Experimental study on effect of heat transfer enhancement for single-phase forced convective flow with twisted tape inserts

Chang, 2014, Thermal performances of tubular flows enhanced by ribbed spiky twist tapes with and without edge notches, Int. J. Heat Mass Transfer, 73, 645, 10.1016/j.ijheatmasstransfer.2014.02.049 Eiamsa-Ard, 2010, Performance assessment in a heat exchanger tube with alternate clockwise and counter-clockwise twisted-tape inserts, Int. J. Heat Mass Transfer, 53, 1364, 10.1016/j.ijheatmasstransfer.2009.12.023 Skullong, 2016, Heat transfer and turbulent flow friction in a round tube with staggered-winglet perforated-tapes, Int. J. Heat Mass Transfer, 95, 230, 10.1016/j.ijheatmasstransfer.2015.12.007 Eiamsa-Ard, 2009, Convective heat transfer in a circular tube with short-length twisted tape insert, Int. Commun. Heat Mass Transfer, 36, 365, 10.1016/j.icheatmasstransfer.2009.01.006 Patil, 2014, Laminar heat transfer augmentation through a square duct and circular tube fitted with twisted tapes, Exp. Heat Transfer, 27, 124, 10.1080/08916152.2012.757674 Saha, 2001, Thermohydraulic study of laminar swirl flow through a circular tube fitted with twisted tapes, Trans. Am. Soc. Mech. Eng. J. Heat Transfer, 123, 417, 10.1115/1.1370500 Chakroun, 1996, The effect of twisted-tape width on heat transfer and pressure drop for fully developed laminar flow, J. Eng. Gas Turbines Power, 118, 584, 10.1115/1.2816688 Hasanpour, 2016, Experimental heat transfer and pressure drop study on typical, perforated, V-cut and U-cut twisted tapes in a helically corrugated heat exchanger, Int. Commun. Heat Mass Transfer, 71, 126, 10.1016/j.icheatmasstransfer.2015.12.032 Saha, 2012, Heat transfer enhancement of laminar flow through a circular tube having wire coil inserts and fitted with center-cleared twisted tape, J. Therm. Sci. Eng. Appl., 4, 031003, 10.1115/1.4006289 Tarasevich, 2011, Heat and mass transfer in tubes with various twisted tape inserts, 697 Chougule, 2016, Comparative study on heat transfer enhancement of low volume concentration of Al2O3–water and carbon nano-tube–water nano-fluids in transition regime using helical screw tape inserts, Exp. Heat Transfer, 29, 17, 10.1080/08916152.2014.926432 Syam Sundar, 2012, Effect of full length twisted tape inserts on heat transfer and friction factor enhancement with Fe3O4 magnetic nanofluid inside a plain tube: an experimental study, Int. J. Heat Mass Transfer, 55, 2761, 10.1016/j.ijheatmasstransfer.2012.02.040 Kakaç, 2016, Single-phase and two-phase treatments of convective heat transfer enhancement with nanofluids—a state-of-the-art review, Int. J. Therm. Sci., 100, 75, 10.1016/j.ijthermalsci.2015.09.021 Waghole, 2016, Studies on heat transfer in flow of silver nanofluid through a straight tube with twisted tape inserts, Heat Mass Transfer, 52.2, 309, 10.1007/s00231-015-1563-x Eiamsa-ard, 2016, Influence of three-start spirally twisted tube combined with triple-channel twisted tape insert on heat transfer enhancement, Chem. Eng. Process., 10.1016/j.cep.2016.01.012 Raj, 2015, Single phase flow heat transfer and pressure drop measurements in doubly enhanced tubes, Int. J. Therm. Sci., 88, 215, 10.1016/j.ijthermalsci.2014.10.004 Eiamsa-Ard, 2013, Heat transfer characteristics in micro-fin tube equipped with double twisted tapes: effect of twisted tape and micro-fin tube arrangements, J. Hydrodyn. Ser. B, 25, 205, 10.1016/S1001-6058(13)60355-8 ANSI/ASME, 1986 Gnielinski, 1976, New equations for heat and mass-transfer in turbulent pipe and channel flow, Int. Chem. Eng., 16, 359 Patil, 2000, Laminar flow heat transfer and pressure drop characteristics of power-law fluids inside tubes with varying width twisted tape inserts, J. Heat Transfer, 122, 143, 10.1115/1.521448 Rout, 2013, Laminar flow heat transfer and pressure drop in a circular tube having wire-coil and helical screw-tape inserts, J. Heat Transfer, 135, 021901, 10.1115/1.4007415 Ahamed, 2011, Enhancement and prediction of heat transfer rate in turbulent flow through tube with perforated twisted tape inserts: a new correlation, J. Heat Transfer, 133, 041903, 10.1115/1.4002635 Murugesan, 2011, Heat transfer and pressure drop characteristics in a circular tube fitted with and without V-cut twisted tape insert, Int. Commun. Heat Mass Transfer, 38, 329, 10.1016/j.icheatmasstransfer.2010.11.010 Khwanchit, 2011, Heat transfer enhancement by twisted tapes with alternate-axes and triangular, rectangular and trapezoidal wings, Chem. Eng. Process., 50, 211, 10.1016/j.cep.2010.11.012 Sivashanmugam, 2007, Studies on heat transfer and friction factor characteristics of laminar flow through a circular tube fitted with right and left helical screw-tape inserts, Exp. Therm. Fluid Sci., 32, 192, 10.1016/j.expthermflusci.2007.03.005 Ghajar, 1994, Heat transfer measurements and correlations in the transition region for a circular tube with three different inlet configurations, Exp. Therm. Fluid Sci., 8, 79, 10.1016/0894-1777(94)90075-2