Selection of Ca/S ratio and bed temperature for Indian lignite based CFBC boiler using simplified sulphur capture model

S. Naga Kishore1, M.L.S. Deva Kumar1, T. Venkateswara Rao2
1Department of ME, JNT University College of Engineering, Anantapur, India
2Department of ME, DBS Institute of Technology, Kavali, India

Tài liệu tham khảo

Lakshminarasimhan, 2013, High sulfur lignite fired large CFB boilers-design and operating experience Mattisson, 1998, A sulphur capture model for circulating fluidized bed boilers, Chem. Eng. Sci., 53, 1163, 10.1016/S0009-2509(97)00448-X Kullendorff, 1986, A general review on combustion in circulating fluidized beds, 83 Oka, 2004 Blaszczuk, 2012, vol. 9, 109 Basu, 2015 Wang, 2008, Validity of an Expert system for oil shale-fired CFB boiler design and performance analysis, Oil Shale, 25, 400, 10.3176/oil.2008.4.02 Basu, 2006 Ehrlich, 1975, A coal-fired fluidized bed boiler, vol. 1 Braganca, 2009, FBC Desulfurization process using coal with low sulphur content, high oxidizing condition and metamorphic limestones, Braz. J. Chem. Eng., 26, 375, 10.1590/S0104-66322009000200015 Gómez, 2014, Experiences in sulphur capture in a 30 MWth Circulating Fluidized Bed boiler under oxy-combustion conditions, Appl. Therm. Eng., 65, 617, 10.1016/j.applthermaleng.2014.01.012 Young, 2006, Desulfurization with a modified limestone formulation in an Industrial CFBC boiler, Energy Fuels, 20, 138, 10.1021/ef0501546 Yang, 2014, Lignite-fired CFB boiler SO2, NO emission control technology research, Adv. Mater. Res., 989–994, 256, 10.4028/www.scientific.net/AMR.989-994.256 Boskovic, 2002, Effect of operating parameters on sulphur capture in a pressurized circulating fluidized bed combustor, Int. J. Energy Res., 26, 173, 10.1002/er.774 2019, Evaluation of limestone for in-situ desulfurization in CFB boilers, Korean Chemical Engineering Research, 57, 853 Basu, 1991, Development of simplified model for sulphur absorption in circulating fluidized beds and experimental verification in pilot scale and large commercial CFB combustors, J. Chem. Eng. Jpn., 24, 356, 10.1252/jcej.24.356 Adanez, 1995, Sulphur retention in circulating fluidized bed coal combustion: modelling and Simulation, Coal Sci. Technol., 24, 1839, 10.1016/S0167-9449(06)80175-8 de las Obras-Loscertales, 2014, Sulfur retention in an oxy-fuel bubbling fluidized bed combustor: effect of coal rank, type of sorbent and O2/CO2 ratio, Fuel, 137, 384, 10.1016/j.fuel.2014.07.097 Nowak, 2013, 701 H. Yang, H. Zhang, L. Junfu and G.Yue, The influence of new emission standard on the CFB boiler in china and the solutions, 64th IEA FBC Meeting, Naples, Italy, June 3 (2012). Last accessed November 2020. https://www.processeng.biz/iea-fbc.org/upload/64_1_Yang%20Emissions.pdf. Fee, 1983, Fluidized-bed coal combustion: in-bed sorbent sulfation model, Chem. Eng. Sci., 38, 1917, 10.1016/0009-2509(83)85048-9 Hamer, 1987, Evaluation of SO, sorbents in a fluidized-bed reactor, 458 Basu, 1989, Effect of solid recycle rate, bed density and sorbent size on the sulfur capture in a circulating fluidized bed risers, 701 Kunii, 1991 Kunii, 1991, Flow modelling of fast fluidized beds, 91 Adanaz, 1994, Axial voidage profiles in fast fluidized beds, Powder Technol., 81, 259, 10.1016/0032-5910(94)02906-7 Bai, 1999, Quantitative estimation of solids holds up at dense and dilute regions of circulative fluidized beds, Powder Technol., 101, 183, 10.1016/S0032-5910(98)00159-4 Kim, 2014, Performance prediction of a circulating fluidized bed boiler by heat exchangers block simulation at varying load conditions, Journal of Power and Energy, 228, 17, 10.1177/0957650913506006 Yue, 2005, Design theory of circulating fluidized bed boilers, 135 Cen, 2001, Design and performance verification of a 62-MWt CFB boiler, J. Eng. Gas Turbines Power, 123, 240, 10.1115/1.1340621 Basu, 2003, An intelligent tool for evaluating bids for circulating fluidized boilers, in the proceedings of 17th International Conference on Fluidized Bed Combustion, Jacksonville, Florida, USA, ASME, FBC2003–153, 113 Naga Kishore, 2020, Mathematical model of design and performance evaluation of a 210 MW CFB boiler for Indian lignite, 607 Sengupta, 2006, Exergy analysis of a coal-based 210MW thermal power plant, Int. J. Energy Res., 31, 14, 10.1002/er.1224 S. Balasubramanian, K. Sudhindra, Surendra Bhat, An insight into advanced technology in circulating fluidised bed combustion steam generators, TATA Consulting Engineers Ltd Bangalore. Last accessed November 2020.https://www.academia.edu/34881373/An_Insight_into_Advanced_Technology_in_Circulating_Fluidised_Bed_Combustion_Steam_Generators?auto=download. Rajaram, 1999, Design features and operating experience of circulating fluidised bed boilers firing high ash coals in India Kavidass, 1999 Wang, 1999, A mathematical model for a circulating fluidized bed (CFB) Boiler, Energy, 24, 633, 10.1016/S0360-5442(99)00008-0 Wang, 2002, Model prediction of the operating behaviour of a circulating fluidized bed boiler, J. Zhejiang Univ. - Sci., 3, 251, 10.1631/jzus.2002.0251 Jiang, 2006, Flow structure and combustion characteristic of 65 t/h oil-shale-fired circulating fluidized bed riser. 1. Dense phase, Ind. Eng. Chem. Res., 45, 4329, 10.1021/ie060005q Lu, 2007, Performance evaluation of a 220t/h CFB boiler with water-cooled square cyclones, Fuel Process. Technol., 88, 129, 10.1016/j.fuproc.2004.12.008 Xianbin, 2009, Research and development of large capacity CFB boilers in TPRI, 107 Wang, 2009, Startup, commissioning and operation of fenyi 100MW CFB boiler, 137 Han, 2009, Won-kil choi, jong-seop lee, A study of Co-combustion characteristics of north Korean anthracite and bituminous coal in 2 MWe CFBC power plant, Korean Chemical Engineering Research, 47, 580 Gauvillé, 2012, Achievable combustion efficiency with ALSTOM CFB boilers for burning discarded coal, J. S. Afr. Inst. Min. Metall, 112, 437 Gu, 2017, Design and operation of a MSW and STRAW co-firing CFB boiler, 1057