Local Deformation and Failure Mechanisms of Polymer Bonded Energetic Materials Subjected to High Strain Rate Loading

Journal of Dynamic Behavior of Materials - Tập 2 Số 1 - Trang 146-156 - 2016
Suraj Ravindran1, Addis Tessema1, Addis Kidane1
1Department of Mechanical Engineering, University of South Carolina, 300 Main Street, Columbia, SC, 29208, USA

Tóm tắt

Từ khóa


Tài liệu tham khảo

Roessig KM (2002) Mesoscale mechanics of plastic bonded explosives. In: AIP Conference Proceedings IOP Institute of Physics Publishing Ltd, pp 973–978

Peterson PD, Mortensen KS, Idar DJ et al (2001) Strain field formation in plastic bonded explosives under compressional punch loading. J Mater Sci 36:1395–1400

Zhou Z, Chen P, Duan Z, Huang F (2012) Study on fracture behaviour of a polymer-bonded explosive simulant subjected to uniaxial compression using digital image correlation method. Strain 48:326–332

Prentice HJ, Proud WG, Walley SM, Field JE (2010) The use of digital speckle radiography to study the ballistic deformation of a polymer bonded sugar (an explosive simulant). Int J Impact Eng 37:1113–1120

Siviour CR, Grantham SG, Williamson DM et al (2009) Novel measurements of material properties at high rates of strain using speckle metrology. Imaging Sci J 57:326–332

Siviour CR, Grantham SG (2009) High resolution optical measurements of specimen deformation in the split Hopkinson pressure bar. Imaging Sci J 57:333–343

Grantham SG, Siviour CR, Proud WG, Field JE (2004) High-strain rate Brazilian testing of an explosive simulant using speckle metrology. Meas Sci Technol 15:1867

Siviour C, Laity P, Proud W et al (2008) High strain rate properties of a polymer-bonded sugar: their dependence on applied and internal constraints. Proc R Soc A Math Phys Eng Sci 464:1229–1255. doi: 10.1098/rspa.2007.0214

Balzer JE, Siviour CR, Walley SM et al (2004) Behaviour of ammonium perchlorate-based propellants and a polymer-bonded explosive under impact loading. Proc R Soc A Math Phys Eng Sci 460:781–806. doi: 10.1098/rspa.2003.1188

Drodge DR, Williamson DM (2016) Understanding damage in polymer-bonded explosive composites. J Mater Sci 51:668–679

Rae PJ, Palmer SJP, Goldrein HT et al (2002) Quasi-static studies of the deformation and failure of PBX 9501. Proc R Soc A Math Phys Eng Sci 458:2227–2242. doi: 10.1098/rspa.2002.0967

Ravindran S, Kidane A (2016) Meso-Scale Deformation behavior of polymer bonded energetic material under quasi-static compression. In: Mech. Compos. Multi-functional mater, vol 7. Springer, Berlin, pp 345–350

Koohbor B, Ravindran S, Kidane A (2015) Meso-scale strain localization and failure response of an orthotropic woven glass–fiber reinforced composite. Compos Part B Eng 78:308–318

Ravindran S, Koohbor B, Kidane A (2015) On the meso-macro scale deformation of low carbon steel. In: Adv. Opt. Methods Exp. Mech, vol 3. Springer, Berlin, pp 409–414

Sutton MA, Li N, Joy DC et al (2007) Scanning electron microscopy for quantitative small and large deformation measurements part I: SEM imaging at magnifications from 200 to 10,000. Exp Mech 47:775–787

Kammers AD, Daly S (2013) Digital image correlation under scanning electron microscopy: methodology and validation. Exp Mech 53:1743–1761

Zhou Z, Chen P, Huang F, Liu S (2011) Experimental study on the micromechanical behavior of a PBX simulant using SEM and digital image correlation method. Opt Lasers Eng 49:366–370

Ravindran S, Tessema A, Kidane A (2015) Note: dynamic meso-scale full field surface deformation measurement of heterogeneous materials. Rev Sci Instrum. Under review

Ravindran S, Tessema A, Kidane A, Sutton MA (2016) Meso-scale deformation mechanisms of polymer bonded energetic materials under dynamic loading. In: Mech. Compos. Multi-functional Mater, vol 7. Springer, Berlin, pp 451–456

Liu C (2005) On the minimum size of representative volume element: an experimental investigation. Exp Mech 45:238–243

Asadi M (2006) Beet-sugar handbook. Wiley, Hoboken

Gray III GT, Blumenthal WR, Idar DJ, Cady CM (1998) Influence of temperature on the high-strain-rate mechanical behavior of PBX 9501. In: Tenth Am. Phys. Soc. Top. Conf. shock compression condens. matter. AIP Publishing, pp 583–586

Zhao H, Gary G, Klepaczko JR (1997) On the use of a viscoelastic split hopkinson pressure bar. Int J Impact Eng 19:319–330. doi: 10.1016/S0734-743X(96)00038-3

Sutton MA, Orteu JJ, Schreier H (2009) Image correlation for shape, motion and deformation measurements: basic concepts, theory and applications. Springer Science & Business Media, New York

Mallon S, Koohbor B, Kidane A, Sutton MA (2014) Fracture behavior of prestressed composites subjected to shock loading: a DIC-based study. Exp Mech 55:211–225

Koohbor B, Mallon S, Kidane A, Sutton MA (2014) A DIC-based study of in-plane mechanical response and fracture of orthotropic carbon fiber reinforced composite. Compos Part B Eng 66:388–399

Herbold EB, Nesterenko VF, Benson DJ et al (2008) Particle size effect on strength, failure, and shock behavior in polytetrafluoroethylene-Al-W granular composite materials. J Appl Phys 104:103903

Barua A, Horie Y, Zhou M (2012) Microstructural level response of HMX–Estane polymer-bonded explosive under effects of transient stress waves. In: Proceedings of the Royal Society London A Mathematical, Physical and Engineering Science. The Royal Society, pp 3725–3744

Hu Z, Luo H, Bardenhagen S et al (2015) Internal deformation measurement of polymer bonded sugar in compression by digital volume correlation of tomography. Exp Mech 1:289–300

Tordesillas A, Muthuswamy M, Walsh SD (2008) Mesoscale measures of nonaffine deformation in dense granular assemblies. J Eng Mech 134:1095–1113

Kuhn MR, Bagi K (2004) Contact rolling and deformation in granular media. Int J Solids Struct 41:5793–5820