Microstructure and Mechanical Properties of Thermally sprayed silica/nylon nanocomposites
Tóm tắt
High-velocity oxyfuel thermal spray processing was used to produce ceramic/polymer (silica/nylon) nanocomposite coatings. By optimizing spray parameters such as nozzle design, spray distance, oxygen-to-fuel ratio, powder feed position, and substrate cooling, dense coatings with relatively uniform particulate distribution could be achieved. Compared to pure nylon coatings, scratch resistance improved by 30 % and wear resistance by 50 %. The surface chemistry of the silica filler affected the final coating properties. Silica particles with a hydrophobic (methylated) surface resulted in better mechanical properties than those with a hydrophilic (hydroxylated) surface.
Tài liệu tham khảo
M. Sumita, Y. Tsukumo, K. Miyasaka, and K.J. Ishikawa, Tensile Yield Stress of Polypropylene Composites Filled with Ultrafine Particles, J. Mater. Sci., Vol 18,1983, p 1758–1764
E.P. Giannelis, A New Strategy for Synthesizing Polymer-Ceramic Nanocomposites, JOM, Vol 44 (No. 3), 1992, p 28–30
T. Lan, P.D. Kaviratna, and T.J. Pinnavaia, On the Nature of Polyimide Clay Hybrid Composites, Chem. Mater., Vol 6 (No. 5), 1994, p 573–575
P.H.T. Vollenberg and D. Heikens, Particle Size Dependence of the Young’s Modulus of Filled Polymers, Part 1: Preliminary Experiments, Polymer, Vol 30, 1989, p 1656–1662
M. Sumita, Y. Tsukumo, K. Miyasaka, and K.J. Ishikawa, Effect of Re- ducible Properties of Temperature, Rate of Strain, and Filler Content on the Tensile Yield Stress of Nylon 6 Composites Filled with Ultrafine Particles, J. Macromol. Sci. Phys., Vol B-22 (No. 4), 1983, p 601–618
Y. Bao, D.T. Gawne, D. Vesely, and M.J. Bevis, Formation and Micro- structure of Plasma Sprayed Polyamide Coatings, Surf. Eng., Vol 10 (No. 4), 1994, p 307–313
R.W. Smith and R. Knight, Thermal Spraying, Part I: Powder Consoli- dation—From Coating to Forming, JOM, Vol 47(No. 8), 1995, p32–39
R.J. Young and P.A. Lovell, Introduction to Polymers, Chapman and Hall, London, 1991, p 195–198