Finite-Resistivity Instabilities of a Sheet Pinch

AIP Publishing - Tập 6 Số 4 - Trang 459-484 - 1963
H. P. Furth1, J. Killeen1, M. N. Rosenbluth2,3
1Lawrence Radiation Laboratory, Livermore, California
2John Jay Hopkins Laboratory for Pure and Applied Science, General Atomic Division of General Dynamics Corporation, San Diego, California
3University of California, San Diego, La Jolla, California

Tóm tắt

The stability of a plane current layer is analyzed in the hydromagnetic approximation, allowing for finite isotropic resistivity. The effect of a small layer curvature is simulated by a gravitational field. In an incompressible fluid, there can be three basic types of ``resistive'' instability: a long-wave ``tearing'' mode, corresponding to breakup of the layer along current-flow lines; a short-wave ``rippling'' mode, due to the flow of current across the resistivity gradients of the layer; and a low-g gravitational interchange mode that grows in spite of finite magnetic shear. The time scale is set by the resistive diffusion time τR and the hydromagnetic transit time τH of the layer. For large S = τR/τH, the growth rate of the ``tearing'' and ``rippling'' modes is of order τR−3/5τH−2/5, and that of the gravitational mode is of order τR−1/3τH−2/3. As S → ∞, the gravitational effect dominates and may be used to stabilize the two nongravitational modes. If the zero-order configuration is in equilibrium, there are no overstable modes in the incompressible case. Allowance for plasma compressibility somewhat modifies the ``rippling'' and gravitational modes, and may permit overstable modes to appear. The existence of overstable modes depends also on increasingly large zero-order resistivity gradients as S → ∞. The three unstable modes merely require increasingly large gradients of the first-order fluid velocity; but even so, the hydromagnetic approximation breaks down as S → ∞. Allowance for isotropic viscosity increases the effective mass density of the fluid, and the growth rates of the ``tearing'' and ``rippling'' modes then scale as τR−2/3τH−1/3. In plasmas, allowance for thermal conductivity suppresses the ``rippling'' mode at moderately high values of S. The ``tearing'' mode can be stabilized by conducting walls. The transition from the low-g ``resistive'' gravitational mode to the familiar high-g infinite conductivity mode is examined. The extension of the stability analysis to cylindrical geometry is discussed. The relevance of the theory to the results of various plasma experiments is pointed out. A nonhydromagnetic treatment will be needed to achieve rigorous correspondence to the experimental conditions.

Từ khóa


Tài liệu tham khảo

1960, Phys. Fluids, 3, 982, 10.1063/1.1706167

1958, Proc. Roy. Soc. (London), A244, 17

1961, Phys. Fluids, 4, 314, 10.1063/1.1706327

1961, Bull. Am. Phys. Soc., 6, 193

1961, Bull. Am. Phys. Soc., 6, 309

1961, Arkiv Fysik, 19, 499

1961, Bull. Am. Phys. Soc., 6, 204

1961, Phys. Fluids, 4, 1527, 10.1063/1.1706311

1960, Phys. Fluids, 3, 600, 10.1063/1.1706094

1960, Phys. Rev. Letters, 5, 409, 10.1103/PhysRevLett.5.409

1960, J. Nuclear Energy, Part C, 1, 230, 10.1088/0368-3281/1/4/306

1962, Phys. Fluids, 5, 22, 10.1063/1.1706487

1961, Nuclear Fusion, 1, 286, 10.1088/0029-5515/1/4/008

1957, Ann. Phys. N.Y., 1, 120, 10.1016/0003-4916(57)90055-6

1959, Phys. Rev. Letters, 3, 5, 10.1103/PhysRevLett.3.5

1960, Phys. Rev. Letters, 5, 416, 10.1103/PhysRevLett.5.416

1963, Bull. Am. Phys. Soc., 8, 150

1962, Bull. Am. Phys. Soc., 7, 148

1962, Bull. Am. Phys. Soc., 7, 147

1960, Revs. Mod. Phys., 32, 744, 10.1103/RevModPhys.32.744

1962, J. Nucl. Energy, C4, 159

1963, Bull. Am. Phys. Soc., 8, 166

1963, Bull. Am. Phys. Soc., 8, 330

Thông tin
Thông tin xuất bản

AIP Publishing

Tập 6 Số 4

459-484

Thông tin tác giả