Image based control system for improving fiber injection molding process

Fleischer, 2012, Overcoming the challenges of automated pre-forming of semi-finished textiles, 24. Wölling, 2017, Nonwovens from Recycled Carbon Fibres – Comparison of Processing Technologies, Procedia CIRP, 66, 271, 10.1016/j.procir.2017.03.281 Harper, 2006 Hopmann, 2015, Development of an automated additive preforming technology for RTM-parts, 445 Förster, E., 2005. Method and device for producing three-dimensional molded parts and corresponding molded part. Fleischer, 2016, Fiber-Injection-Molding - Herausforderungen und Chancen, VDI-Z Integrierte Produktion 2016, 10, 64 Dackweiler, 2017, Automated local reinforcing of glass fiber-injection-molded preforms with carbon fiber tapes Agrawal, 1987, Injection-molding process control - A review, Polym. Eng. Sci., 27, 1345, 10.1002/pen.760271802 Chen, 2005, A review of current developments in process and quality control for injection molding, Adv. Polym. Technol., 24, 165, 10.1002/adv.20046 Danisman, 2007, Monitoring of resin flow in the resin transfer molding (RTM) process using point-voltage sensors, Composites Science and Technology, 67, 367, 10.1016/j.compscitech.2006.09.011 Berger, 2017, Characterisation and Optimization of in-process Eddy Current Sensor Arrays Using Computed Tomography, Procedia CIRP, 66, 243, 10.1016/j.procir.2017.03.363 Moll, 2019, Method for the Investigation of Mold Filling in the Fiber Injection Molding Process Based on Image Processing, Procedia CIRP, 86, 156, 10.1016/j.procir.2020.01.012 Badrinarayanan, 2017, SegNet: A Deep Convolutional Encoder-Decoder Architecture for Image Segmentation, IEEE Trans. Pattern Anal. Machine Intell., 39, 2481, 10.1109/TPAMI.2016.2644615 Moll, 2020, Analysis of Basis Weight Uniformity Indexes for the Evaluation of Fiber Injection Molded Nonwoven Preforms, Autex Research Journal