Flat tube heat exchangers: Experimental analysis of frosting and water retention

Shao, 2010, Comparison of heat pump performance using fin-and-tube and microchannel heat exchangers under frost conditions, Appl. Energy, 87, 1187, 10.1016/j.apenergy.2009.08.021 Padhmanabhan, 2008 Moallem, 2010, Experimental study of onset and growth of frost on outdoor coils of air-source heat pump systems Joardar, 2006 Hafner, 2003 Obrist, 2005 Zhang, 2010, Air-side performance of a parallel-flow parallel-fin (PF2) heat exchanger in sequential frosting, Int. J. Refrig., 33, 1118, 10.1016/j.ijrefrig.2010.04.011 Hong, 2020, Performance improvement of heat pumps using novel microchannel heat exchangers with plain-louver fins during periodic frosting and defrosting cycles in electric vehicles, Energy Convers. Manage., 223, 10.1016/j.enconman.2020.113306 Kamei, 1952, Research on the frost formation in a low temperature cooler, Japan Sci. Rev., 317 O’Neal, 1982 Sanders, 1974 Trammell, 1968, A study of frost formed on a flat plate held at sub-freezing temperatures, ASHRAE J., 42 Hayashi, 1977, Study of frost properties correlating with frost formation types, J. Heat Transfer, 99, 239, 10.1115/1.3450675 Tao, 1993, Characteristics of frost growth on a flat plate during the early growth period, ASHRAE Trans., 746 Aoki, 1983, A study on frost formation: The process of frost formation involving the phenomena of water permeation and freezing, Bull. JSME, 26, 87, 10.1299/jsme1958.26.87 T.S. Gatchilov, V.S. Ivanov, Characteristics of the frost formed on the surface of the finned air coolers, in: IIR (Ed.), Proceedings of the XV International Congress of Refrigeration, Vol. 2, 1979. Niederer, 1976, Frostig and defrosting effects on coil heat transfer, ASHRAE Trans., 467 Kondepudi, 1989, Effect of frost growth on the performance of louvered finned tube heat exchangers, Int. J. Refrig., 12, 151, 10.1016/0140-7007(89)90030-3 Kondepudi, 1991, Frosting performance of tube fin heat exchangers with wavy and corrugated fins, Exp. Therm Fluid Sci., 4, 613, 10.1016/0894-1777(91)90040-X da Silva, 2011, Experimental study of frost accumulation on fan-supplied tube-fin evaporators, Appl. Therm. Eng., 31, 1013, 10.1016/j.applthermaleng.2010.11.006 da Silva, 2017, Effect of frost morphology on the thermal-hydraulic performance of fan-supplied tube-fin evaporators, Appl. Therm. Eng., 111, 1060, 10.1016/j.applthermaleng.2016.09.165 Padhmanabhan, 2011, Modeling non-uniform frost growth on a fin-and-tube heat exchanger, Int. J. Refrig., 34, 2018, 10.1016/j.ijrefrig.2011.06.005 Liping, 2017, Experimental study of frost growth characteristics on surface of fin-tube heat exchanger, Energy Procedia, 105, 5114, 10.1016/j.egypro.2017.03.1039 Yan, 2003, Performance of finned tube heat exchangers operating under frosting conditions, Int. J. Heat Mass Transfer, 46, 871, 10.1016/S0017-9310(02)00346-0 Kim, 2003, Performance comparisons of a unitary split system using microchannel and fin-tube outdoor coils, ASHRAE Trans., 219 Moallem, 2010 Moallem, 2012, Experimental investigation of the surface temperature and water retention effects on the frosting performance of a compact microchannel heat exchanger for heat pump systems, Int. J. Refrig., 35, 171, 10.1016/j.ijrefrig.2011.08.010 Kim, 2014, Thermal performance of microchannel heat exchangers according to the design parameters under the frosting conditions, Int. J. Heat Mass Transfer, 71, 626, 10.1016/j.ijheatmasstransfer.2013.12.060 Xia, 2006, Frost, defrost, and refrost and its impact on the air-side thermal-hydraulic performance of louvered-fin, flat-tube heat exchangers, Int. J. Refrig., 29, 1066, 10.1016/j.ijrefrig.2006.03.005 Moallem, 2012, Experimental measurements of the surface coating and water retention effects on frosting performance of microchannel heat exchangers for heat pump systems, Exp. Therm Fluid Sci., 39, 176, 10.1016/j.expthermflusci.2012.01.022 Kim, 2013, Frosting and defrosting characteristics of surface-treated louvered-fin heat exchangers: Effects of fin pitch and experimental conditions, Int. J. Heat Mass Transfer, 60, 505, 10.1016/j.ijheatmasstransfer.2013.01.036 Moallem, 2013, Experimental investigation of adverse effect of frost formation on microchannel evaporators, part 1: Effect of fin geometry and environmental effects, Int. J. Refrig., 36, 1762, 10.1016/j.ijrefrig.2012.09.009 Pu, 2020, Experimental study of cyclic frosting and defrosting on microchannel heat exchangers with different coatings, Energy Build., 226, 10.1016/j.enbuild.2020.110382 Jhee, 2002, Effect of surface treatments on the frosting/defrosting behavior of a fin-tube heat exchanger, Int. J. Refrig., 25, 1047, 10.1016/S0140-7007(02)00008-7 Mclaughlin, 2000, Wet air side performance of louver fin automotive evaporators Mclaughlin, 2000, Condensate drainage and retention in louver fin automotive evaporators Westhaeuser, 2022 Chau, 2009, A review of techniques for measurement of contact angles and their applicability on mineral surfaces, Miner. Eng., 22, 213, 10.1016/j.mineng.2008.07.009 2008 Smith, 1931, Mean temperature difference in cross flow, Engineering, 138, 479 Langeheinecke, 2005 Sommers, 2016, Densification of frost on hydrophilic and hydrophobic substrates - examining the effect of surface wettability, Exp. Therm Fluid Sci., 75, 25, 10.1016/j.expthermflusci.2016.01.008 Shin, 2003, Experimental study on frost structure on surfaces with different hydrophilicity: Density and thermal conductivity, J. Heat Transfer, 125, 84, 10.1115/1.1518496 Kim, 2011, Frosting and defrosting characteristics of a fin according to surface contact angle, Int. J. Heat Mass Transfer, 54, 2758, 10.1016/j.ijheatmasstransfer.2011.02.065 J.L. Hoke, J.G. Georgiadis, A.M. Jacobi, The interaction between the substrate and frost layer through condensate distribution, ACRC Technical Report-177, 2000. Lee, 2004, Frost formation on a plate with different surface hydrophilicity, Int. J. Heat Mass Transfer, 47, 4881, 10.1016/j.ijheatmasstransfer.2004.05.021 Okoroafor, 2000, Minimising frost growth on cold surfaces exposed to humid air by means of crosslinked hydrophilic polymeric coatings, Appl. Therm. Eng., 20, 737, 10.1016/S1359-4311(99)00056-3 Sommers, 2018, The role of surface wettability on natural convection frosting: Frost growth data and a new correlation for hydrophilic and hydrophobic surfaces, Int. J. Heat Mass Transfer, 122, 78, 10.1016/j.ijheatmasstransfer.2018.01.074 Kim, 2002 Zhang, 2001, Water condensate retention and “wet” fin performance in automotive evaporators J. Kaiser, Y. Zhong, A.M. Jacobi, C. Zhang, H. Hu, Condensate retention and dynamic drainage from the air-side surface of automotive-style heat exchanger, in: Proceedings of the International Conference on Compact Heat Exchangers and Enhancement Technology for the Process Industries, 2003, pp. 361–366. Zhong, 2005, Dynamic dip testing as a method to assess the condensate drainage behavior from the air-side surface of compact heat exchangers, Exp. Therm Fluid Sci., 29, 957, 10.1016/j.expthermflusci.2005.01.006