Mass and heat transfer behavior of a rotating disc with parallel rectangular grooves

Sasaki, 1986, Stacked rotating bipolar electrode cell for recovery of copper from dilute cupric sulfate solution, Electrochim. Acta, 31, 745, 10.1016/0013-4686(86)85002-2 Meeuwse, 2012, Multistage rotor-stator spinning disc reactor, AIChE J., 58, 247, 10.1002/aic.12586 Glatzer, 2001, Triphase catalysis: a correlation for Sherwood number using the rotating disk contactor (RDC) developed earlier, Chem. Eng. Sci., 56, 3815, 10.1016/S0009-2509(01)00100-2 Cavalcanti, 1999, Mass transfer between a liquid and an array of discs in a cylinder container part I: pumped flow or rotation alone, J. Appl. Electrochem., 29, 1383, 10.1023/A:1003864903910 Cavalcanti, 2000, Mass transfer between a liquid and an array of discs in a cylinder container part II: combined pumped flow and rotation, J. Appl. Electrochem., 30, 303, 10.1023/A:1003839015241 Pletcher, 1990 Alemany, 2002, Cementation and corrosion at a rotating disc electrode: changes in flow and transfer phenomena induced by surface roughness, J. Appl. Electrochem., 32, 1269, 10.1023/A:1021642327507 Gros, 2011, Copper cementation on zinc and iron mixtures: part I: results on rotating disc electrode, Hydrometallurgy, 106, 127, 10.1016/j.hydromet.2010.12.011 Dib, 2007, Mass transfer correlations of simultaneous removal by cementation of nickel, cobalt from sulfate industrial solution containing copper, part I: onto rotating zinc electrode disc, Chem. Eng. J., 130, 39, 10.1016/j.cej.2006.10.026 Pham, 2005, Improvement of cementation process by ultrasound: case of the cadmium–zinc couple at a rotating disc electrode, J. Appl. Electrochem., 35, 249, 10.1007/s10800-004-6705-7 Lin, 2012, A high-efficient rotating disk photoelectrocatalytic (PEC) reactor with macro light harvesting pyramid-surface electrode, AIChE J., 58, 2448, 10.1002/aic.12755 Jaffrin, 2008, Dynamic shear-enhanced membrane filtration: a review of rotating disks, rotating membranes and vibrating systems, J. Membr. Sci., 324, 7, 10.1016/j.memsci.2008.06.050 Jaffrin, 2004, A hydrodynamic comparison between rotating disk and vibrating dynamic filtration systems, J. Membr. Sci., 242, 155, 10.1016/j.memsci.2003.07.029 Sedahmed, 2000, Liquid-solid mass transfer behaviour of rotating screen discs, Chem. Eng. J., 76, 247, 10.1016/S1385-8947(99)00172-2 Ibl, 1983, vol. 6 Sedahmed, 1979, Mass transfer at rotating finned cylinders, J. Appl. Electrochem., 9, 563, 10.1007/BF00610942 Andersen, 1989, The effect of suspended solids on mass transfer to rotating disk, J. Electrochem. Soc., 136, 890, 10.1149/1.2096642 Kwon, 1989, A theoretical and experimental study on the enhancement of the rate of mass transfer by the addition of suspended inert particles, Int. Chem. Eng., 29, 555 Sonneveld, 1990, The influence of suspended particles on the mass transfer at a rotating disc electrode, J. Appl. Electrochem., 20, 563, 10.1007/BF01008865 Sara, 2011, Effect of suspended CuO nanoparticles on mass transfer to a rotating disc electrode, Exp. Therm. Fluid Sci., 35, 558, 10.1016/j.expthermflusci.2010.12.011 Selman, 1978, Mass transfer measurement by the limiting current technique, Adv. Chem. Eng., 10, 211, 10.1016/S0065-2377(08)60134-9 Shevchuk, 2009 Findlay, 1937 Abdel-Aziz, 2014, Mass and heat transfer behavior of a rough vertical vibrating cylinder in relation to annular electrochemical and catalytic reactor design, Int. J. Heat Mass Transf., 72, 595, 10.1016/j.ijheatmasstransfer.2014.01.026 Zhao, 1997, Electrochemical mass transfer measurements in rough surface pipe flow: geometrically similar V shaped grooves, Int. J. Heat Mass Transf., 40, 2785, 10.1016/S0017-9310(96)00346-8 Tantirige, 1984, Mass transfer and geometrically dissimilar rough surfaces, Can. J. Chem. Eng., 62, 490, 10.1002/cjce.5450620407 Gabe, 1987, Enhanced mass transfer using roughened rotating cylinder electrodes in turbulent flow, J. Appl. Electrochem., 17, 370, 10.1007/BF01023303 Walsh, 1993, A first course in electrochemical engineering Fahidy, 1985 Langlosis, 1989, Mass transfer to percolated porous material in a small scale cell operating by self-pumping, J. Appl. Electrochem., 19, 736, 10.1007/BF01320649 Lehmkuhl, 1971, Flow and mass transfer near an enclosed rotating disk: experiment, Chem. Eng. Sci., 26, 1601, 10.1016/0009-2509(71)86050-5 Molki, 1989, Turbulent heat transfer in rectangular ducts with repeated-baffle blockage, Int. J. Heat Mass Transfer, 32, 1491, 10.1016/0017-9310(89)90071-9 Stynes, 1964, Transport from extended surfaces, AIChE J., 10, 437, 10.1002/aic.690100406 Townes, 1966, Sabersky, experiments on the flow over a rough surface, Int. J. Heat Mass Transfer, 9, 729, 10.1016/0017-9310(66)90002-0 Jarrett, 1967, Mass transfer in rectangular cavities, AIChE J., 13, 797, 10.1002/aic.690130438 Focke, 1983, On the mechanism of transfer enhancement by eddy promoters, Electrochim. Acta, 28, 1137, 10.1016/0013-4686(83)80019-X Levich, 1962 Calderbank, 1961, The continuous phase heat and mass transfer properties of dispersions, Chem. Eng. Sci., 16, 39, 10.1016/0009-2509(61)87005-X Riddiford, 1966, The rotating disk system, Adv. Electrochem. Electrochem, 4, 47 Cornet, 1969, Effect of surface roughness on mass transfer to a rotating disk, Trans. Inst. Chem. Eng., 47, T 222