Frictional properties of diamond-like carbon coated tool in dry intermittent machining of aluminum alloy 5052

Klocke, 1997, Dry cutting, CIRP Ann Manuf Technol, 46, 519, 10.1016/S0007-8506(07)60877-4 Weinert, 2004, Dry machining and minimum quantity lubrication, CIRP Ann Manuf Technol, 53, 511, 10.1016/S0007-8506(07)60027-4 Bhowmick, 2008, The performance of hydrogenated and non-hydrogenated diamond-like carbon tool coatings during the dry drilling of 319 Al, Int J Mach Tools Manuf, 48, 802, 10.1016/j.ijmachtools.2007.12.006 Bhowmick, 2010, Dry and minimum quantity lubrication drilling of cast magnesium alloy (AM60), Int J Mach Tools Manuf, 50, 444, 10.1016/j.ijmachtools.2010.02.001 List, 2005, Wear behaviour of cemented carbide tools in dry machining of aluminium alloy, Wear, 259, 1177, 10.1016/j.wear.2005.02.056 Lahres, 1997, Applicability of different hard coatings in dry milling aluminium alloys, Surf Coat Technol, 91, 116, 10.1016/S0257-8972(96)03121-0 dos Santos, 2007, Characterization of DLC thin film and evaluation of machining forces using coated inserts in turning of Al–Si alloys, Surf Coat Technol, 202, 1029, 10.1016/j.surfcoat.2007.07.100 Fukui, 2004, Cutting performance of DLC coated tools in dry machining aluminum alloys, Surf Coat Technol, 187, 70, 10.1016/j.surfcoat.2004.01.014 Yokota, 2012, Effect of the combination of DLC film and alcohol mist in turning of aluminum alloy, J Jpn Soc Precis Eng, 78, 777, 10.2493/jjspe.78.777 Yokota, 2012, Cutting performance of different types of diamond-like carbon coatings, 35 Takikawa, 2003, DLC thin film preparation by cathodic arc deposition with a super droplet-free system, Surf Coat Technol, 163–164, 368, 10.1016/S0257-8972(02)00629-1 Tai, 2006, Correlation between ID/IG ratio from visible Raman spectra and sp2/sp3 ratio from XPS spectra of annealed hydrogenated DLC film, Mater Trans, 47, 1847, 10.2320/matertrans.47.1847