Experimental study on the effects of stern bulb arrangement on the slamming load

Chuang, 1967, Experimental on slamming of wedge-shaped bodies, J. Ship Res., 11, 190, 10.5957/jsr.1967.11.3.190 Cusano, 2007, Assessment of whipping effects induced by stern/bow-flare slamming Dessi, 2007, Analysis of the ship response to stern slamming loads Engle, 2003, A comparison of hydrodynamic impacts prediction methods with two dimensional drop test data, Mar. Struct., 16, 175, 10.1016/S0951-8339(02)00026-6 Faltinsen, 2005, A generalized wagner method for three-dimensional slamming, J. Ship Res., 49, 279, 10.5957/jsr.2005.49.4.279 Howison, 1991, Incompressible water-entry problems at small deadrise angles, J. Fluid Mech., 222, 215, 10.1017/S0022112091001076 Kapsenberg, 2011, Slamming of ships: where are we now?, Phil. Trans. Roy. Soc. Lond. Math. Phys. Eng. Sci., 369, 2892 Kawakami, 1977, Prediction of long term whipping vibration stress due to slamming of large full ships in rough seas, Int. Shipbuild. Prog., 24, 83, 10.3233/ISP-1977-2427201 Kleefsman, 2005, A volume-of-fluid based simulation method for wave impact problems, J. Comput. Phys., 206, 363, 10.1016/j.jcp.2004.12.007 Luo, 2012, Numerical and experimental study of hydrodynamic impact and elastic response of one free-drop wedge with stiffened panels, Ocean Eng., 40, 1, 10.1016/j.oceaneng.2011.11.004 Maki, 2011, Hydroelastic impact of a wedge-shaped body, Ocean Eng., 38, 621, 10.1016/j.oceaneng.2010.12.011 Michimoto, 1982, On the stern flare impact pressure of RORO ship (in Japanese), J. Soc. Nav. Archit. Jpn., 151, 208, 10.2534/jjasnaoe1968.1982.208 Oberhagemann, 2010, Hydro-elastic simulation of stern slamming and whipping, Int. J. Ocean Clim. Syst., 1, 179, 10.1260/1759-3131.1.3-4.179 Ochi, 1973, Prediction of slamming characteristics and hull responses for ship design, Trans. - Soc. Nav. Archit. Mar. Eng., 81, 144 Panciroli, 2015, Experiments on the water entry of curved wedges: high speed imaging and particle image velocimetry, Ocean Eng., 94, 213, 10.1016/j.oceaneng.2014.12.004 Stavovy, 1976, Analytical determination of slamming pressures for high-speed vehicles in waves, J. Ship Res., 20, 190, 10.5957/jsr.1976.20.4.190 Storhaug, 2014, The measured contribution of whipping and springing on the fatigue and extreme loading of container vessels, Int. J. Naval Arch. Ocean Eng., 6, 1096, 10.2478/IJNAOE-2013-0233 Sun, 2009, Water entry of a bow-flare ship section with roll angle, J. Mar. Sci. Technol., 14, 69, 10.1007/s00773-008-0026-1 Tveitnes, 2008, An experimental investigation into the constant velocity water entry of wedge-shaped sections, Ocean Eng., 35, 1463, 10.1016/j.oceaneng.2008.06.012 Von Karman, 1929 Wagner, 1932, Über Stoß- und Gleitvergänge an der Oberfläche von Flüssigkeiten, Z. Angew. Math. Mech., 12, 193, 10.1002/zamm.19320120402 Yang, 2007, Experimental and numerical study on the water entry of symmetric wedges and a stern section of modern containership Yettou, 2006, Experimental study on the water impact of a symmetrical wedge, Fluid Dynam. Res., 38, 47, 10.1016/j.fluiddyn.2005.09.003