Low velocity impact response of carbon fiber laminates fabricated by pulsed infusion: A review of damage investigation and semi-empirical models validation

Lopresto, 2013, A new damage index for the indentation depth evaluation of composites under low velocity impact loads, Polym. Compos., 34/12, 2061, 10.1002/pc.22614 F.K. Chang, H.Y. Choi, H.S. Wang, Damage of laminated composites due to low velocity impact, in: Proceedings of the 31st AIAA/ASME/ASCE/AHS/ASC Structural Dynamics and Materials Conference, Long Beach, CA, April 2–4, 1990, pp. 930–940. Stout, 1999, Damage development in carbon/epoxy laminates under quasi-static and dynamic loading, Compos. Sci. Technol., 59, 2339, 10.1016/S0266-3538(99)00089-5 Azouaoui, 2001, Modelling of damage and failure of glass/epoxy composite plates subject to impact fatigue, Int. J. Fatigue, 23, 877, 10.1016/S0142-1123(01)00050-0 Lopresto, 2013, Damage mechanisms and energy absorption in composite laminates under low velocity impact loads, 192, 675 Zhang, 1998, Impact damage in composite aircraft structures-experimental testing and numerical simulation, Proc. Inst. Mech. Eng., 212, 245, 10.1243/0954410981532414 Davies, 1994, Numerical modelling of impact damage, Composites, 25, 342, 10.1016/S0010-4361(94)80004-9 Ricciardi, 2014, A new cost-saving vacuum infusion process for fiber-reinforced composites: pulsed infusion, J. Compos. Mater., 48, 1365, 10.1177/0021998313485998 Busse, 1979, Optoacoustic phase angle measurement for probing a metal, Appl. Phys. Lett., 35, 759, 10.1063/1.90960 Toscano, 2013, On the use of lockin thermography to monitor delamination growth in composite panels under compression, Sci. Eng. Compos. Mater., 21, 485, 10.1515/secm-2013-0156 Dillenz, 2003, Progress in phase angle thermography, Rev. Sci. Instrum., 74, 417, 10.1063/1.1524010 Riccio, 2013, Delaminations buckling and growth phenomena in stiffened composite panels under compression. Part I: An experimental study, J. Compos. Mater., 48, 2843, 10.1177/0021998313502741 Riccio, 2013, Delaminations buckling and growth phenomena in stiffened composite panels under compression. Part II: A numerical study, J. Compos. Mater., 48, 2857, 10.1177/0021998313502742 Farge, 2008, Optically measured full-field displacements on the edge of a cracked composite laminate, Composites A, 39, 1245, 10.1016/j.compositesa.2007.11.010 Ferraro, 1994, On the holographic detection of core-to-skin disbonds in composite sandwich structures, Mater. Eval., 52, 1376 P. Ferraro, Evaluation by holographic interferometry of impact damage in composite aeronautical structures, in: Proceedings of the Meeting SPIE Laser interferometry IV: Computer-Aided Interferometry, San Diego, CA, Vol. 1553, July 22–24, 1991 (A93-44185 18-35), pp. 349–357. V. Pagliarulo, R. Palummo, A. Rocco, P. Ferraro, M.R. Ricciardi, V. Antonucci, Evaluation of delaminated area of polymer/carbon nanotubes fiber reinforced composites after flexural tests by ESPI, in: IEEE MAS Proceedings, 6865922, 2014, pp. 211–215. Caprino, 1999, Influence of material thickness on the response of graphite fabric/epoxy panels to low velocity impact, Compos. Sci. Technol., 59/15, 2279, 10.1016/S0266-3538(99)00079-2 Caprino, 2003, Indentation and penetration of carbon fibre reinforced plastic laminates, Composites B, 34, 319, 10.1016/S1359-8368(03)00002-7 Lopresto, 2013, A new damage index for the indentation depth evaluation of composites under low velocity impact loads, Polym. Compos., 34/12, 2061, 10.1002/pc.22614 Lopresto, 2015, A damage index of indentation sensitivity in low velocity impact conditions, Polym. Compos., 36, 987, 10.1002/pc.23425 Caprino, 2001, On the penetration energy of fibre reinforced plastics under low-velocity impact conditions, Compos. Sci. Technol., 61/1, 65, 10.1016/S0266-3538(00)00152-4 G. Caprino, E.V. Lopresto, Macroscopic behaviour and fracture modes of CFRP panels transversely loaded at the centre, in: Proceedings of ECCM11, Rodi, Greece, 31 May–3 June, 2004. Riccio, 2013, A global–local numerical model for the prediction of impact induced damage in composite laminates, Appl. Compos. Mater., 21, 457, 10.1007/s10443-013-9343-6 Jackson, 1993, The use of impact force as a scale parameter for the impact response of composite laminates, J. Compos. Technol. Res., 15, 282, 10.1520/CTR10380J Lagace, 1993, A preliminary proposition for a test method to measure (impact) damage resistance, J. Reinf. Plast. Compos., 12, 584, 10.1177/073168449301200508 Poe, 1991, Relevance of impactor shape to non-visible damage and residual tensile strength of a thick graphite/epoxy laminate, Vol. 3, 501 Davies, 1994, Numerical modeling of impact damage, Composites, 25, 342, 10.1016/S0010-4361(94)80004-9 Davies, 1995, Impact damage prediction in carbon composite structures, Int. J. Impact Eng., 16, 149, 10.1016/0734-743X(94)00039-Y Putić, 2007, The influence of high and low temperatures on the impact properties of glass–epoxy composites, J. Serb. Chem. Soc., 72, 713, 10.2298/JSC0707713P