Mechanics of fatigue crack growth in a bonding interface

Tolle, 1995, Mechanisms of ductile fracture in pure silver under high-triaxial stress state, Acta Mater, 43, 287, 10.1016/0956-7151(95)90284-8 Varias, 1991, Ductile Failure of a constrained metal foil, J Mech Phys Solids, 39, 963, 10.1016/0022-5096(91)90014-F He, 1996, Interface cracking phenomena in constrained metal layers, Acta Mater, 44, 2963, 10.1016/1359-6454(95)00384-3 Kassner, 1998, The mechanisms of ductile fracture in constrained thin silver films, Acta Mater, 46, 6445, 10.1016/S1359-6454(98)00299-7 Choi, 2001, Fracture of a ductile layer constrained by stiff substrates, Fatigue Fract Engng Mater. Struct, 23, 1, 10.1046/j.1460-2695.2001.00371.x Roy, 1995, Finite element simulation of ductile rupture in a constrained metal foil, Mater Sci Eng A, 191, 27, 10.1016/0921-5093(94)09645-7 Flom, 2009, Evaluation margins of safety in brazed joints, Weld J, 10, 31 Leinenbach, 2010, Fracture behavior and defect assessment of brazed martensitic stainless steel joints, Engng Fail Anal, 17, 672, 10.1016/j.engfailanal.2009.05.002 Başer, 2010, Fracture behavior of brazed soft martensitic stainless steel joints under cyclic loading, Mater Sci For, 636–637, 1490 Başer TA, Leinenbach C, Schindler HJ, Cyclic fracture behavior of brazed steel joints. In: Proc. 12th international conference on fracture (ICF12), Ottawa; 2009. Leinenbach C, Başer T, Schindler HJ. Fatigue crack growth and threshold behavior of high strength braze joints, in preparation. Schindler HJ. Analytisches Modell zur Berechnung der Rissausbreitungsgeschwindigkeit unter Ermüdungsbeanspruchung, In: Berichtsband der 30. Tagung des DVM-AK Bruchvorgänge; 1998. p. 333–42. Newman, 1981, A crack closure model for predicting crack growth under aircraft spectrum loading, 53 McClung, 1991, The influence of applied stress, crack-length and stress intensity factor on crack closure, Metall Trans A, 22A, 1559, 10.1007/BF02667369 Forth SC, James MA, Johnston WM, Newman Jr. JC. Anomolous fatigue crack growth phenomena in high-strength steel, In: Proc. int. conf. on fracture, vol. 11, Turin (I), Paper No. 4824; 2005. Azari, 2010, The effect of mode ratio and bond interface on the fatigue behavior of a highly-toughened epoxy, Engng Fract Mech, 77, 395, 10.1016/j.engfracmech.2009.09.011 Paris, 1961, A rational analytic theory of fatigue, Trend Engng, 13, 9 Schwalbe, 2010, On the beauty of analytical models for fatigue propagation and fracture, vol. 37, 3 Wu, 1992, A model of fatigue crack growth based on Dugdale model and damage accumulation, Int J Fract, 57, 253, 10.1007/BF00035077 Schindler, 2000, On the significance of crack tip shielding in fatigue threshold – theoretical relations and experimental implications, 46 Hertzberg, 1995, On the calculation of closure-free fatigue crack propagation data in monolithic metal alloys, Mater Sci Engng A, 190, 25, 10.1016/0921-5093(94)09610-9 Hertzberg, 1993, A simple calculation of da/dN-DK data in the near threshold regime and above, Int J Fract, 64, R53, 10.1007/BF00015777 Riemelmoser, 2000, Fatigue crack growth thresholds, endurance limits, and design, 252