On the visco-elasto-plastic response of additively manufactured polyamide-12 (PA-12) through selective laser sintering

Starr, 2011, The effect of process conditions on mechanical properties of laser-sintered nylon, Rapid Prototyp. J., 17, 418, 10.1108/13552541111184143 Caulfield, 2007, Dependence of mechanical properties of polyamide components on build parameters in the SLS process, J. Mater. Process. Technol., 182, 477, 10.1016/j.jmatprotec.2006.09.007 Cooke, 2011, Anisotropy, homogeneity and ageing in an SLS polymer, Rapid Prototyp. J., 17, 269, 10.1108/13552541111138397 Salazar, 2014, Monotonic loading and fatigue response of a bio-based polyamide PA11 and a petrol-based polyamide PA12 manufactured by selective laser sintering, Eur. Polym. J., 59, 36, 10.1016/j.eurpolymj.2014.07.016 Ajoku, 2006, Investigating mechanical anisotropy and end-of-vector effect in laser-sintered nylon parts, Proc. Inst. Mechanical Eng. Part B-J. Eng. Manufacture, 220, 1077, 10.1243/09544054JEM537 Amel, 2014, Investigating the behavior of laser-sintered Nylon 12 parts subject to dynamic loading, J. Mater. Res., 29, 1852, 10.1557/jmr.2014.150 Van Hooreweder, 2013, On the difference in material structure and fatigue properties of nylon specimens produced by injection molding and selective laser sintering, Polym. Test., 32, 972, 10.1016/j.polymertesting.2013.04.014 Munguia, 2014, Fatigue behaviour of laser-sintered PA12 specimens under four-point rotating bending, Rapid Prototyp. J., 20, 291, 10.1108/RPJ-07-2012-0064 Ramos-Grez, 2008, Elastic tensor stiffness coefficients for SLS Nylon 12 under different degrees of densification as measured by ultrasonic technique, Rapid Prototyp. J., 14, 260, 10.1108/13552540810907929