Passivation and depassivation properties of Cr–Mo alloyed corrosion-resistant steel in simulated concrete pore solution

Fu, 2021, Bond degradation of non-uniformly corroded steel rebars in concrete, Eng. Struct., 226, 111392, 10.1016/j.engstruct.2020.111392 Hornbostel, 2016, Influence of mortar resistivity on the rate-limiting step of chloride-induced macro-cell corrosion of reinforcing steel, Corrosion Sci., 110, 46, 10.1016/j.corsci.2016.04.011 Zhao, 2015, Shape of corrosion-induced cracks in recycled aggregate concrete, Corrosion Sci., 98, 310, 10.1016/j.corsci.2015.05.028 Mundra, 2017, Chloride-induced corrosion of steel rebars in simulated pore solutions of alkali-activated concretes, Cement Concr. Res., 100, 385, 10.1016/j.cemconres.2017.08.006 Berrocal, 2016, Corrosion of steel bars embedded in fibre reinforced concrete under chloride attack: state of the art, Cement Concr. Res., 80, 69, 10.1016/j.cemconres.2015.10.006 Tang, 2015, Recent durability studies on concrete structure, Cement Concr. Res., 78, 143, 10.1016/j.cemconres.2015.05.021 Jin, 2020, Influence of SAP on the chloride penetration and corrosion behavior of steel bar in concrete, Corrosion Sci., 171, 108714, 10.1016/j.corsci.2020.108714 Chang, 2021, Comprehensive resistance of fair-faced concrete suffering from sulfate attack under marine environments, Construct. Build. Mater., 277, 122312, 10.1016/j.conbuildmat.2021.122312 Li, 2021, Corrosion mechanism of reinforced bars inside concrete and relevant monitoring or detection apparatus: a review, Construct. Build. Mater., 279, 122432, 10.1016/j.conbuildmat.2021.122432 Bao, 2020, Influence of the incorporation of recycled coarse aggregate on water absorption and chloride penetration into concrete, Construct. Build. Mater., 239, 117845, 10.1016/j.conbuildmat.2019.117845 Bao, 2020, Coupled effects of sustained compressive loading and freeze–thaw cycles on water penetration into concrete, Struct. Concr., 1 Xiong, 2018, Preparation of phytic acid conversion coating and corrosion protection performances for steel in chlorinated simulated concrete pore solution, Corrosion Sci., 139, 275, 10.1016/j.corsci.2018.05.018 Liu, 2020, A novel green reinforcement corrosion inhibitor extracted from waste Platanus acerifolia leaves, Construct. Build. Mater., 260, 119695, 10.1016/j.conbuildmat.2020.119695 Moffatt, 2017, Performance of high-volume fly ash concrete in marine environment, Cement Concr. Res., 102, 127, 10.1016/j.cemconres.2017.09.008 Aguirre-Guerrero, 2017, A novel geopolymer application: coatings to protect reinforced concrete against corrosion, Appl. Clay Sci., 135, 437, 10.1016/j.clay.2016.10.029 Carmona Calero, 2017, Influence of different ways of chloride contamination on the effi ciency of cathodic protection applied on structural reinforced concrete elements, J. Electroanal. Chem., 793, 8, 10.1016/j.jelechem.2016.08.029 Etteyeb, 2016, Protection of reinforcement steel corrosion by phenylphosphonic acid pre-treatment PART II: tests in mortar medium, Cement Concr. Compos., 65, 94, 10.1016/j.cemconcomp.2015.10.010 Etteyeb, 2015, Protection of reinforcement steel corrosion by phenyl phosphonic acid pre-treatment PART I: tests in solutions simulating the electrolyte in the pores of fresh concrete, Cement Concr. Compos., 55, 241, 10.1016/j.cemconcomp.2014.07.025 Liu, 2017, Corrosion behavior of low-Cr steel rebars in alkaline solutions with different pH in the presence of chlorides, J. Electroanal. Chem., 803, 40, 10.1016/j.jelechem.2017.09.016 Roventi, 2014, Corrosion resistance of galvanized steel reinforcements in carbonated concrete: effect of wet-dry cycles in tap water and in chloride solution on the passivating layer, Cement Concr. Res., 65, 76, 10.1016/j.cemconres.2014.07.014 Du, 2020, Chloride ions migration and induced reinforcement corrosion in concrete with cracks: a comparative study of current acceleration and natural marine exposure, Construct. Build. Mater., 263, 120099, 10.1016/j.conbuildmat.2020.120099 Serdar, 2013, Long-term corrosion behaviour of stainless reinforcing steel in mortar exposed to chloride environment, Corrosion Sci., 69, 149, 10.1016/j.corsci.2012.11.035 Trejo, 2004, Accelerated chloride threshold testing-Part Ⅱ: corrosion resistant reinforcement, ACI Mater. J., 101, 57 Mohamed, 2009 Luo, 2017, Effect of cold deformation on the corrosion behaviour of UNS S31803 duplex stainless steel in simulated concrete pore solution, Corrosion Sci., 124, 178, 10.1016/j.corsci.2017.05.021 Shi, 2020, Degradation effect of carbonation on electrochemical behavior of 2304 duplex stainless steel in simulated concrete pore solutions, Corrosion Sci., 177, 109006, 10.1016/j.corsci.2020.109006 Shi, 2021, Long-term corrosion resistance of reinforcing steel in alkali-activated slag mortar after exposure to marine environments, Corrosion Sci., 179, 109175, 10.1016/j.corsci.2020.109175 You, 2020, Corrosion behaviour of low-carbon steel reinforcement in alkali-activated slag-steel slag and Portland cement-based mortars under simulated marine environment, Corrosion Sci., 175, 108874, 10.1016/j.corsci.2020.108874 Shi, 2020, Passivation and corrosion behavior of 2304 duplex stainless steel in alkali-activated slag materials, Cement Concr. Compos., 108, 103532, 10.1016/j.cemconcomp.2020.103532 Criado, 2015, Steel corrosion in simulated carbonated concrete pore solution its protection using sol-gel coatings, Prog. Org. Coating, 88, 228, 10.1016/j.porgcoat.2015.06.002 Zhang, 2009, Influence of phytic acid concentration on coating properties obtained by MAO treatment on magnesium alloys, Appl. Surf. Sci., 255, 7893, 10.1016/j.apsusc.2009.04.145 Cui, 2008, Influence of phytic acid concentration on performance of phytic acid conversion coatings on the AZ91D magnesium alloy, Mater. Chem. Phys., 111, 503, 10.1016/j.matchemphys.2008.05.009 Babaee, 2016, Chloride-induced corrosion of reinforcement in low-calcium fly ash-based geopolymer concrete, Cement Concr. Res., 88, 96, 10.1016/j.cemconres.2016.05.012 Andrade, 1996, Corrosion rate monitoring in the laboratory and on-site, Construct. Build. Mater., 10, 315, 10.1016/0950-0618(95)00044-5 Otieno, 2016, Chloride-induced corrosion of steel in cracked concrete-Part I:Experimental studies under accelerated and natural marine environments, Cement Concr. Res., 79, 373, 10.1016/j.cemconres.2015.08.009 Yamashita, 2008, Analysis of XPS spectra of Fe2+ and Fe3+ ions in oxide materials, Appl. Surf. Sci., 254, 2441, 10.1016/j.apsusc.2007.09.063 Joiret, 2002, Use of EIS, ring-disk electrode EQCM and Raman spectroscopy to study the film of oxides formed on iron in 1M NaOH, Cement Concr. Compos., 24, 7, 10.1016/S0958-9465(01)00022-1 Maedaa, 1998, The role of chromate treatment after phosphating in paint adhesion, Prog. Org. Coating, 33, 83, 10.1016/S0300-9440(98)00014-9 Ai, 2016, Passive behaviour of alloy corrosion-resistant steel Cr10Mo1 in simulating concrete pore solutions with different pH, Appl. Surf. Sci., 389, 1126, 10.1016/j.apsusc.2016.07.142 Olsson, 2003, Passive films on stainless steels-chemistry, structure and growth, Electrochim. Acta, 48, 1093, 10.1016/S0013-4686(02)00841-1 Schmki, 2002, From bacon to barriers of metals of metals and alloys: a review on the passivity, J. Solid State Electrochem., 6, 145, 10.1007/s100080100219 Uhlig, 1979, Passivity in metals and alloys, Corrosion Sci., 19, 777, 10.1016/S0010-938X(79)80075-X Cattarin, 2008, Electrodes coated by passive oxide films with a thickness profile: modeling and measurement of the impedance response, J. Electrochem. Soc., 155, 543, 10.1149/1.2976214 Li, 2017, Passive film growth on carbon steel and its nanoscale features at various passivating potentials, Appl. Surf. Sci., 396, 144, 10.1016/j.apsusc.2016.11.046 Linter, 1999, Reactions of pipeline steels in carbon dioxide solutions, Corrosion Sci., 41, 117, 10.1016/S0010-938X(98)00104-8 Burstein, 1983, Growth of passivation films on scratched 304L stainless steel in alkaline solution, Corrosion Sci., 23, 125, 10.1016/0010-938X(83)90111-7 Kirchheim, 1987, Growth kinetics of passive films, Electrochim. Acta, 32, 1619, 10.1016/0013-4686(87)90015-6 Macdonald, 2011, The history of the point defect model for the passive state: a brief review of film growth aspects, Electrochim. Acta, 56, 1761, 10.1016/j.electacta.2010.11.005 Xu, 2009, Oxide formation and conversion on carbon steel in mildly basic solutions, Electrochim. Acta, 54, 5727, 10.1016/j.electacta.2009.05.020 Soltis, 2015, Passivity breakdown, pit initiation and propagation of pits in metallic materials-Review, Corrosion Sci., 90, 5, 10.1016/j.corsci.2014.10.006 Lin, 1981, A point defect model for anodic passive films II. Chemical breakdown and pit initiation, J. Electrochem. Soc., 128, 1194, 10.1149/1.2127592