Numerical investigation of hydrodynamics and heat transfer of elongated bubbles during flow boiling in a microchannel
Tóm tắt
Từ khóa
Tài liệu tham khảo
Agostini, 2007, State of the art of high heat flux cooling technologies, Heat Transfer Engineering, 28, 258, 10.1080/01457630601117799
Revellin, 2006, Characterization of diabatic two-phase flows in microchannels: Flow parameter results for R-134a in a 0.5 mm channel, Int. J. of Multiphase Flow, 32, 755, 10.1016/j.ijmultiphaseflow.2006.02.016
Walsh, 2010, Heat transfer model for gas-liquid slug flows under constant heat flux, Int. J. of Heat and Mass Transfer, 53, 3193, 10.1016/j.ijheatmasstransfer.2010.03.007
Thome, 2004, Heat transfer model for evaporation in microchannels. Part I: presentation of the model, Int. J. of Heat and Mass Transfer, 47, 3375, 10.1016/j.ijheatmasstransfer.2004.01.006
Garimella, 2003, Transport in microchannels - a critical review, Annu. Rev. Heat Transfer, 13, 1, 10.1615/AnnualRevHeatTransfer.v13.30
Bertsch, 2008, Review and comparative analysis of studies on saturated flow boiling in small channels, Nanoscale and Microscale Thermophysical Engineering, 12, 187, 10.1080/15567260802317357
J.R. Thome, Wolverine Engineering Data Book III, Available free at http://www.wlv.com/products/databook/db3/DataBookIII.pdf, 2004.
B. Agostini, J.R. Thome, Comparison of an extended database for boiling heat transfer coefficients in multi-microchannels elements with the three-zone model, in: ECI Heat Transfer and Fluid Flow in Microscale, Castelvecchio Pascoli, Italy.
Cooper, 1984, Heat flow rates in saturated nucleate pool boiling - A wide-ranging examination using reduced properties, Advances in Heat Transfer, 16, 157, 10.1016/S0065-2717(08)70205-3
Agostini, 2008, High heat flux flow boiling in silicon multi-microchannels - Part II: Heat transfer characteristics of refrigerant R245fa, Int. J. of Heat and Mass Transfer, 51, 5415, 10.1016/j.ijheatmasstransfer.2008.03.007
Ong, 2011, Macro-to-microchannel transition in two-phase flow: Part 2 -Flow boiling heat transfer and critical heat flux, Experimental Thermal and Fluid Science, 35, 873, 10.1016/j.expthermflusci.2010.12.003
Harirchian, 2012, Flow regime-based modeling of heat transfer and pressure drop in microchannel flow boiling, Int. J. of Heat and Mass Transfer, 55, 1246, 10.1016/j.ijheatmasstransfer.2011.09.024
Dupont, 2004, Heat transfer model for evaporation in microchannels. Part II: comparison with the database, Int. J. of Heat and Mass Transfer, 47, 3387, 10.1016/j.ijheatmasstransfer.2004.01.007
Ribatski, 2007, On the prediction of heat transfer in micro-scale flow boiling, Heat Transfer Engineering, 28, 842, 10.1080/01457630701378267
Consolini, 2009, Micro-channel flow boiling heat transfer of R-134a, R-236fa, and R-245fa, Microfluid Nanofluid, 6, 731, 10.1007/s10404-008-0348-7
Han, 2012, The effect of liquid film evaporation on flow boiling heat transfer in a microtube, Int. J. of Heat and Mass Transfer, 55, 547, 10.1016/j.ijheatmasstransfer.2011.11.005
Kew, 1997, Correlations for prediction of flow boiling heat transfer in small-diameters channels, Applied Thermal Engineering, 17, 705, 10.1016/S1359-4311(96)00071-3
Ong, 2011, Macro-to-microchannel transition in two-phase flow: Part 1 -Two-phase flow patterns and film thickness measurements, Experimental Thermal and Fluid Science, 35, 37, 10.1016/j.expthermflusci.2010.08.004
Revellin, 2007, A new type of diabatic flow pattern map for boiling heat transfer in microchannels, J. of Micromechanics and Microengineering, 17, 788, 10.1088/0960-1317/17/4/016
Harirchian, 2010, A comprehensive flow regime map for microchannel flow boiling with quantitative transition criteria, Int. J. of Heat and Mass Transfer, 53, 2694, 10.1016/j.ijheatmasstransfer.2010.02.039
Han, 2009, Measurement of the liquid film thickness in microtube slug flow, Int. J. of Heat and Mass Transfer, 30, 842
Han, 2010, The effect of bubble acceleration on the liquid film thickness in micro tubes, Int. J. of Heat and Fluid Flow, 31, 630, 10.1016/j.ijheatfluidflow.2010.02.002
Sussman, 1994, A level set approach for computing solutions to incompressible two-phase flow, J. of Computational Physics, 114, 146, 10.1006/jcph.1994.1155
Hirt, 1981, Volume of fluid (VOF) method for the dynamics of free boundaries, J. of Computational Physics, 39, 201, 10.1016/0021-9991(81)90145-5
Talimi, 2012, A review on numerical studies of slug flow hydrodynamics and heat transfer in microtubes and microchannels, Int. J. of Multiphase Flow, 39, 88, 10.1016/j.ijmultiphaseflow.2011.10.005
Mukherjee, 2005, Numerical simulation of growth of a vapor bubble during flow boiling of water in microchannel, Microfluid Nanofluid, 1, 137, 10.1007/s10404-004-0021-8
Suh, 2008, Bubble dynamics, flow, and heat transfer during flow boiling in parallel microchannels, Numerical Heat Transfer, Part A, 54, 390, 10.1080/10407780802164561
Mukherjee, 2009, Contribution of thin-film evaporation during flow boiling inside microchannels, Int. J. of Thermal Sciences, 48, 2025, 10.1016/j.ijthermalsci.2009.03.006
Jacobi, 2002, Heat transfer model for evaporation of elongated bubble flows in microchannels, J. of Heat Transfer, 124, 1131, 10.1115/1.1517274
Mukherjee, 2011, Numerical study of bubble growth and wall heat transfer during flow boiling in a microchannel, Int. J. of Heat and Mass Transfer, 54, 3702, 10.1016/j.ijheatmasstransfer.2011.01.030
Zu, 2011, Confined bubble growth during flow boiling in a mini-/micro-channel of rectangular cross-section part II: Approximate 3-D numerical simulation, Int. J. of Thermal Sciences, 50, 267, 10.1016/j.ijthermalsci.2010.09.004
Zhuan, 2012, Flow pattern of boiling in micro-channel by numerical simulation, Int. J. of Heat and Mass Transfer, 55, 1741
Juric, 1998, Computations of boiling flows, Int. J. of Multiphase Flow, 24, 387, 10.1016/S0301-9322(97)00050-5
Son, 2008, Numerical simulation of nucleate boiling on a horizontal surface at high heat fluxes, Int. J. of Heat and Mass Transfer, 51, 2566, 10.1016/j.ijheatmasstransfer.2007.07.046
Kunkelmann, 2009, CFD simulation of boiling flows using the Volume-of-Fluid method within OpenFOAM, Numerical Heat Transfer, Part A, 56, 631, 10.1080/10407780903423908
Cummins, 2005, Estimating curvature from volume fractions, Computers and Structures, 83, 425, 10.1016/j.compstruc.2004.08.017
Bornia, 2011, On the properties and limitations of the height function method in two-dimensional Cartesian geometry, J. of Computational Physics, 230, 851, 10.1016/j.jcp.2010.11.029
Francois, 2006, A balanced-force algorithm for continuous and sharp interfacial surface tension models within a volume tracking framework, J. of Computational Physics, 213, 141, 10.1016/j.jcp.2005.08.004
Popinet, 2009, An accurate adaptive solver for surface-tension-driven interfacial flows, J. of Computational Physics, 228, 5838, 10.1016/j.jcp.2009.04.042
Schrage, 1953
Brackbill, 1992, A continuum method for modeling surface tension, J. of Computational Physics, 100, 335, 10.1016/0021-9991(92)90240-Y
Morini, 2005, Viscous heating in liquid flows in micro-channels, Int. J. of Heat and Mass Transfer, 48, 3637, 10.1016/j.ijheatmasstransfer.2005.01.011
Carey, 1992
Marek, 2001, Analysis of the evaporation coefficient and the condensation coefficient of water, Int. J. of Heat and Mass Transfer, 44, 39, 10.1016/S0017-9310(00)00086-7
Rose, 1987, the condensation coefficient and dropwise condensation, Proceedings of the Royal Society of London A, 411, 305
Wang, 2007, Characteristics of evaporating thin film in a microchannel, Int. J. of Heat and Mass Transfer, 50, 3933, 10.1016/j.ijheatmasstransfer.2007.01.052
Hardt, 2008, Evaporation model for interfacial flows based on a continuum-field representation of the source terms, J. of Computational Physics, 227, 5871, 10.1016/j.jcp.2008.02.020
Youngs, 1982, Time-dependent multi-material flow with large fluid distortion, 273
Lafaurie, 1994, Modelling merging and fragmentation in multiphase flows with SURFER, J. of Computational Physics, 113, 134, 10.1006/jcph.1994.1123
Malik, 2007, Adaptive VOF with curvature-based refinement, Int. J. for Numerical Methods in Fluids, 55, 693, 10.1002/fld.1490
Hernandez, 2008, A new volume of fluid method in three dimensions-Part I: Multidimensional advection method with face-matched flux polyhedra, Int. J. for Numerical Methods in Fluids, 58, 897, 10.1002/fld.1776
van Leer, 1979, Towards the ultimate conservative difference scheme. V.A second-order sequel to Godunov’s method, J. of Computational Physics, 32, 101, 10.1016/0021-9991(79)90145-1
Fluent 6.3 User’s Guide, Fluent Inc., Lebanon, NH, 2006.
Gupta, 2009, On the CFD modelling of Taylor flow in microchannels, Chemical Engineering Science, 64, 2941, 10.1016/j.ces.2009.03.018
Issa, 1985, Solution of the implicitly discretized fluid flow equations by operator-splitting, J. of Computational Physics, 62, 40, 10.1016/0021-9991(86)90099-9
M. Magnini, B. Pulvirenti, Height function interface reconstruction algorithm for the simulation of boiling flows, in: A.A. Mammoli, C.A. Brebbia (Eds.), Computational Methods in Multiphase Flows VI, Wessex Institute of Technology, UK, 2011.
Plesset, 1954, The growth of vapor bubbles in superheated liquids, J. of Applied Physics, 25, 493, 10.1063/1.1721668
Scriven, 1959, On the dynamics of phase growth, Chemical Engineering Science, 10, 1, 10.1016/0009-2509(59)80019-1
Scardovelli, 1999, Direct numerical simulation of free-surface and interfacial flow, Annual Review of Fluid Mechanics, 31, 567, 10.1146/annurev.fluid.31.1.567
Harvie, 2006, An analysis of parasitic current generation in Volume Of Fluid simulations, Applied Mathematical Modelling, 30, 1056, 10.1016/j.apm.2005.08.015
Kreutzer, 2005, Inertial and interfacial effects on pressure drop of taylor flow in capillaries, A.I.Ch.E. Journal, 51, 2428, 10.1002/aic.10495
Aussillous, 2000, Quick deposition of a fluid on the wall of a tube, Physics of Fluids, 12, 2367, 10.1063/1.1289396
Liberzon, 2006, Upward-propagating capillary waves on the surface of short taylor bubbles, Physics of Fluids, 18, 10.1063/1.2192781
Patankar, 1980
Consolini, 2010, A heat transfer model for evaporation of coalescing bubbles in microchannel flow, Int. J. of Heat and Fluid Flow, 31, 115, 10.1016/j.ijheatfluidflow.2009.10.005
Gupta, 2010, CFD modelling of flow and heat transfer in the Taylor flow regime, Chemical Engineering Science, 65, 2094, 10.1016/j.ces.2009.12.008
Ozisik, 1993