Environmental factor approach to account for water effects in pressure vessel and piping fatigue evaluations

Asada, Y., 1993. Rate approach for fatigue life reduction factor in LWR water environment. WRC Progress Report, vol. No. XLVIII, 9/10, p. 148. Bieniussa, 1986, Protection against fatigue damage with respect to the environmental influence of LWR operating conditions, Nucl. Eng. Des., 94, 317, 10.1016/0029-5493(86)90014-2 BWR Environmental Cracking Margins for Carbon Steel Piping, 1982. EPRI Report No. NP-2406, Prepared by GE. Chopra, O.K., Shack, W.J., 1995. Effects of LWR environments on fatigue-life of carbon and low-Alloy steels, vol. PVP-306. ASME, New York. Cooper, W.E., 1992. The initial scope and intent of the Section III Fatigue Design Procedures. Prepared for the Pressure Vessel Research Council (PVRC) Workshop on Environmental Effects on Fatigue Performance Clearwater Beach, FL. Ford, F.P., Ranganath, S., Weinstein, D., 1993. environmentally assisted fatigue crack initiation in low alloy steels. EPRI Report No. TR-102765. Hale, 1981, Low cycle fatigue of commercial piping steels in a BWR primary water environment, J. Eng. Mater. Technol. Trans. ASME, 103, 15, 10.1115/1.3224967 Higuchi, 1991, Fatigue strength correction factors for carbon and low-alloy steels in oxygen-containing high-temperature water, Nucl. Eng. Des., 129, 293, 10.1016/0029-5493(91)90138-8 Higuchi, 1984, Trans. Iron Steel Inst. Jpn., 24, B196 Higuchi, 1985, Trans. Iron Steel Inst. Jpn., 71, 101, 10.2355/tetsutohagane1955.71.4_S101 Higuchi, M., Iida, K., Fukakura, J., Kobayashi, H., Miyazano, S., Nako, M., 1988. Effects of LWR Water environment on fatigue strength of several nuclear structural materials. Presented at ASME Code Subgroup on Fatigue Strength meeting, New York City. Higuchi, M., Iida, K., Asada, Y., 1995. Effects of Strain Rate Change on Fatigue Life of Carbon Steel in High-Temperature Water, vol. PVP-306, ASME, New York. James, B.A., Paul, L.D., Miglin, M.T., 1990. Low cycle fatigue crack initiation in SA210A1 carbon steel boiler tubing in contaminated boiler water. In: Fatigue Degradation and Fracture, vol. PVP-195. ASME, New York, pp. 13–19. Kanasaki, H., Hayashi, M., Iida, K., Asada, Y., 1995. Effects of Temperature Change on Fatigue Life of Carbon Steel in High-Temperature Water, vol. PVP-306. ASME, New York. Keisler, J., Chopra, O.K., Shack, W.J., 1994. Statistical analysis of fatigue strain life data for carbon and low-alloy steels. NUREG/CR-6237. Keisler, J., Chopra, O.K., Shack, W.J., 1995. Fatigue strain-life behavior of carbon and low-alloy steels, austenitic stainless steels, and Alloy 600 in LWR Environments. NUREG/CR-6335. Kishida, K., Suzuki, S., Asada, Y., 1995. Evaluation of Environmental Fatigue Life for Light Water Reactor Components, vol. PVP-306. ASME, New York. Majumdar, S., Chopra, O.K., Shack, W.J., 1993. Interim fatigue design curves for carbon, low-alloy, and austenitic stainless steels in LWR environments. NUREG/CR-5999. Mehta, H.S., Gosselin, S.R., 1995. An environmental factor approach to account for reactor water effects in light water reactor pressure vessel and piping fatigue evaluations. EPRI Report No. TR-105759. Mehta, H.S., Ranganath, S., 1992. An Environmental Fatigue Stress Rule for Carbon Steel Reactor Piping, vol. PVP-241. ASME, New York. Mehta, H.S., Ranganath, S., Weinstein, D., 1986. Application of environmental fatigue stress rules to carbon steel reactor piping. EPRI Report No. NP-4644. Nagata, N., Sato, S., Katada, Y., 1989. Low-cycle fatigue behavior of low-alloy steels in high-temperature pressurized water. Trans. 10th Int. Conf. on Structural Mechanics in Reactor Technology, Anaheim, CA. Nakao, G. et al., 1995. Effects of Temperature and Dissolved Oxygen Content on Fatigue Life of Carbon and Low Alloy Steels in LWR Water Environment, vol. PVP-306. ASME, New York. NUREG/CR-4667, 1994. Environmentally assisted cracking in light water reactors. Semiannual Reports: vol. 12 (August 1991), vol. 13 (March 1992), vol. 16 (September 1993) and vol. 17 (June 1994). O'Donnel, T.P., O'Donnel, W.J., 1995. Cyclic Rate-Dependent Fatigue Life In Reactor Water, vol. PVP-306. ASME, New York. O'Donnel, W.J., 1988. Synthesis of S/N and da/dN Life Evaluation technologies, PVP Conference, Pittsburgh, vol. 88-PVP-10. ASME Publication. Prater, 1986, Trans. of ASME. J. Eng. Mater. Technol., 108, 2, 10.1115/1.3225837 Ranganath, S., Kass, J.N., Heald, J.D., 1982. Fatigue Behavior of Carbon Steel Components in High-Temperature Water Environments, vol. 770. ASTM STP, Philadelphia, PA, pp. 436–459. Rules for Construction of Nuclear Power Plant Components, 1992. Section III, Division 1. ASME Boiler and Pressure Vessel Code, American Society of Mechanical Engineers. Tentative Structural Design Basis for Reactor Pressure Vessels and Directly Associated Components, 1958. Pressurized, Water Cooled Systems, PB 151987, U.S. Dept. of Commerce, Office of Technical Services, 1 Dec. 1958 Revision. Terrel, 1989, Fatigue life response of ASME SA 106-B steel in pressurized water reactor environments, Int. J. Press. Vessels Pip., 39, 345, 10.1016/0308-0161(89)90107-5 Van Der Sluys, W.A., Yukawa, S., 1995. Status of PVRC Evaluation of LWR Coolant Environmental Effects on the S–N Fatigue Properties of Pressure Boundary Materials, vol. PVP-306. ASME, New York. Van Der Sluys, W.A., 1993. Evaluation of the available data on the effect of the environment on the low cycle fatigue properties in light water reactor environments. Presented at the 6th Int. Symp. on Environmental degradation in Nuclear Power Systems—Water Reactors. TMS/NACE, 1–5 August, San Diego, CA. Ware, A.G., Morton, D.K., Nitzel, M.E., 1995. Application of NUREG/CR-5999 interim fatigue curves to selected nuclear power plant components. NUREG/CR-6260.