Simple methods to estimate the influence of limestone fillers on reaction and property evolution in cementitious materials
Tóm tắt
Từ khóa
Tài liệu tham khảo
Mehta, 2009, Global concrete industry sustainability, Concr Int, 31, 45
Bentz, 2010, Powder additions to mitigate retardation in high volume fly ash mixtures, ACI Mater J, 107, 508
Cost VT. Concrete sustainability versus constructability – closing the gap. In: presentation at international concrete sustainability conference. Boston; 2011.
Kenai, 2004, Some engineering properties of limestone concrete, Mater Manufact Proc, 19, 949, 10.1081/AMP-200030668
Voglis, 2005, Portland-limestone cements: their properties and hydration compared to those of other composite cements, Cem Concr Compos, 27, 191, 10.1016/j.cemconcomp.2004.02.006
Pera, 1999, Influence of finely ground limestone on cement hydration, Cem Concr Compos, 21, 99, 10.1016/S0958-9465(98)00020-1
Kadri, 2009, Combined effect of chemical nature and fineness of mineral powders on portland cement hydration, Mater Struct, 43
Kumar, 2013, A comparison of intergrinding and blending limestone on reaction and strength evolution in cementitious materials, Constr Build Mater, 43, 428, 10.1016/j.conbuildmat.2013.02.032
Bentz, 2012, Fine limestone additions to regulate setting in high volume fly ash mixtures, Cem Concr Compos, 34, 11, 10.1016/j.cemconcomp.2011.09.004
Gurney, 2012, Using limestone to reduce set retardation in high volume fly ash mixtures: improving constructability for sustainability, Transport Res Rec, 2290, 139, 10.3141/2290-18
ASTM Annual Book of ASTM Standards. Concrete and Aggregates. West Conshohocken; 2009.
Kumar, 2012, Modeling early age hydration kinetics of alite, Cem Concr Res, 42, 903, 10.1016/j.cemconres.2012.03.003
Oey, 2013, The filler effect: the influence of filler content and surface area on cementitious reaction rates, J Am Ceram Soc, 21, 1
Torquato, 2002
Bentz, 1997, Three-dimensional computer simulation of portland cement hydration and microstructure development, J Am Ceram Soc, 80, 3, 10.1111/j.1151-2916.1997.tb02785.x
Bentz, 2008, The hidden meaning of water-to-cement ratio, Concr Int, 30, 51
Bentz, 1994, Hydraulic radius and transport in reconstructed model 3D porous media, Transport Porous Med, 17, 221, 10.1007/BF00613583
Sant, 2008, Rheological properties of cement pastes: a discussion of structure formation and mechanical property development, Cem Concr Res, 38, 1286, 10.1016/j.cemconres.2008.06.008
Bentz, 2008, Early-age properties of cement-based materials: I. influence of cement fineness, ASCE J Mater Civil Eng, 20, 502, 10.1061/(ASCE)0899-1561(2008)20:7(502)
Sant, 2009, Detecting the fluid-to-solid transition in cement pastes, Concr Int, 43
Scherer, 2012, Hydration and percolation at the setting point, Cem Concr Res, 42, 665, 10.1016/j.cemconres.2012.02.003
Zheng, 2012, Prediction of the degree of hydration at initial setting time of cement paste with particle agglomeration, Cem Concr Res, 42, 1280, 10.1016/j.cemconres.2012.05.020
Vance, 2013, Hydration and strength development in ternary portland cement blends containing limestone and fly ash or metakaolin, Cem Concr Compos, 21, 12
Haecker, 2005, Modeling the linear elastic properties of portland cement paste, Cem Concr Res, 35, 1948, 10.1016/j.cemconres.2005.05.001
Velez, 2001, Determination by nanoindentation of elastic modulus and hardness of pure constituents of Portland cement clinker, Cem Concr Res, 31, 555, 10.1016/S0008-8846(00)00505-6
Chen, 2010, A coupled nanoindentation /SEM-EDS study on low water/cement ratio portland cement paste: evidence for C–S–H/Ca(OH)2 Nanocomposites, J Am Ceram Soc, 93, 1484, 10.1111/j.1551-2916.2009.03599.x
Sandberg, 2005, Cement-admixture interactions related to aluminate control, J ASTM Int, 2, 1, 10.1520/JAI12296
Bentz, 2009, Early-age properties of cement-based materials: II. influence of water-to-cement ratio, ASCE J Mater Civil Eng, 21, 512, 10.1061/(ASCE)0899-1561(2009)21:9(512)
Bentz, 2009, Limestone fillers to conserve cement in low w/cm concretes: an analysis based on powers’ model, Concr Int, 31, 41
Jensen, 2001, Water-entrained cement based materials I: principles and theoretical background’, Cem Concr Res, 31, 647, 10.1016/S0008-8846(01)00463-X
Mindess, 2003
Bentz, 2012, Comparison of ASTM C311 strength activity index testing vs. testing based on constant volumetric proportions, J ASTM Int, 9, 7, 10.1520/JAI104138
Bentz, 2012, Relating compressive strength to heat release in mortars, Adv Civil Eng Mater, 1, 14
Bentz, 2010, Blending different fineness cements to engineer the properties of cement-based materials, Mag Concr Res, 62, 327, 10.1680/macr.2008.62.5.327
Bentz DP. Verification, validation, and variability of virtual standards. In: 12th international congress on the chemistry of cement. Montreal; 2007.
Zelic, 2004, A mathematical model for prediction of compressive strength in cement-silica fume blends, Cem Concr Res, 34, 2319, 10.1016/j.cemconres.2004.04.015
Ioan M, Radu L, Mandoiu C. Software-enhanced method for rapid determination of the early heat of hydration of cement CEM II/A and B-S to predict the 28-day compressive strength. In: Proc of the 1st international proficiency testing conference. Sinaia, Romania; 2007, p. 355–362.
Hobbs, 1974, Influence of aggregate restraint on the shrinkage of concrete, ACI J, 445
Garboczi, 1997, Analytical formulas for interfacial transition zone properties, Adv Cem Based Mater, 6, 99, 10.1016/S1065-7355(97)90016-X
Barde, 2005