Mechanical and Biomechanical Characterization of a Polyurethane Nucleus Replacement Device Injected and Cured In Situ Within a Balloon

Luoma, 2000, Low back pain in relation to lumbar disc degeneration, Spine, 25, 487, 10.1097/00007632-200002150-00016 Bruck, 1982, Medical applications of polymeric materials, Med Prog Technol, 9, 1 Mandarino, 1958, Polyurethane polymer (ostamer): its use in fractured and diseased bones; experimental results, Surg Forum, 9, 762 Stoll, 2002, The dynamic neutralization system for the spine: a multi-center study of a novel non-fusion system, Eur Spine J, 11, S170, 10.1007/s00586-002-0438-2 Wilke, 2006, Biomechanical evaluation of a new total posterior-element replacement system, Spine, 31, 2790, 10.1097/01.brs.0000245872.45554.c0 Anderson, 2003, Wear analysis of the Bryan Cervical Disc prosthesis, Spine, 28, S186, 10.1097/01.BRS.0000092212.42388.79 Korge, 2002, A spiral implant as nucleus prosthesis in the lumbar spine, Eur Spine J, 11, S149, 10.1007/s00586-002-0444-4 Ahrens M, Donkersloot P, Martens F, et al. Nucleus replacement with the DASCORTM Disc Arthroplasty System: Two year follow up results obtained from two prospective European multi-center clinical studies. Paper presented at: Spine Arthroplasty Society; May 1-4, 2007; Berlin, Germany. Beer, 1992 Callaghan, 1999, Low back three-dimensional joint forces, kinematics, and kinetics during walking, Clin Biomech, 14, 203, 10.1016/S0268-0033(98)00069-2 Nachemson, 1970, Intravital dynamic pressure measurements in lumbar discs. A study of common movements, maneuvers and exercises, Scand J Rehabil Med, 1S, 1 Syczewska, 1999, Segmental movements of the spine during treadmill walking with normal speed, Clin Biomech, 14, 384, 10.1016/S0268-0033(99)00003-0 Panjabi, 1992, The stabilizing system of the spine. Part II. Neutral zone and instability hypothesis, J Spinal Disord, 5, 390, 10.1097/00002517-199212000-00002 Meakin, 2001, Replacing the nucleus pulposus of the intervertebral disk: prediction of suitable properties of a replacement material using finite element analysis, J Mater Sci, 12, 207 Meakin, 2001, Replacing the nucleus pulposus of the intervertebral disc, Clin Biomech, 16, 560, 10.1016/S0268-0033(01)00042-0 Seroussi, 1989, Internal deformations of intact and denucleated human lumbar discs subjected to compression, flexion, and extension loads, J Orthop Res, 7, 122, 10.1002/jor.1100070117 Tsantrizos, 2005, Internal strains in healthy and degenerated lumbar intervertebral discs, Spine, 30, 2129, 10.1097/01.brs.0000181052.56604.30 Farfan, 1972, Lumbar intervertebral disc degeneration: the influence of geometrical features on the pattern of disc degeneration--a post mortem study, J Bone Joint Surg, 54A, 492, 10.2106/00004623-197254030-00004 Adams, 1996, ‘Stress’ distributions inside intervertebral discs. The effects of age and degeneration, J Bone Joint Surg, 78B, 965, 10.1302/0301-620X78B6.1287 Cook S, Salkeld S, Rogozinski A, Rogozinski C, Bailey K. Partial disc replacement in the baboon lumbar spine. Paper presented at: Spine Arthroplasty Society; May 9-13, 2006; Montreal, Quebec, Canada. Fernstrom, 1966, Arthroplasty with intercorporal endoprothesis in herniated disc and in painful disc, Acta Chir Scand Suppl, 357, S154 Bao, 2007, NUBACTM Intradiscal Arthroplasty: Preclinical studies, and preliminary safety and efficacy evaluations, SAS J, 1, 36, 10.1016/S1935-9810(07)70045-2 Roberts, 1997, Does the thickness of the vertebral subchondral bone reflect the composition of the intervertebral disc?, Eur Spine J, 6, 385, 10.1007/BF01834064 Wolff, 1892, Das gesetz der tranformation der knochen, Berlin Hirschwald Hansson, 1980, The bone mineral content and ultimate compressive strength of lumbar vertebrae, Spine, 5, 46, 10.1097/00007632-198001000-00009 Crock, 1986, Internal disc disruption. A challenge to disc prolapse fifty years on, Spine, 11, 650, 10.1097/00007632-198607000-00028 Schoenmayer R. Ten year follow-up of disc height, range of motion and clinical outcomes with 1st generation PDN device. Paper presented at: Spine Arthroplasty Society; May 9-13, 2006; Montreal, Quebec, Canada. Genaidy, 1993, Spinal compression tolerance limits for the design of manual material handling operations in the workplace, Ergonomics, 36, 415, 10.1080/00140139308967899 Cripton P, Berleman H, Visarius H, Begeman PC, Nolte LP, Prasad P. Response of the lumbar spine due to shear loads. Paper presented at: Symposium: Injury prevention through biomechanics, 1995; Wayne State University, Detroit MI. Nachemson, 1965, The effect of forward leaning on lumbar intradiscal pressure, Acta Orthop Scand, 35, 314, 10.3109/17453676508989362 Nachemson, 1965, In vivo discometry in lumbar discs with irregular nucleograms. Some differences in stress distribution between normal and moderately degenerated discs, Acta Orthop Scand, 36, 418, 10.3109/17453676508988651 Nachemson, 1964, In vivo measurements of intradiscal pressure, J Bone Joint Surg, 46A, 1077, 10.2106/00004623-196446050-00012 Bertagnoli, 2006, Chapter 16 - NeuDisc, 122 Dumbleton, 2002, A literature review of the association between wear rate and osteolysis in total hip arthroplasty, J Arthroplasty, 17, 649, 10.1054/arth.2002.33664 Cunningham B, Hu N, Beatson HJ, McAfee P, Yuan HA. An investigational study of nucleus pulposus replacement using an in-situ curable polyurethane. An in vivo non-human primate model. Paper presented at: Spine Arthroplasty Society; May 1-4, 2007; Berlin, Germany. Mabrey, 2002, Standardized analysis of UHMWPE wear particles from failed total joint arthroplasties, J Biomed Mater Res, 63, 475, 10.1002/jbm.10302 Lacy S, Johnson C, Long PH, et al. A Rabbit Model to Evaluate the Biological Response to DASCOR™ Device Wear Debris. Paper presented at: Spine Arthroplasty Society; May 1-4, 2007; Berlin, Germany.