Suppression control method for torque vibration of three-phase HB-type stepping motor utilizing feedforward control
Tóm tắt
This paper proposes a method to reduce the vibration of the three-phase HB-type stepping motor with cogging torque by the feedforward compensation control. The compensation signal to suppress the vibration of the motor frame is obtained by the repetitive controller installing an online Fourier transformer and utilizing an acceleration sensor attached to the motor frame or an acoustic sensor such as a microphone placed close to the frame. The sensor is used only for the acquisition of the feedforward compensation data. The feedforward compensation signal at an arbitrary operating point is derived from the amplitude and phase data of the frequency components and the operating point data. Compensation data obtained by the repetitive controller is applied to the operating point changed by reference frequency and load condition in steady state. The compensation signal for the new operating point will be generated from compensation data utilizing polynomial equation approximation and linear interpolation method. The effectiveness of this proposed method is confirmed by the experimental results.
Từ khóa
#Torque control #Vibration control #Acoustic sensors #Micromotors #Frequency #Forging #Acceleration #Microphones #Steady-state #Signal generatorsTài liệu tham khảo
10.1109/41.491355
10.1109/28.90345
nakano, 1989, Repetitive Control
10.1109/ICIT.1994.467074
10.1109/63.484420
su, 2000, repetitive control for vibration reduction of 3-phase hb-type stepping motor utilizing acceleration sensor-learning of feedforward compensation signal, Trans Inst Elect Eng Jpn, 120 c, 53
10.1109/PEDS.1999.792811
10.1541/ieejias.119.670
10.1109/AMC.2000.862907
10.1541/ieejias.116.578