Experimental investigation of the effect of injection water salinity on the displacement efficiency of miscible carbon dioxide WAG flooding in a selected carbonate reservoir
Tóm tắt
The effect of injection brine salinity on the displacement efficiency of low water salinity flooding was investigated using sea water at 35,000 ppm, and two field injection waters, namely, Um-Eradhuma (UER) at 171,585 ppm and simsima (SIM) at 243,155 ppm. The salinity of the employed waters was varied from original salinity to 1,000 ppm and used in the displacement of oil in selected core samples. The results of this set of experiments revealed that UER salinity of 5,000 ppm is the optimum system for the candidate reservoir. UER original water and its optimum water were then used in this project as the high and low salinity waters in the CO2–WAG flooding experiments. Displacement efficiencies were evaluated under three injection modes: carbon dioxide WAG miscible flooding (CO2–WAG, 1:1, 2:1, and 1:2), continuous CO2 injection, and waterflood. The WAG performance parameters, such as secondary and tertiary displacement efficiencies, CO2 flood utilization factor, and CO2 performance during different WAG flood cycles were determined. To insure miscibility condition between the injected gas and the employed oil, all of the flooding experiments were conducted at 3,200 psia (which is 300 psia above the minimum miscibility pressure of CO2 and used oil) and 250 °F. Experimental results indicated that core length is a critical parameter in determining the optimum WAG process, and that a minimum core length of 29 cm is required to insure the generation of miscibility before breakthrough in CO2–WAG flooding experiments. On the other hand, core length had no effect on the performance of the low salinity flooding experiments. Using single core flooding low salinity CO2–WAG of 1:2 flooding produced an improvement in the displacement efficiency of 29 % over the high salinity system. Also, composite core flooding experiments showed that the high salinity CO2-2:1 WAG achieved a displacement efficiency of 98 %. These results indicate that achieving miscibility at the reservoir conditions is the dominant mechanism and that low salinity will have no major effect on the displacement efficiency of CO2-Miscible WAG flooding. Results also indicate that oil recovery during different CO2–WAG cycles is a function of WAG ratios.
Tài liệu tham khảo
Abrams A (1975) The influence of fluid viscosity, interfacial tension, and flow velocity on residual oil saturation left by waterflood. SPE J 15(5):437–447
Aguilera ME, de Ramos AL (2004) Effect of CO2 diffusion on wettability for hydrocarbon-water-CO2 systems in capillaries. Int Commun Heat Mass Transf 31(8):1115–1122
Aleidan A, Mamora DD (2010) SWACO2 and WACO2 efficiency improvement in carbonate cores by lowering water salinity. Paper SPE 137548 presented at the Canadian Unconventional Resources & International Petroleum Conference held in Calgary, Alberta, Canada
Caudle BH, Dyes AB (1958) Improving miscible displacement by gas-water injection. Pet Trans AIME 213:281–284
Christensen JR, Stenby EH, Skauge A (1998) Review of the WAG field experience. Paper SPE 71203 presented at the 1998 SPE International petroleum conference and exhibition of Mexico, Villahermosa
Craig Jr. FF, Geffen TM, Morse RA (1955) Oil recovery performance of pattern gas or water injection operations from model tests. Society of Petroleum Engineers, pp 7–15
Dang CT, Nghiem LX, Chen Z, Nguyen QP, Nguyen TB (2013) State-of-the art low salinity waterflooding for enhanced oil recovery. Paper SPE 165903 presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, Jakarta, Indonesia
Fredi I. Stalkup (1992) Miscible displacement. SPE Monograph Volume 8, Richardson
Hinderaker L, Utseth RH, Hustad OS, Kvanvik BA, Paulsen JE (1996) A comprehensive Norwegian R&D program on IOR. Paper SPE 36844 presented at the SPE European Petroleum Conference, Milan, Italy
Jackson DD, Andrews GL, Claridge EL (1985) Optimum WAG ratio versus rock wettability in CO2 flooding. Paper SPE 14303 presented at 60th Annual technical conference and exhibition of the Society of Petroleum engineers, Las Vegas, NV, USA
Jiang H, Nuryaningsih L, Adidharma H (2010) The effect of salinity of injection brine on water alternating gas performance in tertiary miscible carbon dioxide flooding: experimental study. Paper SPE 132369, presented at the SPE Western Regional Meeting held in Anaheim, CA, USA
Kulkarni MH, Rao DN (2005) Experimental investigation of miscible secondary gas injection. Paper SPE 95975 presented at SPE Annual Technical Conference and Exhibition, Dallas, TX
Rogers JD, Grigg RB (2000) A literature analysis of the WAG injectivity abnormalities in the CO2 process. Paper SPE 59329 presented at the 2000 review SPE/DOE Improved Oil Recovery symposium, Tulsa, OKlhoma
Yousef AA, Al-Saleh S, Al-Kaabi A, Al-Jawfi M (2011) Laboratory investigation of the impact of injection-water salinity and ionic content on oil recovery from carbonate reservoirs. SPE Reservoir Eval Eng 14:578–593
Zekri AY, Natuh AA (1992) Laboratory study on the effects of miscible WAG process on tertiary oil recovery. Paper SPE 24481 Presented at the 5th Abu Dhabi petroleum conference, Abu Dhabi, UAE