Giải quyết vấn đề mòn ăn mòn do xói mòn của thiết bị và đường ống trong các nhà máy điện hạt nhân: Kinh nghiệm trong nước và quốc tế

Thermal Engineering - Tập 54 - Trang 348-355 - 2007
V. I. Baranenko1, Yu. A. Yanchenko1
1All-Russia Research Institute of Nuclear Power Engineering, Moscow, Russia

Tóm tắt

Vấn đề mòn ăn mòn do xói mòn (ECW) gặp phải trong các thiết bị và đường ống của hệ thống cấp nước, ngưng tụ, và hơi trong các nhà máy điện hạt nhân được xem xét. Các phương pháp giải quyết vấn đề ECW và việc chuẩn bị các tài liệu quy định cho việc tính toán và dự đoán tỷ lệ ECW ở Nga và quốc tế được phân tích.

Từ khóa

#mòn ăn mòn #xói mòn #hệ thống điện hạt nhân #tài liệu quy định

Tài liệu tham khảo

“Failure at the Surry-2 Nuclear Power Plant,” Atomnaya Tekhnika za Rubezhom, No. 10, 43 (1987). “Pipe Break Causes Deaths at Surry,” Nucl. Eng. Intern., 32, 4 (1987). V. K. Chexal, et al. “Keeping Erosion/Corrosion in CHEC,” Nucl. Eng. Intern., No. 5 (May), 20 (1989). V. K. Chexal and J. S. Horowitz, “Chexal-Horowitz Flow-Accelerated Corrosion Model: Parameters and Influences,” in Current Perspectives of International Pressure Vessels and Piping Codes and Standards, (American Society of Mechanical Engineers, New York, 1995), Book No. 409768, pp. 231–243. V. K. Chexal and J. S. Horowitz, “Chexal-Horowitz Flow-Accelerated Corrosion Model: Parameters and Influences,” in Current Perspectives of International Pressure Vessels and Piping Codes and Standards (American Society of Mechanical Engineers, New York, 1995), Book No. 409768, pp. 231–243. “Problems of Increasing the Competitiveness of Nuclear Power Plants in the United States,” Mirovaya Electroenergetika, No. 2, 37–42 (1997). “Case N-480,” in Examination Requirements for Pipe Wall Thinning Due Single Phase Erosion and Corrosion (American Society of Mechanical Engineers, 1990), Section X1, pp. 787–795. “WATHEC and DASY Combat Erosion/Corrosion” (Bertich Energieerzeugung (KWU), Erlangen, 1994). M. Bouchacourt, “Predicting Flow-Accelerated Erosion/Corrosion Damage in Power Plants with BRTCICERO Code,” in Proceedings of Specialists Meeting Organized by the International Atomic Energy Agency, Kiev, Ukraine, 1994, pp. 314–334. H. Nopper, W. Daeuwel, and W. Kastner, “COMSY Software Assists PLIM&PLEX Activities,” Proceedings of Specialists Meeting Organized by the International Atomic Energy Agency, Charlotte, NC, USA, June 19–22, 2002, p. 9. J. P. Goffin, “Thickness Measurements of Pipes Submitted to Erosion and Corrosion Problems in Steam, Feedwater, and Condensate Systems of the Doel-1 and Doel-2 Nuclear Power Plants,” in Proceedings of Specialists Meeting Organized by the International Atomic Energy Agency, Vienna, Austria, September 12–14, 1988 (IAEA, Vienna, 1990), pp. 43–48. D. Martens, “Follow-Up of Flow-Accelerated Corrosion in the Belgian Nuclear Power Plants,” in Proceedings of Specialists Meeting Organized by the International Atomic Energy Agency, Vladimir, Russia, September 13–16, 1999, p. 13. V. I. Baranenko, M. B. Bakirov, S. G. Oleinik, and Yu. A. Yanchenko, “Software for Evaluating Erosion/Corrosion Wear of Pipelines on Nuclear Power Plants,” Teploenergetika, No. 11, 231–224 (2003). V. I. Baranenko, V. A. Gashenko, M. B. Bakirov, et al., “Effect of Chemical Impurities in Silicon-Manganese-Doped Carbon Steels on the Working Life of Nuclear Power Plant Pipelines with Respect to Erosion/Corrosion Wear,” Teploenergetika, No. 12, 37–40 (2001). K. N. Yandushkin, K. V. Drizen, B. M. Obraztsov, and I. L. Alekseenko, Corrosion and Protection of On-Board Ship Pipelines (Sudostroenie, Leningrad, 1978) [in Russian].