Preparation of Nickel-Cobalt/Carborundum Carbide Composite Coatings by Supergravity Field-Enhanced Electrodeposition
Tóm tắt
Nickel-cobalt/silicon carbide (Ni-Co/SiC) composite coatings were fabricated by supergravity field-enhanced electrodeposition. The surface morphology and the distribution of the SiC particles in the coatings were examined by scanning electron microscope and energy dispersive X-ray spectrometry. The preferred orientations of the coatings were measured by X-ray diffractometry. The wear resistance and microhardness were measured by a reciprocating tribometer and a microhardness instrument, respectively. The results revealed that the use of the supergravity field enhanced the smoothness of the as-deposited Ni-Co/SiC coatings, and the SiC nanoparticles were uniformly distributed in comparison with that for conventional electrodeposition. When the rotation speed of the cathode, which provided the supergravity field, was 800 r/min, the SiC content in the coating reached a maximum of 8.1 wt%, which was a much higher content than the 2.2 wt% value obtained under conventional electrodeposition. The highest coating microhardness of 680 HV was also observed at this rotation speed. In addition, the wear resistance of the as-prepared Ni-Co/SiC coatings exhibited improved performance relative to that prepared under normal gravity. A minimum wear weight loss of 1.4 mg together with an average friction coefficient of 0.13 were also realized at a rotation speed of 800 r/min, values which were much lower than those for normal gravity.
Tài liệu tham khảo
K Ignatova, Y Marcheva. Composition and structure of Ni-Co coating depending on the ratio of Ni and Co in a citrate electrolyte. Bulgarian Chemical Communications, 2017, 49(2): 313–319.
A Sivanantham, P Ganesan, S Shanmugam. Hierarchical NiCo2S4 nanowire arrays supported on Ni foam: an efficient and durable bifunctional electrocatalyst for oxygen and hydrogen evolution reactions. Advanced Functional Materials, 2016, 26(26): 4661–4672.
C Du, L Yang, F Yang, et al. Nest-like NiCoP for highly efficient overall water splitting. ACS Catalysis, 2017, 7(6): 4131–4137.
J De, T Banerjee, R S Sen, et al. Multi-objective optimization of electroless ternary Nickel–Cobalt–Phosphorous coating using non-dominant sorting genetic algorithm-II. Engineering Science and Technology, An International Journal, 2016, 19(3): 1526–1533.
A Karimzadeh, M Aliofkhazraei, F C Walsh. A review of electrodeposited Ni-Co alloy and composite coatings: Microstructure, properties and applications. Surface and Coatings Technology, 2019, 372: 463–498.
Y J Chang, C H Chang. Intelligent computation for optimal fabrication condition of a protein chip with Ni-Co alloy-coated surface. Journal of Laboratory Automation, 2016, 21(3): 394–401.
S M L Baghal, A Amadeh, M H Sohi, et al. The effect of SDS surfactant on tensile properties of electrodeposited Ni–Co/SiC nanocomposites. Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2013, 559: 583–590.
C Ma, S Wang, F C Walsh. The electrodeposition of nanocrystalline Cobalt-Nickel-Phosphorus alloy coatings: A review. Transactions of the IMF, 2015, 93(5): 275–280.
B Bakhit, A Akbari. A comparative study of the effects of saccharin and β-SiC nano-particles on the properties of Ni and Ni–Co alloy coatings. Surface and Coatings Technology, 2014, 253: 76–82.
A Rasooli, M S Safavi, M K Hokmabad. Cr2O3 nanoparticles: A promising candidate to improve the mechanical properties and corrosion resistance of Ni-Co alloy coatings. Ceramics International, 2018, 44(6): 6466–6473.
A Al-Fatesh. Suppression of carbon formation in CH4–CO2 reforming by addition of Sr into bimetallic Ni–Co/γ-Al2O3 catalyst. Journal of King Saud University - Engineering Sciences, 2015, 27(1): 101–107.
X H Wang, B Lu, Z F Hu, et al. Effects of n-Al2O3 particles content on structure and performance of electro-brush plating Ni-Co alloy composite coatings. Rare Metal Materials and Engineering, 2016, 45(1): 36–41.
A W J Hsue, Y F Chang. Toward synchronous hybrid micro-EDM grinding of micro-holes using helical taper tools formed by Ni-Co/diamond Co-deposition. Journal of Materials Processing Technology, 2016, 234: 368–382.
P R Dheeraj, A Patra, S Sengupta, et al. Synergistic effect of peak current density and nature of surfactant on microstructure, mechanical and electrochemical properties of pulsed electrodeposited Ni-Co-SiC nanocomposites. Journal of Alloys and Compounds, 2017, 729: 1093–1107.
B Bakhit. The influence of electrolyte composition on the properties of Ni–Co alloy coatings reinforced by SiC nano-particles. Surface and Coatings Technology, 2015, 275: 324–331.
C Y Ma, D Q Zhao, Z P Ma. Effects of duty cycle and pulse frequency on microstructures and properties of electrodeposited Ni–Co–SiC nanocoatings. Ceramics International, 2012, 46(8): 12128–12137.
W Jiang, L D Shen, M Y Xu, et al. Mechanical properties and corrosion resistance of Ni-Co-SiC composite coatings by magnetic field-induced jet electrodeposition. Journal of Alloys and Compounds, 2019, 791: 847–855.
B Bakhit, A Akbari. Effect of particle size and co-deposition technique on hardness and corrosion properties of Ni–Co/SiC composite coatings. Surface and Coatings Technology, 2012, 206(23): 4964–4975.
H K Lee, H Y Lee, J M Jeon. Codeposition of micro- and nano-sized SiC particles in the nickel matrix composite coatings obtained by electroplating. Surface and Coatings Technology, 2007, 201(8): 4711–4717.
W Wang, F Y Hou, H Wang, et al. Fabrication and characterization of Ni–ZrO2 composite nano-coatings by pulse electrodeposition. Scripta Materialia, 2005, 53(5): 613–618.
N Zhang, Z Wang, L Guo, et al. Rapid fabrication of W–Cu composites via low-temperature infiltration in supergravity fields. Journal of Alloys and Compounds, 2019, 809: 151782.
N Zhang, Z Wang, L Guo, et al. Supergravity process for enriching and separating Ag from Sn–Ag–Zn melts. Chemical Engineering and Processing - Process Intensification, 2019, 143: 107591.
X C Yin, G Sun, A L Song, et al. A novel structure of Ni-(MoS2/GO) composite coatings deposited on Ni foam under supergravity field as efficient hydrogen evolution reaction catalysts in alkaline solution. Electrochimica Acta, 2017, 249: 52–63.
A Murotani, T Fuchigami, M Atobe. Electrochemical deposition of Ni/SiC under centrifugal fields. Electrochemistry, 2008, 76(11): 824–826.
X Y Hu, N S Qu. Improved corrosion resistance of Ni-Co coatings prepared by electrodeposition with large centrifugal acceleration. Journal of Materials Engineering and Performance, 2019, 28(4): 2104–2114.
X Y Hu, N S Qu. Enhanced corrosion resistance of nickel–cobalt/carborundum coatings formed by supergravity field-assisted electrodeposition. Thin Solid Films, 2020, 700: 137923.
M Srivastava, V K W Grips, K S Rajam. Electrodeposition of Ni–Co composites containing nano-CeO2 and their structure, properties. Applied Surface Science, 2010, 257(3): 717–722.
J S Chen, Y H Huang, Z D Liu. Jet electrodeposition oriented by rapid prototyping. Transactions of Nonferrous Metals Society of China, 2005, 15(3): 247–250.
W Jiang, L D Shen, M B Qiu, et al. Preparation of Ni-SiC composite coatings by magnetic field-enhanced jet electrodeposition. Journal of Alloys and Compounds, 2018, 762: 115–124.
N Guglielmi. Kinetics of the deposition of inert particles from electrolytic baths. Journal of the Electrochemical Society, 1972, 119(8): 1009.
D D Ning, A Zhang, M Murtaza, et al. Effect of surfactants on the electrodeposition of Cu-TiO2 composite coatings prepared by jet electrodeposition. Journal of Alloys and Compounds, 2019, 777: 1245–1250.
F T L Muniz, M A Miranda, C M Santos, et al. The Scherrer equation and the dynamical theory of X-ray diffraction. Acta Cryst., 2016, 72(3): 385–390.
L Benea, P L Bonora, A Borello, et al. Preparation and investigation of nanostructured SiC-nickel layers by electrodeposition. Solid State Ionics, 2002, 151(1–4): 89–95.
N P Wasekar, L Bathini, G Sundararajan. Tribological behavior of pulsed electrodeposited Ni-W/SiC nanocomposites. Journal of Materials Engineering and Performance, 2018, 27(10): 5236–5245.
J Hu, Y N Shi, X Sauvage, et al. Grain boundary stability governs hardening and softening in extremely fine nanograined metals. Science, 2017, 355 (6331): 1292–1296.
Y J Xue, W Ma, J S Li, et al. Fabrication and wear resistance of Ni-CeO2 nanocomposite coatings by electrodeposition under ultrasound condition. Advanced Tribology, 2010, 3: 202–313.
A A P Sidharth, I Sridhar. Material removal analysis for compliant polishing tool using adaptive meshing technique and Archard wear model. Wear, 2019, 418: 140–150.
S Dehgahi, R Amini, M Alizadeh. Corrosion, passivation and wear behaviors of electrodeposited Ni-Al2O3-SiC nanocomposite coatings. Surface and Coatings Technology, 2016, 304: 502–511.