical applications of nitrogen-doped carbon nanomaterials, Nanotechnol. Rev., 2, 615, 10.1515/ntrev-2013-0007 Ayala, 2010, The doping of carbon nanotubes with nitrogen and their potential applications, Carbon, 48, 575, 10.1016/j.carbon.2009.10.009 An, 2015, Adsorption of O2, H2, CO, NH3, and NO2 on ZnO Nanotube: a density functional theory study, J. Phys. Chem. C, 112, 5747, 10.1021/jp711105d Orita, 2004, A comparison of CO adsorption on Pt(211), Ni(211), and Pd(211) surfaces using density functional theory, Surf. Sci., 571, 161, 10.1016/j.susc.2004.08.019 Perdew, 1997, Generalized gradient approximation made simple [Phys. Rev. Lett. 77, 3865 (1996)], Phys. Rev. Lett., 77, 3865, 10.1103/PhysRevLett.77.3865 Perdew, 1996, Generalized gradient approximation made simple, Phys. Rev. Lett., 77, 3865, 10.1103/PhysRevLett.77.3865 Zhao, 2005, Carbon nanotube-metal cluster composites: a new road to chemical sensors?, Nano Lett., 5, 847, 10.1021/nl050167w Kumar, 2017, Oxygen and nitrogen doping in single wall carbon nanotubes: an efficient stable field emitter, J. Alloys Compd., 711, 85, 10.1016/j.jallcom.2017.03.324 Zhang, 2015, Adsorption of gases from SF6 decomposition on aluminum-doped SWCNTs: a density functional theory study, Eur. Phys. J. D, 69, 1, 10.1140/epjd/e2015-60172-x Ni, 2012, Oxygen molecule dissociation on carbon nanostructures with different types of nitrogen doping, Nanoscale, 4, 1184, 10.1039/C1NR11086A