Investigation of micro-injection moulding: Factors affecting the replication quality

Weber, 1999, Micromoulding-market position and development, Kunststoffe, 89, 192 Yao, 2004, Scaling issues in miniaturization of injection molded parts, Manuf. Sci. Eng., 126, 733, 10.1115/1.1813479 Mönkkönen, 2002, Replication of sub-micron features using amorphous thermoplastics, Polym. Eng. Sci., 42, 1600, 10.1002/pen.11055 Zhao, 2003, Effects of process parameters on the micro molding process, Polym. Eng. Sci., 43, 1542, 10.1002/pen.10130 Yoshii, 1994, Experimental study of transcription of minute width grooves in injection molding, Polym. Eng. Sci., 34, 1211, 10.1002/pen.760341507 Wimberger-Friedl, 2001, Injection molding of sub-μm grating optical elements, 149 Yu, 2004, Flow and heat transfer simulation of injection molding with microstructures, Polym. Eng. Sci., 44, 1866, 10.1002/pen.20188 Arlø, 2001, Transcription of small surface structures in injection molding—an experimental study, 143 Shen, 2002, Three-dimensional non-newtonian computations of micro-injection molding with the finite element method, Int. Commun. Heat Mass Transfer, 29, 643, 10.1016/S0735-1933(02)00383-4 Spennemann, 2001, Process analysis and injection molding of microstructures, 157 Yu, 2002, Experiment investigation and numerical simulation of injection molding with micro-features, Polym. Eng. Sci., 42, 871, 10.1002/pen.10998 Shen, 2002, An analysis of the three-dimensional micro-injection molding, Int. Commun. Heat Mass Transfer, 29, 423, 10.1016/S0735-1933(02)00331-7 Su, 2004, Implementation and analysis of polymeric microstructure replication by micro injection molding, J. Micromech. Microeng., 14, 415, 10.1088/0960-1317/14/3/015 Yao, 2002, Increasing flow length in thin wall injection molding using a rapidly heated mold, Polym.-Plast. Technol. Eng., 41, 819, 10.1081/PPT-120014390 Saito, 2002, A new concept of active temperature control for an injection molding process using infrared radiation heating, Polym. Eng. Sci., 42, 2418, 10.1002/pen.11128 Madou, 2002 Varadan, 2001 B. Sha, S.S. Dimov, C.A. Griffiths, M.S. Packianather, Micro-injection moulding: factors affecting the achievable aspect ratios, Int. J. Adv. Manuf. Technol., (published online 9 May 2006). B. Sha, S.S. Dimov, D.T. Pham, C.A. Griffiths, Study of factors affecting aspect ratios achievable in micro-injection moulding, in: W. Menz, S. Dimov (Eds.), Proceedings of the International Conference on Multi-Material Micro Manufacture (4M), Karlsruhe, Germany, June 29–July 1, 2005, pp. 107–110. Belofsky, 1995