Significantly improved strength and ductility in bimodal-size grained microstructural magnesium matrix composites reinforced by bimodal sized SiCp over traditional magnesium matrix composites

Zhao, 2008, Formation of bimodal-sized structure and its tensile properties in a warm-rolled and annealed ultrafine-grained ferrite/cementite steel, Metall. Mater. Trans. A, 39, 1691, 10.1007/s11661-008-9531-4 Hassan, 2005, Development of high performance magnesium nano-composites using nano-Al2O3 as reinforcement, Mater. Sci. Eng. A, 392, 163, 10.1016/j.msea.2004.09.047 Koch, 2003, Optimization of strength and ductility in nanocrystalline and ultrafine grained metals, Scr. Mater., 49, 657, 10.1016/S1359-6462(03)00394-4 Gil Sevillano, 2004, Utilization of nanocrystalline materials for structural applications, Scr. Mater., 51, 795, 10.1016/j.scriptamat.2004.05.015 Zhao, 2006, Grain growth and Hall–Petch relation in dual-sized ferrite/cementite steel with nano-sized cementite particles in a heterogeneous and dense distribution, Scr. Mater., 54, 1193, 10.1016/j.scriptamat.2005.11.032 Tellkamp, 2001, Mechanical behavior and microstructure of a thermally stable bulk nanostructured Al alloy, Metall. Mater. Trans. A, 32, 2335, 10.1007/s11661-001-0207-6 Wang, 2002, Extraordinarily high tensile ductility in a nanostructured metal, Nature, 419, 912, 10.1038/nature01133 Li, 2008, Effect of thermal annealing on mechanical properties of a nanostructured copper prepared by means of dynamic plastic deformation, Scr. Mater., 59, 475, 10.1016/j.scriptamat.2008.04.043 Dirras, 2010, Microstructure and mechanical characteristics of bulk polycrystalline Ni consolidated from blends of powders with different particle size, Mater. Sci. Eng. A, 527, 1206, 10.1016/j.msea.2009.09.050 Shekhar, 2009, Multimodal ultrafine grain size distributions from severe plastic deformation at high strain rates, Mater. Sci. Eng. A, 527, 187, 10.1016/j.msea.2009.07.058 Guo, 2014, Numerical investigation of fracture behavior of nanostructured Cu with bimodal grain size distribution, Acta Mech., 225, 1093, 10.1007/s00707-013-1050-8 Zhu, 2012, A statistical model for predicting the mechanical properties of nanostructured metals with bimodal grain size distribution, Acta Mater., 60, 5762, 10.1016/j.actamat.2012.06.059 Guo, 2014, Micromechanical simulation of fracture behavior of bimodal nanostructured metals, Mater. Sci. Eng. A, 618, 479, 10.1016/j.msea.2014.09.036 Zhu, 2012, Modelling the plastic deformation of nanostructured metals with bimodal grain size distribution, Int. J. Plast., 30–31, 166, 10.1016/j.ijplas.2011.10.003 Deng, 2012, Microstructure and elevated tensile properties of submicron SiCp/AZ91 magnesium matrix composite, Mater. Des., 38, 110, 10.1016/j.matdes.2012.02.017 Nie, 2011, Effect of multidirectional forging on microstructures and tensile properties of a particulate reinforced magnesium matrix composite, Mater. Sci. Eng. A, 528, 7133, 10.1016/j.msea.2011.06.016 Wang, 2011, Influences of extrusion parameters on microstructure and mechanical properties of particulate reinforced magnesium matrix composites, Mater. Sci. Eng. A, 528, 6387, 10.1016/j.msea.2011.04.064 Shen, 2014, Effect of submicron size SiC particles on microstructure and mechanical properties of AZ31B magnesium matrix composites, Mater. Des., 54, 436, 10.1016/j.matdes.2013.08.078 Yoo, 1997, The effect of SiC whiskers on the hot deformation behavior of SiCw/AA2124 composites, Compos. Sci. Technol., 57, 651, 10.1016/S0266-3538(97)00010-9 Cavaliere, 2006, Isothermal forging of metal matrix composites: recrystallization behaviour by means of deformation efficiency, Compos. Sci. Technol., 66, 357, 10.1016/j.compscitech.2005.04.047 Wang, 2012, Dynamic recrystallization behavior of particle reinforced Mg matrix composites fabricated by stir casting, Mater. Sci. Eng. A, 545, 38, 10.1016/j.msea.2012.02.077 Nie, 2011, Microstructure and tensile properties of micro-SiC particles reinforced magnesium matrix composites produced by semisolid stirring assisted ultrasonic vibration, Mater. Sci. Eng. A, 528, 8709, 10.1016/j.msea.2011.08.035 Zhang, 2007, Compressive behaviour of Al-based hybrid composites reinforced with SiC whiskers and SiC nanoparticles, Mater. Chem. Phys., 101, 242, 10.1016/j.matchemphys.2006.04.004 Deng, 2013, Dynamic recrystallization behavior during hot deformation and mechanical properties of 0.2 μm SiCp reinforced Mg matrix composite, Mater. Sci. Eng. A, 560, 824, 10.1016/j.msea.2012.10.044 Nie, 2010, Multidirectional forging of magnesium matrix composites: effect on microstructures and tensile properties, Mater. Sci. Eng. A, 527, 7364, 10.1016/j.msea.2010.08.007 Shen, 2013, Effect of bimodal size SiC particulates on microstructure and mechanical properties of AZ31B magnesium matrix composites, Mater. Des., 52, 1011, 10.1016/j.matdes.2013.05.067 Nie, 2012, Effect of hot extrusion on microstructures and mechanical properties of SiC nanoparticles reinforced magnesium matrix composite, J. Alloys Compd., 512, 355, 10.1016/j.jallcom.2011.09.099 Paramsothy, 2010, Mechanical property retention in remelted microparticle to nanoparticle AZ31/Al2O3 composites, J. Alloys Compd., 506, 600, 10.1016/j.jallcom.2010.07.123 Paramsothy, 2011, The synergistic ability of Al2O3 nanoparticles to enhance mechanical response of hybrid alloy AZ31/AZ91, J. Alloys Compd., 509, 7572, 10.1016/j.jallcom.2011.04.120 Nguyen, 2009, Microstructure and mechanical characteristics of AZ31B/Al2O3 nano-composite with addition of Ca, J. Compos. Mater., 43, 5, 10.1177/0021998308096333 Alam, 2013, Microstructure, thermal and mechanical response of AZ51/Al2O3 nanocomposite with 2 wt.% Ca addition, Mater. Des., 50, 1, 10.1016/j.matdes.2013.01.057 Paramsothy, 2009, Enhancing tensile/compressive response of magnesium alloy AZ31 by integrating with Al2O3 nanoparticles, Mater. Sci. Eng. A, 527, 162, 10.1016/j.msea.2009.07.054 Deng, 2010, Effect of submicron size SiC particulates on microstructure and mechanical properties of AZ91 magnesium matrix composites, J. Alloys Compd., 504, 542, 10.1016/j.jallcom.2010.05.159 Zhao, 2007, Relationship between yield strength and grain size for a bimodal structural ultrafine-grained ferrite/cementite steels, Scr. Mater., 57, 857, 10.1016/j.scriptamat.2007.06.062 Hassan, 2005, Development of high performance magnesium nano-composites using nano-Al2O3 as reinforcement, Mater. Sci. Eng. A, 392, 163, 10.1016/j.msea.2004.09.047 Zhao, 2008, Strengthening and improvement of ductility without loss of corrosion performation in a magnesim alloy by homogenizing annealing, Scr. Mater., 58, 560, 10.1016/j.scriptamat.2007.11.023 Sankaranarayanan, 2014, Effect of nanoscale boron carbide particle addition on the microstructural evolution and mechanical response of pure magnesium, Mater. Des., 56, 428, 10.1016/j.matdes.2013.11.031 Zhao, 2006, Low absorbed energy ductile dimple fracture in lower shelf region in an ultrafine grained ferrite/cementite steel, Metall. Mater. Trans. A, 37, 2897, 10.1007/BF02586122 Zhao, 2006, Dependence of strength and strength–elongation balance on the volume fraction of cementite particles in ultrafine grained ferrite/cementite steels, Scr. Mater., 54, 1385, 10.1016/j.scriptamat.2005.11.067 Hirano, 1996, Effect of matrix grain size on the mechanical properties of Si3N4/SiC nanocomposites densified with Y2O3, Mater. Lett., 27, 53, 10.1016/0167-577X(95)00248-0