Influence of panel fastening on the acoustic performance of light-weight building elements: Study by sound transmission and laser scanning vibrometry

Warnock, 1997, Sound insulation: airborne and impact, Vol. 3, 1129 Hopkins, 2007 Novak, 1992, Sound insulation of lightweight double walls, Applied Acoustics, 37, 281, 10.1016/0003-682X(92)90016-L J. Nurzynski, Sound insulation of lightweight plasterboard walls, Proceedings 17th International Congress on Acoustics, Rome, 2001. H. Muellner, I. Plotizin, How ‘secondary’ details of the construction and workmanship effect the airborne sound insulation of plasterboard walls. Proceedings of Internoise, The Hague, The Netherlands, 27–30 August, 2001, pp. 1133–1136. H. Muellner, I. Plotizin, Beeinträchtigung des Schallschutzes von Gipskartonständerwänden durch “sekundäre” Wanddetails und Verarbeitungsqualität (Influence on the airborne sound insulation properties of gypsum plasterboard walls due to minor construction details and workmanship), Proceedings DAGA, Bochum, 2002. H. Muellner, I. Plotizin, The influence of the screw position on the airborne sound insulation of plasterboard walls, Proceedings Forum-Acusticum, Seville, 2002. B. Rasmussen, E. Gerretsen, Proposal for an acoustic classification scheme for housing, in: B. Rasmussen, M. Machimbarrena (Eds.), COST Action TU0901—Towards a Common Framework in Building Acoustics Throughout Europe, 2013, pp. 75–95. OENORM B 8115-5: 2012 Sound insulation and room acoustics in building construction—Part 5: Classification, Austrian Standards Institute, Vienna. J.D. Quirt, A.C.C. Warnock, J.A. Birta: Summary Report for Consortium on Gypsum Board Walls: Sound Transmission Results. National Research Council Canada, Internal Report IRC-IR-693, Institute for Research in Construction, Canada, October 1995. http://dx.doi.org/10.4224/20375264. Craik, 2000, Sound transmission through lightweight parallel plates. Part I: airborne sound, Applied Acoustics, 61, 223, 10.1016/S0003-682X(99)00070-5 S. Schoenwald, B. Zeitler, T.R.T. Nightingale, Investigation of flanking sound transmission in lightweight building structures using a scanning laser vibrometer, Euronoise 2009, Edinburgh, October 26–28, 2009. Mayr, 2011, Point and transfer mobility of point-connected ribbed plates, Journal of Sound and Vibration, 330, 4798, 10.1016/j.jsv.2011.04.017 Hongisto, 2002, Sound insulation of double walls an experimental parametric study, Acta Acustica united with Acustica, 88, 904 Uris, 2002, Influence of screw spacings on sound reduction index in lightweight partitions, Applied Acoustics, 63, 813, 10.1016/S0003-682X(01)00072-X International Organization for Standardization ISO 10140:2010 Acoustics – Laboratory measurement of sound insulation of building elements – Part 1: Application rules for specific products, – Part 2: Measurement of airborne sound insulation, – Part 3: Measurement of impact sound insulation, – Part 4: Measurement procedures and requirements, – Part 5: Requirements for test facilities and equipment. International Organization for Standardization ISO 717-1:2013 Acoustics – Rating of sound insulation in buildings and of building elements – Part 1: Airborne sound insulation. Heckl, 1963, Relationship between the transmission loss and the impact noise isolation of floor structures, Journal of the Acoustical Society of America, 35, 1825, 10.1121/1.1918830 Vér, 1971, Relation between the normalized impact sound level and sound transmission loss, Journal of the Acoustical Society of America, 50, 1414, 10.1121/1.1912783 Cremer, 1988 Beranek, 1971 Kropp, 1994, On the meaning of the sound reduction index at low frequencies, Acta Acustica, 2, 379 Roozen, 2015, Determining radiated sound power of building structures by means of Laser Doppler vibrometry, Journal of Sound and Vibration, 346, 81, 10.1016/j.jsv.2015.02.029 Rayleigh, 1945, vol. 2 Fahy, 1985 Lamancusa, 1993, Numerical optimization techniques for structural-acoustic design of rectangular panels, Computers & Structures, 48, 661, 10.1016/0045-7949(93)90260-K Verheij, 1980, Cross spectral density methods for measuring structure borne power flow on beams and pipes, Journal of Sound and Vibration, 70, 133, 10.1016/0022-460X(80)90559-3 B. Rasmussen, M. Machimbarrena (Eds.), Building Acoustics Throughout Europe. Volume 1: Towards a Common Framework in Building Acoustics Throughout Europe, Chapter 2: Existing Sound Insulation Performance Requirements and Classification Schemes For Housing Across Europe. DiScript Preimpresion, S. L., 2014. Nightingale, 2004, Estimating in-situ material properties of a wood joist floor, Building Acoustics, 11, 175, 10.1260/1351010042250411 Kurra, 2012, Comparison of the models predicting sound insulation values of multilayered building elements, Applied Acoustics, 73, 575, 10.1016/j.apacoust.2011.11.008 Salenbien, 2011, Laser-based surface acoustic wave dispersion spectroscopy for extraction of thicknesses, depth, and elastic parameters of a subsurface layer, Journal of Applied Physics, 109, 093104, 10.1063/1.3573389 〈http://www.rigips.at/fileadmin/Rigips_Daten/Produktdatenblaetter_Platten_englisch/engl_PDB_Rigidur_H_12_5.pdf〉 (Accessed June 2014). Xie, 2005, The radiation efficiency of baffled plates and strips, Journal of Sound and Vibration, 280, 181, 10.1016/j.jsv.2003.12.025 Maidanik, 1962, Response of ribbed panels to reverberant acoustic fields, Journal of the Acoustical Society of America, 34, 809, 10.1121/1.1918200 Roozen, 2015, A global error estimator for the uncertainty of a multi-channel spectral analysis, Applied Acoustics, 87, 57, 10.1016/j.apacoust.2014.06.007 S. Smith, J. Antonio, Monitoring & testing sound insulation performance in New Homes in Europe, in: B. Rasmussen, M. Machimbarrena (Eds.), COST Action TU0901 – Towards a Common Framework in Building Acoustics Throughout Europe, 2013, pp. 157–165.