The Experiment Analysis of Bonding Performance between Near Surface Mounted CFRP Strip and Concrete at Different Curing Temperatures
Tóm tắt
To investigate the bonding performance of near-surface mounted (NSM) carbon fiber-reinforced polymer (CFRP) technique under different curing temperatures, a total of five test specimens strengthened with NSM CFRP strip were tested by direct pull-out methods. The strain of CFRP strip, interfacial bonding shear stress, ultimate load and failure mode were analyzed through the test. The experiment results showed that the ultimate load and bonding shear stress of the specimens increased gradually when curing temperature was lower than the glass transition temperature (Tg) of the bond material. Afterward, they gradually decreased with the increase in temperature. The bonding shear stress was gradually transmitted from the loading end to the free end. The failure modes were changed from CFRP strip–adhesive interface bonding failure to CFRP strips fracture failure with the temperature rising. In this paper, the bonding performance experiment results of NSM CFRP strip could provide a reference for the rapid strengthening of monorail traffic track beams.
Tài liệu tham khảo
Rizkalla SH, Elhacha R (2004) Near-surface-mounted fiber-reinforced polymer reinforcements for flexural strengthening of concrete structures. ACI Struct J 101(5):717–726
Cruz JMS, Barros JAO (2004) Bond between near surface mounted carbon-fiber-reinforced polymer laminate strips and concrete. J Compos Constr 8(6):519–527
Hassan T, Rizkalla S (2003) Investigation of bond in concrete structures strengthened with near surface mounted carbon fiber reinforced polymer strips. J Compos Constr 7(3):248–356
Hassan T, Rizkalla S (2004) Bond mechanism of NSM FRP bars for flexural strengthening of concrete structures. ACI Struct J 101(6):830–841
Al-Mahmoud F, Castel A, Fran R, François R et al (2011) Anchorage and tension stiffening effect between near surface mounted CFRP rods and concrete. Cement Concr Compos 33(2):346–352
Seracino R, Nicola M (2007) Bond strength of near-surface mounted FRP strip-to-concrete joints. J Compos Constr 11(4):401–409
Sharaky IA, Torres L, Baena M et al (2013) An experimental study of different factors affecting the bond of NSM FRP bars in concrete. Compos Struct 99(5):350–365
Hu K, Dong K, Yang Y (2016) Temperature effect on bond behavior of carbon fiber reinforced polymer to concrete interface. J Tongji Univ (Nat Sci Ed) 06:845–852
Hu K, Lu F, Cai Z (2009) Researches on mechanical property of CFRP-concrete interface at elevated temperature. J Tongji Univ (Nat Sci Ed) 12:1592–1597
Lee H, Jung WT, Chung W (2017) Bond behavior of near surface mounted CFRP rods under temperature cycling. Eng Struct 137:67–75
Mohammed A, Al-Saadi NTK, Al-Mahaidi R (2016) Bond behaviour between NSM CFRP strips and concrete at high temperature using innovative high-strength self-compacting cementitious adhesive (IHSSC-CA) made with graphene oxide. Constr Build Mater 127:872–883
Yu B, Kodur V (2014) Effect of temperature on strength and stiffness properties of near-surface mounted FRP reinforcement. Compos B Eng 8(3):510–517
Capozucca R, Blasi MG, Corina V (2015) NSM technique: bond of CFRP rods and static/dynamic response of strengthened RC beams. Compos Struct 127:466–479