Low cost metal matrix composites based on aluminum, magnesium and copper reinforced with fly ash prepared using friction stir processing

Bahrami, 2016, Development of metal-matrix composites from industrial/agricultural waste materials and their derivatives, Crit. Rev. Environ. Sci. Technol., 46, 143 207, 10.1080/10643389.2015.1077067

Rajan, 2007, Fabrication and characterisation of Al–7Si–0.35Mg/fly ash metal matrix composites processed by different stir casting routes, Compos. Sci. Technol., 67, 3369, 10.1016/j.compscitech.2007.03.028

Yu, 2014, Dry sliding wear behavior of fly ash cenosphere/AZ91D Mg alloy composites, J. Mater. Eng. Perform., 23, 3480, 10.1007/s11665-014-1157-7

Balamurugan, 2015, Influence of process parameters on Cu–Fly ash composite by powder metallurgy technique, Mater. Manuf. Process., 30, 313, 10.1080/10426914.2014.984220

Arora, 2012, Composite fabrication using friction stir processing – a review, Int. J. Adv. Manuf. Technol., 61, 1043, 10.1007/s00170-011-3758-8

Sharma, 2015, Surface composites by friction stir processing: a review, J. Mater. Process. Technol., 224, 117, 10.1016/j.jmatprotec.2015.04.019

Ratna Sunil, 2016, Magnesium based surface metal matrix composites by friction stir processing, J. Magnes. Alloy., 4, 52, 10.1016/j.jma.2016.02.001

Sarmadi, 2013, Friction and wear performance of copper–graphite surface composites fabricated by friction stir processing (FSP), Wear, 304, 1, 10.1016/j.wear.2013.04.023

Kahrizsangi, 2015, Effect of friction stir processing on the tribological performance of Steel/Al2O3 nanocomposites, Surf. Coat. Technol., 276, 507, 10.1016/j.surfcoat.2015.06.023

Shamsipur, 2011, The effects of friction-stir process parameters on the fabrication of Ti/SiC nano-composite surface layer, Surf. Coat. Technol., 206, 1372, 10.1016/j.surfcoat.2011.08.065

Dinaharan, 2016, Microstructure and wear characterization of aluminum matrix composites reinforced with industrial waste fly ash particulates synthesized by friction stir processing, Mater. Charact., 118, 149, 10.1016/j.matchar.2016.05.017

Sathiskumar, 2013, Characterization of boron carbide particulate reinforced in situ copper surface composites synthesized using friction stir processing, Mater. Charact., 84, 16, 10.1016/j.matchar.2013.07.001

Fènoël, 2016, A review about friction stir welding of metal matrix composites, Mater. Charact., 120, 1, 10.1016/j.matchar.2016.07.010

Zhang, 2008, Contribution of Orowan strengthening effect in particulate reinforced metal matrix nanocomposites, Mater. Sci. Eng. A, 483–484, 148, 10.1016/j.msea.2006.10.184