Simulation–based optimization of operating parameters for methanol synthesis process: Application of response surface methodology for statistical analysis

Journal of Natural Gas Science and Engineering - Tập 34 - Trang 439-448 - 2016
S. Hoseiny1, Z. Zare1, A. Mirvakili1, P. Setoodeh1, M.R. Rahimpour1
1Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, Shiraz 71345, Iran

Tài liệu tham khảo

Duana, 2014, Regeneration of spent catalyst from vinyl acetate synthesis as porous carbon: process optimization using RSM, Chem. Eng. Res. Des., 92, 1249, 10.1016/j.cherd.2013.11.001 Fujitani, 2000, The chemical modification seen in the Cu/ZnO methanol synthesis catalysts, Appl. Catal. A General, 191, 111, 10.1016/S0926-860X(99)00313-0 Ghodke, 2007, Use of response surface methodology to investigate the effects of milling conditions on damaged starch, dough stickiness and chapatti quality, Food Chem., 112, 1010, 10.1016/j.foodchem.2008.05.036 Laan, 1999, Multicomponent reaction engineering model for Fe-catalyzed Fischere Tropsch synthesis in commercial scale slurry bubble column reactors, Chem. Eng. Sci., 54, 5013, 10.1016/S0009-2509(99)00225-0 Li, 2000, Influence of slurry concentrations on bubble population and their rise velocities in a three-phase slurry bubble column, Powder Technol., 113, 158, 10.1016/S0032-5910(00)00228-X Lim, 2009, Modeling of the kinetics for methanol synthesis using Cu/ZnO/Al2O3/ZrO2 catalyst: influence of carbon dioxide during hydrogenation, Ind. Eng. Chem. Res., 48, 10448, 10.1021/ie901081f Liu, 2003, Recent advances in catalysts for methanol synthesis via hydrogenation of CO and CO2, Ind. Eng. Chem. Res., 42, 6518, 10.1021/ie020979s Muhammad, 2014, Correlating the additional amine sweetening cost to acid gases load in natural gas using Aspen Hysys, Nat. Gas Sci. Eng., 92, 1249 Rahimpour, 2012, A novel slurry bubble column membrane reactor concept for Fischere Tropsch synthesis in GTL technology, Chem. Eng. Res. Des., 90, 383, 10.1016/j.cherd.2011.07.014 Rezaie, 2005, A comparison of homogeneous and heterogeneous dynamic models for industrial methanol reactors in the presence of catalyst deactivation, Chem. Eng. Process. Process Intensif., 44, 911, 10.1016/j.cep.2004.10.004 Setinc, 2001, Dynamics of a mixed slurry reactor for the three-phase methanol synthesis, Chem. Eng. Sci., 56, 6081, 10.1016/S0009-2509(01)00212-3 Singh, 2008, Bioleaching of wheat straw-rich soda pulp with alkalophilic laccase from c-proteobacterium JB: optimization of process parameters using response surface methodology, Bioresour. Technol., 99, 7472, 10.1016/j.biortech.2008.02.023 Sun, 1998, In situ IR studies on the mechanism of methanol synthesis over an ultrafine Cu/ZnO/Al2O3 catalyst, Appl. Catal., 171, 301, 10.1016/S0926-860X(98)00096-9 Toyir, 2001, Highly effective conversion of CO2 to methanol over supported and promoted copper-based catalysts: influence of support and promoter, Appl. Catal. B Environ., 29, 201, 10.1016/S0926-3373(00)00205-8 Yang, 2008, A new method of low-temperature methanol synthesis on Cu/ZnO/Al2O3 catalysts from CO/CO2/H2, Fuel, 87, 443, 10.1016/j.fuel.2007.06.020 Zhai, 2008, Study on the deactivation phenomena of Cu-based catalyst for methanol synthesis in slurry phase, Fuel, 87, 430, 10.1016/j.fuel.2007.07.008