Synthesis of Polymer Brushes Using Atom Transfer Radical Polymerization

Macromolecular Rapid Communications - Tập 24 Số 18 - Trang 1043-1059 - 2003
Jeffrey Pyun1,2, Tomasz Kowalewski1, Krzysztof Matyjaszewski1
1Center for Macromolecular Engineering, Department of Chemistry, Carnegie Mellon University, 4400 Fifth Avenue, Pittsburgh, PA 15213, USA
2University of California, Department of Chemistry, Berkeley, CA 94720‐1460, USA

Tóm tắt

Abstract

Atom transfer radical polymerization (ATRP) is a robust method for the preparation of well‐defined (co)polymers. This process has also enabled the preparation of a wide range of polymer brushes where (co)polymers are covalently attached to either curved or flat surfaces. In this review, the general methodology for the synthesis of polymer brushes from flat surfaces, polymers and colloids is summarized focusing on reports using ATRP. Additionally, the morphology of ultrathin films from polymer brushes is discussed using atomic force microscopy (AFM) and other techniques to confirm the formation of nanoscale structure and organization.

Formation of polymer brushes by ATRP.

magnified image

Formation of polymer brushes by ATRP.

Từ khóa


Tài liệu tham khảo

10.1021/ar960248m

10.1002/(SICI)1521-4095(199808)10:12<901::AID-ADMA901>3.0.CO;2-B

10.1021/cm011065j

10.1007/BFb0051635

10.1021/jp960244z

10.1016/S0079-6700(00)00012-5

10.1021/la971035o

10.1021/ma970661p

10.1021/ma970660x

10.1021/ma980240n

10.1021/ja00125a035

10.1126/science.272.5263.866

10.1021/ar9501434

10.1002/(SICI)1521-3765(19991105)5:11<3095::AID-CHEM3095>3.0.CO;2-#

10.1016/S0079-6700(01)00003-X

10.1021/cr940534g

10.1021/cr9901182

10.1021/ma981290v

10.1021/ma991146p

10.1021/ja992465z

10.1021/ja028866n

Boyes S. G., 2002, Polym. Prepr. (Am. Chem. Soc. Div. Polym. Chem.), 43, 549

10.1021/ma001152h

 

Pyun J., 2003, Macromol. Chem. Phys.

Pyun J., 2002, ACS Polym. Prepr., 43, 328

10.1016/S0032-3861(03)00322-7

10.1021/ma981402i

10.1021/ma010001r

10.1021/ma0013962

10.1021/ma012100a

10.1021/ma021633w

10.1140/epje/e2003-00009-x

10.1016/S0079-6700(01)00038-7

Tsubokawa N., 1998, Recent Res. Dev. Polym. Sci., 2, 211

10.1021/ja991108l

10.1021/ja010235q

10.1021/ja010241m

10.1002/polb.10329

10.1002/pola.10085

10.1021/cm010291q

10.1007/s007060170141

10.1002/1521-3773(20011105)40:21<4016::AID-ANIE4016>3.0.CO;2-J

10.1021/cm000514x

10.1002/1521-3927(20000601)21:10<669::AID-MARC669>3.0.CO;2-6

10.1002/1521-4095(20020903)14:17<1239::AID-ADMA1239>3.0.CO;2-P

10.1021/ma0121464

10.1021/ma011651y

10.1002/pola.10160

10.1021/ma010746x

10.1021/cr990129v

10.1021/ja001652q

10.1002/1521-3773(20010417)40:8<1510::AID-ANIE1510>3.0.CO;2-U

10.1021/ma011159e

10.1021/ma011736z

10.1002/pola.10568

10.1021/la026787j

10.1039/b204737c

10.1002/1521-3927(20020401)23:7<417::AID-MARC417>3.0.CO;2-3

10.1016/S0032-3861(01)00192-6

10.1021/ja016582h

10.1021/ja962159a

10.1002/(SICI)1099-0518(19980115)36:1<1::AID-POLA3>3.0.CO;2-Z

10.1021/ja984456g

10.1021/ma001508p

10.1016/S0079-6700(00)00011-3

10.1021/ma021472w

Qin S., 2002, Polym. Prepr. (Am. Chem. Soc. Div. Polym. Chem.), 43, 237

10.1016/S0032-3861(01)00591-2

10.1002/macp.200390090

10.1021/cr990119u

10.1002/pola.10210

10.1002/0471220450.ch12

10.1016/S0079-6700(02)00023-0

10.1002/pola.10567

10.1021/ja991450y

10.1021/ma991264c

10.1021/la011630x

10.1021/ma970535l

10.1021/cr990124y

10.1021/ma012203t

10.1021/ma980725b

10.1021/ma011313x

10.1140/epje/i2001-10098-2

10.1021/ma991988o

10.1021/la027055u

10.1021/ma010371f

10.1021/la011365f

10.1021/ma991733a

10.1021/ma000225u

10.1021/ma0255128

10.1021/ma981033q

10.1002/(SICI)1099-0518(20000601)38:11<2023::AID-POLA110>3.0.CO;2-L

10.1021/ja984428y

10.1021/ma000433m

10.1021/ma000434e

10.1021/ma991549p

10.1021/ma991077e

10.1002/1521-3900(200102)164:1<187::AID-MASY187>3.0.CO;2-E

10.1021/ma0116001

10.1021/ac980231c

10.1007/s002160000682

10.1021/ma000797e

10.1021/ma001435

10.1021/ma981304x

10.1016/S0079-6700(01)00033-8

10.1016/S0079-6700(01)00051-X

10.1016/S0079-6700(02)00010-2

10.1021/ja993941o

10.1021/la020496t

10.1007/s002890050596

10.1295/polymj.33.902

10.1016/S0079-6700(01)00049-1

Chen X., 2002, Polym. Prepr. (Am. Chem. Soc. Div. Polym. Chem.), 43, 265

10.1021/ma0209491

10.1021/ma020809r

10.1021/cm021216y

10.1021/ja0274709

10.1021/cm021778h

10.1021/ma034188t

10.1002/ijch.199500005

10.1002/(SICI)1521-3935(19980701)199:7<1435::AID-MACP1435>3.0.CO;2-#

10.1063/1.1415497

10.1002/app.1532

10.1002/pat.148

10.1021/la034219d

10.1002/(SICI)1099-0518(20000615)38:12<2274::AID-POLA170>3.0.CO;2-I

10.1021/ma0214299

10.1002/pi.1339

10.1002/(SICI)1099-0739(199810/11)12:10/11<667::AID-AOC775>3.0.CO;2-1

10.1021/ma9904823

10.1021/ma991076m

10.1007/3-540-45806-9_1

10.1021/ja0261168

10.1021/ma0113733

10.1021/ma0345347

10.1016/j.polymer.2003.08.028

10.1016/S0079-6700(01)00018-1

Nlu Q. J., 2002, Polym. Mater. Sci. Eng., 87, 433

10.1002/1521-3765(20020802)8:15<3308::AID-CHEM3308>3.0.CO;2-D

10.1002/1521-4095(20021118)14:22<1637::AID-ADMA1637>3.0.CO;2-C