Minimization of Machining Allowance in Electrochemical Machining

Datta, 1981, Electrochemical Machining under Pulse Current Conditions, Electrochemical Acta, 26, 899, 10.1016/0013-4686(81)85053-0

Hia, X.M., Yu, C.Y. and Liu, Z.X., 1985, Studies on Anodic Behaviors Under Pulse ECM, Proc. of ISEM-8, CIRP: 93-100

Kozak, 1994, Modeling and Analysis of Pulse Electrochemical Machining, Trans. of the ASME, Vol, 116, 316

Kunieda, 1993, Influence of Microindents Formed by Electrochemical Jet Machining on Rolling Bearing Fatigue Life, Manufacturing Science and Engineering, ASME, 64, 693

Masuzawa, 1994, A combined Electrical Machining Process for Micronozzle fabrication, Annals of the CIRP, 43, 189, 10.1016/S0007-8506(07)62193-3

McGeough, 1974

Rajurkar, 1995, Modeling and Monitoring Interelectrode Gap in Pulse Electrochemical Machining, Annals of the CIRP, 44, 177, 10.1016/S0007-8506(07)62301-4

Rajurkar, 1993, Study of Pulse Electrochemical Machining Characteristics, Annals of the CIRP, 42, 231, 10.1016/S0007-8506(07)62432-9

Tonshoff, 1996, Environmental and Safety Aspects of Electrophysical and Electrochemical Processes, Annals of the CIRP, 45, 1, 10.1016/S0007-8506(07)60510-1

Watkins, 1992, Introduction to Environmentally Conscious Manufacturing, Inter. J. of Environmentally Conscious Manufacturing, 1, 5

Wei, 1994, Pulse Electrochemical Machining of Ti-6AI-4V Alloy, Trans. Of NAMRI/SME, Volume XXII, 141

Yu, 1982, The Investigation of the Flow Characteristics of the Gap in the Pulse Electrochemical Machining, Annals of the CIRP, 31, 119, 10.1016/S0007-8506(07)63281-8