Microstructure and properties of C/C-CuNi composites fabricated by carbothermal reduction of hydrothermal co-deposited oxides

Wang, 2019, A new nonlinear displacement-dependent parametric model of a high-speed rail pantograph hydraulic damper, Veh. Syst. Dyn., 58, 272, 10.1080/00423114.2019.1578385 Wang, 2019, Microstructural feature and tribological behaviors of pyrolytic carbon-coated copper foam/carbon composite, J. Mater. Sci., 54, 13557, 10.1007/s10853-019-03857-2 Chater, 2015, Output feedback control of pantograph–catenary system with adaptive estimation of catenary parameters, J. Mod. Transport., 23, 252, 10.1007/s40534-015-0085-z Liu, 2012, Simulation of dynamic current collection between pantograph and catenary of elastic catenary suspension system, 489 Kubo, 1998, Effect of arc discharge on wear rate of Cu-impregnated carbon strip in unlubricated sliding against Cu trolley under electric current, Wear, 216, 172, 10.1016/S0043-1648(97)00184-1 Poljanec, 2018, Influence of contact parameters on the tribological behaviour of various graphite/graphite sliding electrical contacts, Wear, 406, 75, 10.1016/j.wear.2018.03.022 Derosa, 2020, A heuristic wear model for the contact strip and contact wire in pantograph–Catenary interaction for railway operations under 15 kV 16.67 Hz AC systems, Wear, 456 Wang, 2021, Microstructural, mechanical and tribological performances of carbon fiber reinforced copper/carbon composites, Compos. Part A, 142, 10.1016/j.compositesa.2020.106247 Deng, 2017, The tribological properties of Cf/Cu/C composites under applied electric current, Tribol. Int., 116, 84, 10.1016/j.triboint.2017.07.005 Grandin, 2018, Influence of mechanical and electrical load on a copper/copper-graphite sliding electrical contact, Tribol. Int., 121, 1, 10.1016/j.triboint.2018.01.004 Zhang, 2019, Effects of Ni-coated graphite flake on braking behavior of Cu-based brake pads applied in high-speed railway trains, J. Tribol., 141, 10.1115/1.4043714 Yao, 2016, Cu/C composites with a good combination of hardness and electrical conductivity fabricated from Cu and graphite by accumulative roll-bonding, Mater. Des., 110, 124, 10.1016/j.matdes.2016.07.129 Kou, 2017, Microstructure and flexural properties of C/C-Cu composites strengthened with in-situ grown carbon nanotubes, J. Alloys Compd., 694, 1054, 10.1016/j.jallcom.2016.10.151 Yin, 2017, Influence of applied load on wear behavior of C/C-Cu composites under electric current, Prog. Nat. Sci., 27, 192, 10.1016/j.pnsc.2017.03.004 Guellali, 2005, Influence of the matrix microstructure on the mechanical properties of CVI-infiltrated carbon fiber felts, Carbon, 43, 1954, 10.1016/j.carbon.2005.03.006 Cui, 2018, Novel copper-impregnated carbon strip for sliding contact materials, J. Alloys Compd., 735, 1846, 10.1016/j.jallcom.2017.11.311 Lee, 2007, Effect of alloying elements on the interfacial bonding strength and electric conductivity of carbon nano-fiber reinforced Cu matrix composites, Mater. Sci. Eng., 449–451, 778, 10.1016/j.msea.2006.02.377 Kubota, 2013, Sliding wear behavior of copper alloy impregnated C/C composites under an electrical current, Wear, 302, 1492, 10.1016/j.wear.2012.11.029 Xiao, 2017, Microstructure and properties of Cu-Ti alloy infiltrated chopped Cf reinforced ceramics composites, Ceram. Int., 43, 16628, 10.1016/j.ceramint.2017.09.053 Lei, 2020, High thermal conductivity and strong interface bonding of a hot-forged Cu/Ti-coated-diamond composite, Carbon, 168, 553, 10.1016/j.carbon.2020.07.001 Kong, 2016, Improved wetting and thermal properties of graphite-Cu composite by Cr-solution immersion method, Diamond Relat. Mater., 65, 191, 10.1016/j.diamond.2016.03.024 Kong, 2018, Enhanced wetting and properties of carbon/carbon-Cu composites with Cr3C2 coatings by Cr-solution immersion method, lJ, Mater. Sci. Technol., 34, 458, 10.1016/j.jmst.2017.01.028 Zuo, 2020, Simultaneous improvement of electrical conductivity and mechanical property of Cr doped Cu/CNTs composites, Mater. Today Commun., 23 Zhou, 2015, Preparation of a C/C–Cu composite with Mo2C coatings as a modification interlayer, Mater. Lett., 145, 264, 10.1016/j.matlet.2015.01.111 Chu, 2018, Interface and mechanical/thermal properties of graphene/copper composite with Mo2C nanoparticles grown on graphene, Compos. Part A, 109, 267, 10.1016/j.compositesa.2018.03.014 Liu, 2019, Microstructure and thermal properties of diamond/copper composites with Mo2C in-situ nano-coating, Surf. Coat. Technol., 360, 376, 10.1016/j.surfcoat.2018.12.116 Zhai, 2011, Porous graphitic carbons prepared by combining chemical activation with catalytic graphitization, Carbon, 49, 725, 10.1016/j.carbon.2010.09.057 Tang, 2013, Effect of transition metal on catalytic graphitization of ordered mesoporous carbon and Pt/metal oxide synergistic electrocatalytic performance, Microporous Mesoporous Mater., 177, 105, 10.1016/j.micromeso.2013.04.027 Ouyang, 2018, Microstructure and ablation properties of C/C-Zr-Si-O composites prepared by carbothermal reduction of hydrothermal co-deposited oxides, Mater. Des., 159, 145, 10.1016/j.matdes.2018.08.048 Logan, 1961, An AC bridge for semiconductor resistivity measurements using a four‐point probe, Bell Syst. Tech. J., 40, 885, 10.1002/j.1538-7305.1961.tb03245.x Meier, 1965, Application of the four-probe method for measuring the resistivity of nonuniform semiconductor materials, Meas. Tech., 8, 427, 10.1007/BF01001796 Guizani, 2017, New insights on the structural evolution of biomass char upon pyrolysis as revealed by the Raman spectroscopy and elemental analysis, Carbon, 119, 519, 10.1016/j.carbon.2017.04.078 Li, 2013, Microstructure and thermal conductivity of carbon/carbon composites containing zirconium carbide, J. Mater. Sci., 48, 7568, 10.1007/s10853-013-7572-6 Xue, 2018, Nanosized graphitic carbon with balanced micro/mesoporosity for robust supercapacitor with superior volumetric capacitance and cyclic performance, Electrochim. Acta, 271, 406, 10.1016/j.electacta.2018.03.172 Zhang, 2016, Lithium and sodium storage in highly ordered mesoporous nitrogen-doped carbons derived from honey, J. Power Sources, 335, 20, 10.1016/j.jpowsour.2016.08.096 Zhao, 2017, Voronoi-tessellated graphite produced by low-temperature catalytic graphitization from renewable resources, ChemSusChem, 10, 3409, 10.1002/cssc.201701211 Wang, 2018, Effect of pyrolytic carbon interface thickness on conductivity and mechanical and wear properties of copper mesh modified carbon/carbon composite, Mater. Des., 154, 302, 10.1016/j.matdes.2018.05.031