Đặc tính sức bền và trạng thái biến dạng của các mối hàn không hoàn toàn tại tâm mối hàn dưới tải trọng hai trục với tính không đồng nhất cơ học bất đối xứng

I. I. Makarov and T. I. Emel’yanova, “Influence of technological defects on the durability and reliability of welded joints,” in: Reliability of Welded Joints and Structures [in Russian], Mashinostroenie, Moscow (1967), pp. 47–63. G. A. Nikolaev and S. V. Rumyantsev, “Influence of welding defects on the mechanical properties of welded joints,” in: Problems of Strength of Metals and Structures [in Russian], Izd. AN SSSR, Moscow (1959), pp. 82–91. G. V. Zhemchuzhnikov, É. V. Kotenko, and V. S. Girenko, “Influence of incomplete fusion on the static strength of butt joints at low temperatures,” Avtomat. Svarka, No. 2, 29–33 (1968). G. A. Nikolaev, S. A. Kurkin, V. A. Vinokurov, et al., “Investigation of the strength of welded structures,” Izv. Vuzov, Mashinostroenie, No. 9, 144–153 (1968). V. L. Dil’man and A. A. Ostsemin, “Strength of mechanically inhomogeneous welded joints with a slitlike defects,” Svar. Proizvod., No. 2, 12–15 (1999). L. M. Kachanov, Foundations of the Theory of Plasticity [in Russian], Nauka, Moscow (1969). O. A. Bakshi and V. Z. Shron, “Strength of welded joints with soft interlayers under static tension,” Svar. Proizvod., No. 5, 6–10 (1962). A. L. Nemchinskii, “On the influence of defects on the strength of welds,” Svarka, No. 1, 95–102 (1958). O. A. Bakshi, I. V. Shakhmatov, and V. V. Erofeev, “Stress-strain state of welded joints with defects at the center of soft butt welds,” Avtomat. Svarka, No. 3, 9–11 (1982). S. Hao, A. Cornec, and K. H. Schwabbe, “Plastic stress-strain fields and limit loads of a plane strain cracked tensile panel with a mismatched welded joint,” Int. J. Solids Struct., 34, No. 3, 297–326 (1997). R. S. Zainullin, “Load-carrying capacity of welded vessels with sharp surface defects,” Svar. Proizvod., No. 3, 5–7 (1981). A. A. Ostsemin, “Stress state and the static strength of mechanically inhomogeneous welded joints. Report 2. Effect of a small degree of mechanical inhomogeneity on the strength of butt welded joints,” Strength Mater., 23, No. 4, 406–410 (1991). A. A. Ostsemin, “Effect of compactness for a cross section of mechanically inhomogeneous welded joints on their stress-strained state and strength,” Strength Mater., 24, No. 1, 84–89 (1992). L. Prandtl, “Examples of application of the Hencky theorem to the equilibrium of plastic bodies,” in: Yu. N. Rabotnov (Ed.), Theory of Plasticity [Russian translation], Izd. Inostr. Lit., Moscow (1948), pp. 102–113. A. A. Ostsemin, “Evaluation of the yield strength of welded joints,” Svar. Proizvod., No. 6, 42–43 (1987). V. L. Dil’man and A. A. Ostsemin, “Analysis of the ductile strength of welds weakened by notches in longitudinally welded pipes of large diameter by the method of slip lines,” Strength Mater., 36, No. 3, 274–281 (2004). O. A. Bakshi, “On the stressed state of soft interlayers in welded joints in tension (compression),” in: Problems of Welding Fabrication [in Russian], Issue 33 (1965), pp. 5–26. A. A. Ostsemin and V. A. Lupin, “Torsion of a conical rod made of a strain-hardening material,” Strength Mater., 17, No. 6, 801–805 (1985). A. A. Ostrovskii, “On the direction of local yield layers in the complex stressed state,” Prikl. Mekh., Issue 2, 112–115 (1974). M. V. Shakhmatov, V. V. Erofeev, and A. A. Ostsemin, “Effect of strain hardening on the direction of local yielding layers in the prefracture zone,” Strength Mater., 17, No. 3, 352–354 (1985). N. N. Davidenkov and D. M. Vasil’ev, “On the coefficient of transverse strain,” Zavod. Lab., No. 5, 596–599 (1952). O. A. Bakshi ands A. S. Bogomolova, “Strength of mechanically inhomogeneous welded joints in biaxial tension,” Svar. Proizvod., No. 5, 3–6 (1971). A. A. Ostsemin, “Strength and stressed state of the soft interlayer in a thin-walled cylindrical vessel under biaxial loading,” Avtomat. Svarka, No. 5–6, 18–20 (1994). L. I. Gladshtein and A. B. Zlochevskii, “Strength of mechanically inhomogeneous welded joints of high-strength steel in uniaxial and biaxial tension,” Svar. Proizvod., No. 9, 8–12 (1969). A. A. Ostsemin, “Influence of surface defects on the strength of welded joints with asymmetric mechanical inhomogeneity,” Avtomat. Svarka, No. 5, 31–35 (2007). M. V. Shakhmatov, “Load-carrying capacity of welded joints with defects in hard and soft welds,” Avtomat. Svarka, No. 6, 14–18 (1988). A. S. Volkov, “Causes of the formation of defects near repaired sections of the welds,” Svar. Proizvod., No. 8, 33–35 (1974). A. A. Ostsemin and V. L. Dil’man, “Influence of welding defects located on the fusion boundary on the strength of welded joints,” Vestnik Mashinostr., No. 2, 21–26 (2006). A. A. Ostsemin, “Analysis of the load-carrying capacity of the operating oil main in the presence of defects in longitudinal welds,” Svar. Proizvod., No. 9, 11–15 (1988).