Optimum design of cooling lines in injection moulds by using boundary element design sensitivity analysis

Finite Elements in Analysis and Design - Tập 14 Số 2-3 - Trang 177-185 - 1993
Toshiro MATSUMOTO1, Masataka Tanaka1, Mamoru Miyagawa2, Noboru Ishii2
1Department of Mechanical Systems Engineering, Faculty of Engineering, Shinshu University, 500 Wakasato, Nagano 380, Japan
2Graduate School of Shinshu University, 500 Wakasato, Nagano 380, Japan

Tóm tắt

Từ khóa


Tài liệu tham khảo

Davey, 1990, Modelling the pressure die-casting process with the boundary element method: steady state approximation, Int. J. Numer. Methods Eng., 30, 1275, 10.1002/nme.1620300705

Davey, 1990, Modelling the transient thermal behaviour of the pressure die-casting process with the BEM, Appl. Math. Modelling, 14, 394, 10.1016/0307-904X(90)90095-M

Matsuoka, 1991, Simulation of injection mould cooling by boundary element method, Trans. Jpn. Soc. Mech. Eng., 57, 1865, 10.1299/kikaia.57.1865

Barone, 1981, Special boundary integral equations for approximate solution of Laplace's equation in two-dimensional regions with circular holes, Q. J. Mech. Appl. Math., 34, 265, 10.1093/qjmam/34.3.265

Kane, 1986, Shape optimization utilizing a boundary element formulation, 781

Barone, 1988, Boundary integral equations for recovery of design sensitivities in shape optimization, AIAA J., 2, 589, 10.2514/3.9938

Matsumoto, 1991, Sensitivity analysis of frequency response in acoustic problems using boundary element method, 433

Thông tin
Thông tin xuất bản

Finite Elements in Analysis and Design

Tập 14 Số 2-3

177-185

Thông tin tác giả