Numerical studies of undulation control on dynamic stall for reverse flows
Tóm tắt
The delayed detached-eddy simulation with adaptive coefficient (DDES-AC) method is used to simulate the baseline and leading-edge undulation control of dynamic stall for the reverse flow past a finite-span wing with NACA0012 airfoil. The numerical results of the baseline configuration are compared with available measurements. DDES and DDES-AC perform differently when predicting the primary and secondary dynamic stalls. Overall, DDES-AC performs better owing to the decrease of grey area between the strong shear layer and the fully three-dimensional separated flow. Moreover, the effects of the undulating leading-edge on the forces, lift gradients, and instantaneous flow structures are explored. Compared with the uncontrolled case, the lift gradient in the primary dynamic stall is reduced from 18.4 to 8.5, and the secondary dynamic stall disappears. Therefore, periodic unsteady air-loads are also reduced. Additionally, the control mechanism of the wavy leading edge (WLE) is also investigated by comparison with the straight leading edge (SLE). No sudden breakdown of strong vortices is the main cause for WLE control.
Tài liệu tham khảo
Datta, A., Yeo, H., Norman, T.R.: Experimental investigation and fundamental understanding of a full-scale slowed rotor at high advance ratios. J. Am. Helicopter Soc. 58, 1–17 (2013)
Potsdam, M., Datta, A., Jayaraman, B.: Computational investigation and fundamental understanding of a slowedUH-60A rotor at high advance ratios. J. Am. Helicopter Soc. 61, 1–17 (2016)
Potsdam, M., Yeo, H., Ormiston, R.A.: Performance and loads predictions of a slowed uh-60a rotor at high advance ratios. In: 39th European Rotorcraft Forum (2013)
Corke, T.C., Thomas, F.O.: Dynamic stall in pitching airfoils: aerodynamic damping and compressibility effects. Annu. Rev. Fluid Mech. 47, 479–505 (2015)
Costes, M., Richez, F., Le Pape, A., et al.: Numerical investigation of three-dimensional effects during dynamic stall. Aerosp. Sci. Technol. 47, 216–237 (2015)
Visbal, M.R.: Numerical investigation of deep dynamic stall of a plunging airfoil. AIAA J. 49, 2152–2170 (2011)
Akbari, M.H., Price, S.J.: Simulation of dynamic stall for a NACA 0012 airfoil using a vortex method. J. Fluid Struct. 17, 855–874 (2003)
Carr, L.W.: Progress in analysis and prediction of dynamic stall. J. Aircr. 25, 6–17 (2009)
Lind, A.H., Jones, A.R.: Unsteady airloads on static airfoils through high angles of attack and in reverse flow. J. Fluid Struct. 63, 259–279 (2016)
Lind, A.H., Smith, L.R., Milluzzo, J.I., et al.: Reynolds number effects on rotor blade sections in reverse flow. J. Aircr. 53, 1248–1260 (2016)
Lind, A.H., Jones, A.R.: Vortex shedding from airfoils in reverse flow. AIAA J. 53, 2621–2633 (2015)
Lind, A.H., Lefebvre, J.N., Jones, A.R.: Time-averaged aerodynamics of sharp and blunt trailing-edge static airfoils in reverse flow. AIAA J. 52, 2751–2764 (2014)
Lind, A.H., Jones, A.R.: Unsteady aerodynamics of reverse flow dynamic stall on an oscillating blade section. Phys. Fluids 28, 1–17 (2016)
Lind, A.H., Trollinger, L.N., Manar, F.H., et al.: Flowfield measurements of reverse flow on a high advance ratio rotor. Exp. Fluids 59, 185 (2018)
Smith, L.R., Jones, A.R.: Measurements on a yawed rotor blade pitching in reverse flow. Phys. Rev. Fluids 4, 034703 (2019)
Kirk, P.B., Jones, A.R.: Vortex formation on surging aerofoils with application to reverse flow modelling. J. Fluid Mech. 859, 59–88 (2019)
Hodara, J., Lind, A.H., Jones, A.R., et al.: Collaborative investigation of the aerodynamic behavior of airfoils in reverse flow. J. Am. Helicopter Soc. 61, 1–15 (2016)
Traub, L.W., Miller, A.C., Rediniotis, O., et al.: Effects of synthetic jets on large amplitude sinusoidal pitch motions. J. Aircr. 42, 282–285 (2005)
Yen, J., Ahmed, N.A.: Parametric study of dynamic stall flow field with synthetic jet actuation. J. Fluids Eng. 134, 071106 (2012)
Greenblatt, D., Wygnanski, I.: Dynamic stall control by periodic excitation, Part 1: NACA 0015 parametric study. J. Aircr. 38, 430–438 (2001)
Yang, G.W., Wang, S.W., Liu, N.Y., et al.: Control of unsteady vortical lift on an airfoil by leading-edge blowing-suction. Acta Mech. Sinica 13, 304–312 (1997)
Post, M.L., Corke, T.C.: Separation control using plasma actuators: dynamic stall vortex control on oscillating airfoil. AIAA J. 44, 3125–3135 (2006)
Wang, Z., Zhuang, M.: Leading-edge serrations for performance improvement on a vertical-axis wind turbine at low tip-speed-ratios. Appl. Energy 208, 1184–1197 (2017)
Pape, A.L., Costes, M., Joubert, G., et al.: Dynamic stall control using deployable leading-edge vortex generators. AIAA J. 50, 2135–2145 (2012)
Heine, B., Mulleners, K., Joubert, G., et al.: Dynamic stall control by passive disturbance generators. AIAA J. 51, 2086–2097 (2013)
Carr, L.W., Chandrasekhara, M.S., Wilder, M.C., et al.: Effect of compressibility on suppression of dynamic stall using a slotted airfoil. J. Aircr. 38, 296–309 (2001)
Chandrasekhara, M.S., Martin, P.B., Tung, C.: Compressible dynamic stall control using a variable droop leading edge airfoil. J. Aircr. 41, 862–869 (2004)
Niu, J.P., Lei, J.M., Lu, T.Y.: Numerical research on the effect of variable droop leading-edge on oscillating NACA 0012 airfoil dynamic stall. Aerosp. Sci. Technol. 72, 476–485 (2018)
Leknys, R.R., Arjomandi, M., Kelso, R.M., et al.: Thin airfoil load control during post-stall and large pitch angles using leading-edge trips. J. Wind Eng. Ind. Aerodyn. 179, 80–91 (2018)
Lee, T., Gerontakos, P.: Dynamic stall flow control via a trailing-edge flap. AIAA J. 44, 469–480 (2006)
Zheng, W., Yan, C., Liu, H., et al.: Comparative assessment of SAS and DES turbulence modeling for massively separated flows. Acta Mech. Sinica 32, 12–21 (2016)
Xiao, Z.X., Zhang, Y.F., Huang, J.B., et al.: Prediction of separation flows around a 6:1 prolate spheroid using RANS/LES hybrid approaches. Acta Mech. Sinica 23, 369–382 (2007)
Liu, J., Zhu, W., Xiao, Z.X., et al.: DDES with adaptive coefficient for stalled flows past a wind turbine airfoil. Energy 161, 846–858 (2018)
Gritskevich, M.S., Garbaruk, A.V., Schütze, J., et al.: Development of DDES and IDDES formulations for the k-ω shear stress transport model. Flow Turbul. Combust. 88, 431–449 (2012)
Deardorff, J.W.: A numerical study of three-dimensional turbulent channel flow at large Reynolds number. J. Fluid Mech. 41, 453–480 (1970)
Lilly, D.K.: The representation of small scale turbulence in numerical simulation experiments. Lecture notes on turbulence, World Scientific, pp. 171–218 (1966)
Shur, M.L., Spalart, P.R., Strelets, M.K., et al.: An enhanced version of DES with rapid transition from RANS to LES in separated flows. Flow Turbul. Combust. 95, 709–737 (2015)
Liu, J., Luo, K.Y., Sun, H.S., et al.: Dynamic response of vortex breakdown flows to a pitching double delta wing. Aerosp. Sci. Technol. 72, 564–577 (2018)
Liu, J., Sun, H.S., Huang, Y., et al.: Numerical investigation of an advanced aircraft model during pitching motion at high incidence. Sci. China Technol. Sci. 59, 276–288 (2016)
Liu, J., Xiao, Z.X., Fu, S.: Unsteady transition studies over a pitching airfoil using a k-ω-γ transition model. AIAA J. 56, 1–6 (2018)
Zhang, M.J., Wu, Q., Huang, B., et al.: Lagrangian based numerical investigation of aerodynamic performance of an oscillating foil. Acta Mech. Sinica 5, 792–804 (2018)
Wang, B., Liu, J., Li, Q.B., et al.: Numerical studies of reverse flows controlled by undulating leading edge. Sci. China Phys. Mech. Astron. 62, 974712 (2019)
Pérez-Torró, R., Kim, J.W.: A large-eddy simulation on a deep-stalled aerofoil with a wavy leading edge. J. Fluid Mech. 813, 23–52 (2017)