Reasonable location of stopping line in close-distance underlying coal seam and partition support of large cross-section roadway
Tóm tắt
Close-distance coal seams are widely distributed over China, and the coal pillars left by the overlying coal seams affect the retracement channel of the underlying coal seam in the stopping stage. Based on the engineering background of close-distance seam mining in a coal mine, the reasonable position of the underlying coal seam's stopping line and the support method of the large section roadway during stopping are investigated using field measurements, similar simulation experiments, and numerical simulations. There are three types of location relationships between the stopping line of the underlying coal seam and the stopping line of the overlying coal seam: "externally staggered with the upper stopping line" (ESUL, stops mining under the overlying goaf), "overlapped with upper stopping line" (OUL), and "internally staggered with the upper stopping line" (ISUL, ISUL-SD for shorter internal staggered distances, ISUL-LD for longer ones). There are different stress arch structures in the overlying strata of the above three positions, and the stress arch evolution process exists in the process of ESUL → OUL → ISUL-SD → ISUL-LD: a front and rear double stress arch structure → the front arch gradually decreases → the front arch dies out, and the double arch synthesizes the single arch → the single-arch range expands → the nested double arch. The relationship between the stress arch structure and the position of the stopping line is evaluated as follows: (1) ESUL: the stress concentration in the roof plate of the retracement channel of the underlying coal seam is the highest, because the overburden block of the extensive collapse zone acts directly on the roof plate of the retracement channel, resulting in relative difficulties in roof support. (2) OUL: although the retracement channel roof pressure is minimal, the overlying rock structure has the potential for rotation or slippage instability. (3) ISUL-SD: the pressure on the roof of the retracement channel is small and the overburden structure is stable, which is conducive to the safe retraction of the support and not limited by the width of the end-mining coal pillar. (4) ISUL-LD: it is basically the same as the condition of stopping under the non-goaf; however, it has a limitation on the width of the end-mining coal pillar. The location of the stopping line is selected as ISUL-SD, and the retraction process of the self-excavating retraction channel was adopted. A partition asymmetric support scheme which is proven by field practice is proposed, through a comprehensive analysis of the pre-stress field simulation of the support scheme, based on the different control requirements of the roof above the support and the roof of the retracement channel in the stopping area. This method realizes safe and smooth withdrawal of the support.
Tài liệu tham khảo
Chen DD, Ji CW, Xie SR et al (2020) Deviatoric stress evolution laws and control in surrounding rock of soft coal and soft roof roadway under intense mining conditions. Adv Mater Sci Eng. https://doi.org/10.1155/2020/5036092
Chen DD, Wu YY, Guo FF et al (2022) Study on the first fracture of the main roof plate structure with the long side goaf and elastic-plastic softening foundation boundary. J China Coal Soc 47(4):1473–1489. https://doi.org/10.13225/j.cnki.jccs.2021.1340
Cheng G, Yang T, Liu H et al (2020) Characteristics of stratum movement induced by downward longwall mining activities in middle-distance multi-seam. Int J Rock Mech Min. https://doi.org/10.1016/j.ijrmms.2020.104517
Cui F, Jia C, Lai X et al (2020) Study on the law of fracture evolution under repeated mining of close-distance coal seams. Energies. https://doi.org/10.3390/en13226064
Gao F, Zhou KP, Dong WJ et al (2008) Similar material simulation of time series system for induced caving of roof in continuous mining under backfill. J Cent South Univ Technol 15:356–360. https://doi.org/10.1007/s11771-008-0067-y
Guo GC, Yang YK (2021) The study of key stratum location and characteristics on the mining of extremely thick coal seam under goaf. Adv Civ Eng. https://doi.org/10.1155/2021/8833822
He SS, Xie SR, Song BH et al (2016) Breaking laws and stability analysis of damage main roof in close distance hypogynous seams. J China Coal Soc 41(10):2596–2605. https://doi.org/10.13225/j.cnki.jccs.2016.0422
Huang QG, Gao F (2013) Large section open-off cut supporting technology of fully mechanized caving mining for carboniferous extra-thick coal seam. Adv Mat Res 734–737:566–569. https://doi.org/10.4028/www.scientific.net/AMR.734-737.566
Li C, Wu Z, Zhang WL et al (2020a) A case study on asymmetric deformation mechanism of the reserved roadway under mining influences and its control techniques. Geomech Eng 22(5):449–460. https://doi.org/10.12989/gae.2020.22.5.449
Li C, Guo XF, Lian XY et al (2020b) Failure analysis of a pre-excavation double equipment withdrawal channel and its control techniques. Energies. https://doi.org/10.3390/en13236368
Li C, Guo XF, Huo TH et al (2021) Coal pillar design of pre-excavated double equipment withdrawal channel and its surrounding rock stability control. J Huazhong Univ of Sci Tech. https://doi.org/10.13245/j.hust.210403
Liu F, Zhong XJ (2018) Research on deformation mechanism of retracement channel during fully mechanized caving mining in superhigh seam. Adv Civ Eng. https://doi.org/10.1155/2018/1368965
Liu XJ, Li XM, Pan WD (2016) Analysis on the floor stress distribution and roadway position in the close distance coal seams. Arab J Geosci 9(2):1–8. https://doi.org/10.1007/s12517-015-2035-9
Liu W, Qin YP, Shi CL et al (2019) Dynamic evolution of spontaneous combustion of coal in longwall gobs during mining-stopped period. Process Saf Environ Prot 132:11–21. https://doi.org/10.1016/j.psep.2019.09.027
Liu Q, Huang J, Guo Y et al (2020) Research on the temporal-spatial evolution of ground pressure at short-distance coal seams. Arab J Geosci. https://doi.org/10.1007/s12517-020-05801-0
Lou JF, Gao FQ, Yang JH et al (2021) Characteristics of evolution of mining-induced stress field in the longwall panel: insights from physical modeling. Int J Coal Sci Technol. https://doi.org/10.1007/s40789-020-00390-5
Lv HW (2014) The mechanism of stability of pre-driven rooms and the practical techniques. J China Coal Soc 39(S1):50–56. https://doi.org/10.13225/j.cnki.jccs.2014.0029
Ma XG, He MC, Wang YJ et al (2018) Study and application of roof cutting pressure releasing technology in retracement channel roof of Halagou 12201 working face. Math Probl Eng. https://doi.org/10.1155/2018/6568983
Meng QB, Han LJ, Qiao WG et al (2016) Evolution law and control technology of surrounding rock for weak and broken coal roadway with large cross section. J China Coal Soc 41(08):1885–1895. https://doi.org/10.13225/j.cnki.jccs.2015.1312
Pan WD, Zhang S, Liu Y (2020) Safe and efficient coal mining below the goaf: a case study. Energies. https://doi.org/10.3390/en13040864
Qin YP, Guo WJ, Liu W et al (2021) Precise positioning and inert processing of the high-temperature zone in a longwall gob during a mining-stopped period: an application case. Energy Sources Part A. https://doi.org/10.1080/15567036.2021.1987589
Suo YL, Shang TL, Zheng Y et al (2013) Numerical simulation on rational location of roadways at lower seam for ultra-close multiple seam mining. J China Coal Soc 38(S2):277–282. https://doi.org/10.13225/j.cnki.jccs.2013.s2.025
Vervoort A (2021) Various phases in surface movements linked to deep coal longwall mining: from start-up till the period after closure. Int J Coal Sci Technol 8(3):412–426. https://doi.org/10.1007/s40789-020-00325-0
Wang HS, Yuan H, Lu XM et al (2015) Interactions of overburden failure zones due to multiple-seam mining using longwall caving. Bull Eng Geol Environ 74(3):1019–1035. https://doi.org/10.1007/s10064-014-0674-9
Wang F, Xu JL, Xie JL et al (2016) Pressure-relief mechanism of lower seam extraction after upper seam extraction. J Min Safety Eng 33(03):398–402. https://doi.org/10.13545/j.cnki.jmse.2016.03.004
Wang E, Xie SR, Chen DD et al (2021) Distribution laws and control of deviatoric stress of surrounding rock in the coal roadway under intense mining. J Min Safety Eng. https://doi.org/10.13545/j.cnki.jmse.2020.0445
Xie SR, Zhang Q, Chen DD et al (2020) Research of roof anchorage rock beam bearing structure model of extra-large width open-off cut and its engineering application in a coal mine China. Adv Civ Eng. https://doi.org/10.1155/2020/3093294
Xie SR, Wu YY, Chen DD et al (2022a) Failure analysis and control technology of intersections of large-scale variable cross-section roadways in deep soft rock. Int J Coal Sci Technol 9:19. https://doi.org/10.1007/s40789-022-00479-z
Xie SR, Wang E, Chen DD et al (2022b) Collaborative control technology of external anchor-internal unloading of surrounding rock in deep large-section coal roadway under strong mining influence. J China Coal Soc 47(5):1946–1957. https://doi.org/10.13225/j.cnki.jccs.xr21.1990
Xue HJ, Chen J, Liu B et al (2014) Numerical simulation study on setting stopping line of working face in Shuguang mine. Appl Mech Mater. https://doi.org/10.4028/www.scientific.net/AMM.580-583.2554
Zhang N, Zhang NC, Han CL et al (2014) Borehole stress monitoring analysis on advanced abutment pressure induced by Longwall Mining. Arab J Geosci 7:457–463. https://doi.org/10.1007/s12517-013-0831-7
Zhang P, Tulu B, Sears M et al (2018) Geotechnical considerations for concurrent pillar recovery in close-distance multiple seams. Int J Min Sci Techno 28(1):21–27. https://doi.org/10.1016/j.ijmst.2017.12.012
Zhang J, Wang B, Bai W et al (2021) A study on the mechanism of dynamic pressure during the combinatorial key strata rock column instability in shallow multi-coal seams. Adv Civ Eng. https://doi.org/10.1155/2021/6664487
Zheng JW, Ju WJ, Zhao X et al (2019) Dynamic evolution characteristic on stope pressure in whole life cycle of stope. J China Coal Soc 44(4):995–1002. https://doi.org/10.13225/j.cnki.jccs.2018.0527
Zhou H, Qu CK, Huang JL et al (2017) Analysis of rational shape of stop line in deep coal seam based on model test. J Rock Mech Geotech Eng 36(10):2373–2382. https://doi.org/10.13722/j.cnki.jrme.2017.0025
Zhu GA, Liu H, Su BR et al (2021) Reasonable determination of terminal mining lines using the stress field with seismic wave excitation in deep coalfaces. Shock Vib. https://doi.org/10.1155/2021/3929004