Non-destructive microwave evaluation of plasma sprayed TBCs porosity

Chen, 2006, The growth and influence of thermally grown oxide in a thermal barrier coating, Surf Coat Technol, 201, 1074, 10.1016/j.surfcoat.2006.01.023 Cernuschi, 2008, Thermophysical, mechanical and microstructural characterization of aged free-standing plasma-sprayed zirconia coatings, Acta Mater, 56, 4477, 10.1016/j.actamat.2008.04.067 Paul, 2010, Assessing coating reliability through pore architecture evaluation, J Therm Spray Technol, 19, 779, 10.1007/s11666-010-9474-3 Curry, 2011, Next generation thermal barrier coatings for the gas turbine industry, J Therm Spray Technol, 20, 108, 10.1007/s11666-010-9593-x Teixeira, 2001, Numerical analysis of the influence of coating porosity and substrate elastic properties on the residual stresses in high temperature graded coatings, Surf Coat Technol, 146–147, 79, 10.1016/S0257-8972(01)01457-8 Bertrand, 2008, Low conductivity plasma sprayed thermal barrier coating using hollow psz spheres: Correlation between thermophysical properties and microstructure, Surf Coat Technol, 202, 1994, 10.1016/j.surfcoat.2007.08.042 Lu, 2001, Distributed porosity as a control parameter for oxide thermal barriers made by physical vapor deposition, J Am Ceram Soc, 84, 2937, 10.1111/j.1151-2916.2001.tb01118.x Markocsan, 2007, Low thermal conductivity coatings for gas turbine applications, J Therm Spray Technol, 16, 498, 10.1007/s11666-007-9068-x Saremi, 2008, Microstructural analysis of YSZ and YSZ/Al2O3 plasma sprayed thermal barrier coatings after high temperature oxidation, Surf Coat Technol, 202, 3233, 10.1016/j.surfcoat.2007.11.029 Furke, 1997, Characterization of Zr02-7wt% YsO3 thermal barrier coatings with different porosities and FEM analysis of stress redistribution during thermal cycling of TBCs, Surf Coat Technol, 94–95, 106 Portinha, 2005, Characterization of thermal barrier coatings with a gradient in porosity, Surf Coat Technol, 195, 245, 10.1016/j.surfcoat.2004.07.094 Zhang, 2005, Evaluation of thickness, porosity and pore shape of plasma sprayed TBC by electrochemical impedance spectroscopy, Surf Coat Technol, 190, 98, 10.1016/j.surfcoat.2004.06.019 Jayaraj, 2004, Electrochemical impedance spectroscopy of porous ZrO2–8wt% Y2O3 and thermally grown oxide on nickel aluminide, Mater Sci Eng, A, A372, 278, 10.1016/j.msea.2004.01.005 Yang, 2009, Nondestructive evaluation of thermal barrier coatings using impedance spectroscopy, Int J Appl Ceram Technol, 6, 381, 10.1111/j.1744-7402.2008.02304.x Rogé, 2003, Nondestructive measurement of porosity in thermal barrier coatings, J Therm Spray Technol, 12, 530, 10.1361/105996303772082279 Mauer, 2009, Characterization of plasma-sprayed Yttria-stabilized zirconia coatings by cathodoluminescence, J Therm Spray Technol, 18, 572, 10.1007/s11666-009-9370-x Fahr, 2002, Application of NJJE in aerospace coatings, Int Soc Opt Eng, 4702, 83 Kelly, 2008, Metallographic techniques for evaluation of thermal barrier coatings produced by electron beam physical vapor deposition, Mater Charact, 59, 863, 10.1016/j.matchar.2007.07.010 Ju, 1999, Microwave nondestructive detection of delamination in IC packages utilizing open-ended coaxial line sensor, NDT & E, 32, 259, 10.1016/S0963-8695(98)00055-3 Ju, 2001, Detection of delamination in IC packages using the phase of microwaves, NDT and E Int, 34, 49, 10.1016/S0963-8695(00)00044-X Abou-Khousa, 2007, Disbond thickness evaluation employing multiple-frequency near-field microwave measurements, IEEE Trans Instrum Meas, 56, 1107, 10.1109/TIM.2007.899848 Kharkovsky, 2008, Application of frustrated total internal reflection of millimeter waves for detection and evaluation of disbands in dielectric joints, Appl Phys Lett, 92, 10.1063/1.2890054 Kharkovsky, 2008, Application of frustrated total internal reflection of millimeter waves for detection and evaluation of disbonds in dielectric joints, Appl Phys Lett, 92, 10.1063/1.2890054 Ghasr, 2009, Multimodal solution for a waveguide radiating into multilayered structures-dielectric property and thickness evaluation, IEEE Trans Instrum Meas, 58, 1505, 10.1109/TIM.2008.2009133 Kerouedan, 2008, Detection of micro-cracks on metal surfaces using near-field microwave dual-behavior resonator filters, Meas Sci Technol, 19, 105701, 10.1088/0957-0233/19/10/105701 Zoughi, 2008, Microwave and millimetre wave sensors for crack detection, Fatigue Fract Eng Mater Struct, 31, 695, 10.1111/j.1460-2695.2008.01255.x Li, 2008, A microwave measurement system for metallic object detection using swept-frequency radar, Int Soc Opt Eng, 7117, 10.1201/9781420045710 Ju, 2009, Quantitative evaluation of wall thinning of metal pipes by microwaves, Mater Sci Forum, 614, 111, 10.4028/www.scientific.net/MSF.614.111 Grishin, 2002, Broad band microwave probe for nondestructive test of dielectric coatings, IEEE Int Symp Appl Ferroelectr, 91 Sezer, 2007, Non-destructive microwave evaluation of TBC delamination induced by acute angle laser drilling, Meas Sci Technol, 18, 167, 10.1088/0957-0233/18/1/021 Sayar, 2009, Non-destructive microwave detection of layer thickness in degraded thermal barrier coatings using K- and W-band frequency range, NDT and E Int, 42, 398, 10.1016/j.ndteint.2009.01.003 Edwards, 1993, Microwave sensitivity maximization of disbond characterization in conductor backed dielectric composites, J Nondestr Eval, 12, 193, 10.1007/BF00567087 Gerhardt, 1990, 189 Gao, 2002, Effective dielectric constant of a two-component material with shape distribution, J Phys D: Appl Phys, 35, 267, 10.1088/0022-3727/35/3/316