Performance of X-Section Concrete Pile Group in Coral Sand Under Vertical Loading
Tóm tắt
To reveal the bearing capacity of the X-section pile group in coral sand, a series of model load tests are conducted. The testing results are presented as load-settlement curves, pile-soil stress ratios, distributions of side friction and axial force, and load-sharing ratio between side and tip resistances. The reliability and accuracy of the numerical simulation model are verified by comparing the results of the model test. Comparative analysis between X-section and circular section piles with the same cross-sectional area indicates that the bearing capacity of the X-section pile group is much larger than that of the circular pile group. The axial force of X-section piles is smaller while the peak skin friction is larger than that of circular piles at the same depth. The skin friction of the core pile is the largest, followed by the side pile and the corner pile is the smallest when the load is relatively small; however, it is converse when the load is larger than 10 kN. Compared with piles in silica sand, the pile in coral sand has a lower bearing capacity, and the sand breakage leads to the steep drop failure of pile foundation. Moreover, pile positions under the raft have less effect on the load-share differences among corner, side and core piles in coral sand. This study provides a reference for the construction of pile foundations in coral sand.
Tài liệu tham khảo
Chen, Y.H., Wang, X.Q., Liu, H.L., Jiang, L. and Zhang, T., 2009. In-Situ study on stress distribution of foundation improved by Y-section pile, International Symposium on Ground Improvement Technologies and Case Histories, ISGI, pp. 319–330.
Chin, J.T. and Poulos, H.G., 1996. Tests on model jacked piles in calcareous sand, Geotechnical Testing Journal, 19(2), 164–180.
Cui, C.Y., Meng, K., Wu, Y.J., Chapman, D. and Liang, Z.M., 2018. Dynamic response of pipe pile embedded in layered visco-elastic media with radial inhomogeneity under vertical excitation, Geomechanics and Engineering, 16(6), 609–618.
Ding, X.M., Kong, G.Q., Liu, H.L. and Lu, Y.R., 2012. Field test study of pile–soil load transfer characteristics of X-shaped cast-in-place pile, Rock and Soil Mechanics, 33(2), 489–493. (in Chinese)
Ding, X.M., Luan, L.B., Zheng, C.J., Mei, G.X. and Zhou, H., 2020. An analytical solution for wave propagation in a pipe pile with multiple defects, Acta Mechanica Solida Sinica, 33(2), 251–267.
Kong, G.Q., Ding, X.M., Chen, Y.M. and Yang, G., 2012. Vertical uplift capacity characteristics and influence factor analysis of cast-in-situ X-section reinforced concrete pile group, Journal of Architecture and Civil Engineering, 29(3), 49–54. (in Chinese)
Li, Z.Y. and Gao, Y.F., 2019. Effects of inner soil on the vertical dynamic response of a pipe pile embedded in inhomogeneous soil, Journal of Sound and Vibration, 439, 129–143.
Liu, H.L., 2007. Cast-in-situ X Shaped Pile Mould Sinking Device, Chinese Patent CN200720036892.6. (in Chinese)
Liu, H.L., Liu, Z.P. and Wang, X.Q., 2009. Study on the geometric characteristics of the cast-in-place X-type vibro-pile section, China Railway Science, 30(1), 17–23.
Liu, F., Yi, J., Cheng, P. and Yao, K., 2020. Numerical simulation of set-up around shaft of XCC pile in clay, Geomechanics and Engineering, 21(5), 489–501.
Luan, L.B., Zheng, C.J., Kouretzis, G. and Ding, X.M., 2020. Dynamic analysis of pile groups subjected to horizontal loads considering coupled pile-to-pile interaction, Computers and Geotechnics, 117, 103276.
Lv, Y., Liu, J. and Zuo, D., 2018. Moisture effects on the undrained dynamic behavior of calcareous sand at high strain rates, Geotechnical Testing Journal, 42(3), 725–746.
Lv, Y.R., Ding, X.M. and Liu, H.L., 2011. In situ tests on cast-in-place concrete X-section pile for bearing capacity of single-pile composite foundation, Geohunan International Conference 2011, Hunan, China. pp. 39–47.
Lv, Y.R., Liu, H.L., Ng, C.W.W., Gunawan, A. and Ding, X.M., 2014. A modified analytical solution of soil stress distribution for XCC pile foundations, Acta Geotechnica, 9(3), 529–546.
Lv, Y.R., Ng, C.W.W., Lam, S.Y., Liu, H.L. and Ding, X.M., 2016. Comparative study of Y-shaped and circular floating piles in consolidating clay, Canadian Geotechnical Journal, 53(9), 1483–1494.
Murff, J.D., 1987. Pile capacity in calcareous sands: State if the art, Journal of Geotechnical Engineering, 113(5), 490–507.
Qu, L.M., Ding, X.M., Zheng, C.J. and Liu, H.L., 2017. An analytical solution for wave propagation in a square pile due to transient point load, Computer and Geotechnics, 83, 77–82.
Qu, L.M., Ding, X.M., Wu, C.R., Long, Y.H. and Yang, J.C., 2020. Effects of topography on dynamic responses of single piles under vertical cyclic loading, Journal of Mountain Science, 17(1), 230–243.
Seo, H., Basu, D., Prezzi, M. and Salgado, R., 2009. Load-settlement response of rectangular and circular piles in multilayered soil, Journal of Geotechnical and Geoenvironmental Engineering, 135(3), 420–430.
Shahnazari, H. and Rezvani, R., 2013. Effective parameters for the particle breakage of calcareous sands: An experimental study, Engineering Geology, 159, 98–105.
Wang, X.Z., Jiao, Y.Y., Wang, R., Hu, M.J., Meng, Q.S. and Tan, F.Y., 2011. Engineering characteristics of the calcareous sand in Nansha Islands, South China Sea, Engineering Geology, 120(1–4), 40–47.
Wang, Z.Q., Liu, H.L., Zhang, M.X., Yuan, J. and Yong, J., 2010. Full scale model tests on vertical bearing characteristics of cast-in-place X-section piles, Chinese Journal of Geotechnical Engineering, 32(6), 903–907. (in Chinese)
Wu, W.B., Liu, H., Yang, X.Y., Jiang, G.S., El Naggar, M.H., Mei, G.X. and Liang, R.Z., 2020. New method to calculate apparent phase velocity of open-ended pipe pile, Canadian Geotechnical Journal, 57(1), 127–138.
Yong, J., Lu, X.M. and Liu, H.L., 2010. Model test study of antipulling property of X-shaped concrete pile, Rock and Soil Mechanics, 31(11), 3430–3434. (in Chinese)
Zhang, M., Wang, X.H., Yang, G.C. and Xie, L.Z., 2013. Study of dynamic model testing of single pile and behaviors of pile-soil interface under cyclic load, Rock and Soil Mechanics, 34(4), 1037–1044. (in Chinese)
Zhang, M.X., Ding, X.M. and Chen, Y.M., 2011. Test on vertical behavior of cast-in-situ X-shaped concrete pile and its ultimate bearing capacity prediction, Journal of China Coal Society, 36(2), 267–271. (in Chinese)
Zhang, M.X., Feng, X.C. and Xu, P., 2014. Analysis on research progress of cast-in-situ X-section concrete pile, Subgrade Engineering, (4), 12–16. (in Chinese)