Heat transfer of oil shale in a small-scale fixed bed
Tóm tắt
Heat transfer experiments on Longkou oil shale were carried out in a fixed-bed reactor. Temperatures at different positions in the reactor were determined. With increasing heating rate, the temperature difference between center and exterior of the reactor increased, the time needed to get to constant temperature decreased, while the time needed to reach final pyrolysis temperature decreased. A pseudo-homogeneous one-dimensional heat transfer model was developed, and analytical expressions were obtained on the basis of mathematical derivation. It was found that the coefficient of heat conductivity is a polynomial function of temperature. The Longkou oil shale could be seen as a poor heat conductor because of its low coefficient of heat conductivity. Usually, there are many factors to affect coefficient of heat conductivity, including the composition, density, moisture content, temperature, particle size and particle size distribution. Reasonable values of heat conductivity in different temperature ranges were determined using the developed model. The calculated results using heat transfer model for Longkou oil shale are reasonably agreed with actually measured temperature.
Tài liệu tham khảo
Jaber JO, Probert SD. Pyrolysis and gasification kinetics of Jordanian oil-shales. Appl Energy. 1999;63:269–86.
Senguler MVK. Geological and thermal characterization of Eskisehir region oil shales. J Therm Anal Calorim. 2014;116:367–72.
Incropera FP, DeWitt DP, Bergman TL. Fundamentals of heat and mass transfer. 6th ed. America: Chemical Industry Press; 2007.
Wang QY. China energy. China: The metallurgical industry press; 1988.
Zhang ZZ. Construction of oil shale power plants and development of new energy in Guangdong. Guangdong Electr Power. 1991;15:54–8.
Fu ZZ. The development and utilization of Huandian oil shale in three years. Util Waste Rock. 1983;1:12–37.
Jiang XM, Wang Q. On design of Petrolo-shale fired fluidized circulation bed boiler. Power Eng US. 1993;6:33–7.
He HM, Xu DP, Zhang XL. Development and utilization of oil shale. Clean Coal Technonl. 2002;8:44–7.
Cook NGW. Natural joints in rock mechanical, hydraulic and seismic behavior and properties under normal stress. Int J Rock Mech Min Sci Geomech Abstr. 1992;29:198–223.
Gao J. Introduction of process and way of oil shale retort sewage disposal. J Shenyang Inst Chem Technol. 2003;17:236–9.
Zhang MH, Chen YT, Zhang MQ. The development and pathway of utilization of Chinese oil shale. Jilin Build Mater. 2003;3:15–21.
Julien Maes, Ann HM, Matthew D, Lapene JMQ. Scaling heat and mass flow through porous media during pyrolysis. J Therm Anal Calorim. 2015;51:313–34.
Souza GEMA, Miranda RF, Lobato FS. Simultaneous heat and mass transfer in a fixed bed dryer. Appl Therm Eng. 2015;90:38–44.
Dixon AG, Walls G, Stanness H. Experimental validation of high Reynolds number CFD simulations of heat transfer in a pilot-scale fixed bed tube. Chem Eng J. 2012;200–202:344–56.
Zhang F, Parker JC. An efficient modeling approach to simulate heat transfer rate between fracture and matrix regions for oil shale retorting. Transp Porous Media. 2010;84:229–40.
Khraisha YH. Thermal conductivity of oil shale particles in a packed bed. Energy Sources. 2002;24:613–23.
Xue JX. The experiment research on physical & mechanicical characteristics of oil shale and its unsteady heat conduction mathematical model of in situ processing. Master Thesis, Taiyuan University of technology, Shanxi, China, 2007.
Kang ZQ, Lv ZX, Yang D. The solid-fluid-thermal-chemistry coupling mathematical model for oil shale in situ steam injecting development. J Xi’an Shiyou Univ (Nat Sci Ed). 2008;23:30–4.
Rakopoulos CD, Kosmadakis GM, Pariotis EG. Critical evaluation of heat transfer models used in CFD in cylinder engine simulations and establishment of a comprehensive wall-function formulation. Appl Energy. 2010;87:1612–30.
Wu JM. Study of heat transfer of fixed-bed and mathematical simulation of Fischer–Tropsch synthesis reactor. Doctor Thesis, Taiyuan University of Technology, Shanxi, China, 2010.
Coberly M. Temperature gradients in gas streams flowing through fixed granular beds. Chem Eng Prog. 1951;47:141–50.
Chen YZ, Wang JB, Chen JW. Estimation of heat transfer parameters in packed bed by using orthogonal collocation. J Chem Ind Eng (China). 1990;2:219–26.
Wen DS, Cong TN, He YR. Heat transfer of gas-solid two-phase mixtures flowing through a packed bed. Chem Eng Sci. 2007;62:4241–9.
Chi YL, Li SY, Ma YH. Study of pyrolysis characteristics and kinetics of Longkou oil shale. J China Univ Pet (Ed Nat Sci). 2007;31:112–5.
Ma Y, Li SY. Study of the characteristics and kinetics of oil sand pyrolysis. Energy Fuels. 2010;24:1844–7.
Johannes I, Tiikma L. Kinetics of oil shale pyrolysis in an autoclave under non-liner increase of temperature. Oil Shale. 2004;21:273–88.
Xue HQ, Li SY, Qi YL. Investigating on pyrolysis kinetics of Yaojie oil shale. Inner Mong Petrochem Ind. 2009;35:98–100.