Microstructure characterization of 7050 aluminum alloy during dynamic recrystallization and dynamic recovery

Williams, 2003, Progress in structural materials for aerospace systems, Acta Mater, 51, 5775, 10.1016/j.actamat.2003.08.023 Wloka, 2007, Influence of temper and surface condition on the exfoliation behaviour of high strength Al–Zn–Mg–Cu alloys, Corros Sci, 49, 1437, 10.1016/j.corsci.2006.06.033 Eschamps, 1998, Influence of quench and heating rates on the ageing response of an Al–Zn–Mg–(Zr) alloy, Mater Sci Eng A Struct Mater Prop Microstuct Process, 251, 200, 10.1016/S0921-5093(98)00615-7 Stiller, 1999, Investigation of precipitation in an Al–Zn–Mg alloy after two-step ageing treatment at 100° and 150 °C, Mater Sci Eng A Struct Mater Prop Microstuct Process, 270, 55, 10.1016/S0921-5093(99)00231-2 Han, 2007, Microstructural evolution of Fe–32%Ni alloy during large strain multi-axial forging, Mater Sci Eng A Struct Mater Prop Microstuct Process, 447, 119, 10.1016/j.msea.2006.10.010 Gourdet, 2000, An experimental study of the recrystallization mechanism during hot deformation of aluminium, Mater Sci Eng A Struct Mater Prop Microstuct Process, 283, 274, 10.1016/S0921-5093(00)00733-4 Liu, 1992, On deformation-induced continuous recrystallization in a superplastic Al–Li–Cu–Mg–Zr alloy, Acta Metall Mater, 40, 1753, 10.1016/0956-7151(92)90118-X Xun, 2004, EBSD characterization of 8090 Al–Li alloy during dynamic and static recrystallization, Mater Charact, 52, 87, 10.1016/j.matchar.2004.04.009 Xun, 2004, Grain boundary characterization in superplastic deformation of Al–Li alloy using electron backscatter diffraction, Mater Sci Technol, 20, 173, 10.1179/026708304225011216 Lu, 2003, Treatment of misorientation data to determine the fraction of recrystallized grains in a partially recrystallized metal, Mater Charact, 51, 293, 10.1016/j.matchar.2004.01.005 Cabibbo, 2005, EBSD FEG-SEM, TEM and XRD techniques applied to grain study of a commercially pure 1200 aluminum subjected to equal-channel angular-pressing, Micron, 36, 401, 10.1016/j.micron.2005.03.004 Kamaya, 2005, Measurement of plastic strain of polycrystalline material by electron backscatter diffraction, Nucl Eng Des, 235, 713, 10.1016/j.nucengdes.2004.11.006 Han, 2003, Orientation rotation behavior during in situ tensile deformation of polycrystalline 1050 aluminum alloy, Int J Mech Sci, 45, 1613, 10.1016/j.ijmecsci.2003.11.003 Gourdet, 2003, A model of continuous dynamic recrystallization, Acta Mater, 51, 2685, 10.1016/S1359-6454(03)00078-8 McQueen, 2004, Development of dynamic recrystallization theory, Mater Sci Eng A Struct Mater Prop Microstuct Process, 387–389, 203, 10.1016/j.msea.2004.01.064 Tsuzaki, 1996, Mechanism of dynamic continuous recrystallization during superplastic deformation in microduplex stainless steel, Acta Mater, 44, 4491, 10.1016/1359-6454(96)00080-8 Hirata, 2003, Experimental prediction of deformation mechanism after continuous dynamic recrystallization in superplastic P/M7475, J Mater Sci, 38, 3925, 10.1023/A:1026146112559 Sakuma, 1999, Summary in the project towards innovation in superplasticity, Mater Trans, 40, 702, 10.2320/matertrans1989.40.702