Enhanced thermal stability of novel helical-finned jacketed stirred tank heater

Li, 2011, Comparison of fluid flow and heat transfer behavior in outer and inner half coil jackets and field synergy analysis, Appl. Therm. Eng., 31, 3078, 10.1016/j.applthermaleng.2011.05.001 Li, 2011, Fluid flow and heat transfer characteristic of outer and inner half coil jackets, Chinese J. Chem. Eng., 19, 253, 10.1016/S1004-9541(11)60162-6 Dhotre, 2006, Modeling & dynamic studies of heat transfer cooling of liquid in half-coil jackets, Chem. Eng. J., 118, 183, 10.1016/j.cej.2006.02.008 Rosa, 2017, Design of heat transfer surfaces in agitated vessels, Heat Exch. - Des. Exp. Simul., 10.5772/66729 J.Y. Oldshue, J.Y. Oldshue, Fluid Miring Technology McGraw-Hill, New York, 1983. Harnby, 1985 Kähm, 2019, Thermal stability criterion of complex reactions for batch processes, Chem. Eng. Res. Des., 150, 187, 10.1016/j.cherd.2019.07.028 Sutter, 2013, Jacketed Heating, Chem. Process., 17–21 Alvarez-Ramirez, 2000, PI control of continuously stirred tank reactors: Stability and performance, Chem. Eng. Sci., 55, 5497, 10.1016/S0009-2509(00)00173-1 R. Berber, Control of batch reactors: a review, Methods of Model Based Process Control, R. Berber (ed.), Kluwer Academic Publishers, Dordreeht, 1995, pp. 459-493. Bosch, 2004, On-line runaway detection in isoperibolic batch and semibatch reactors using the divergence criterion, Comput. Chem. Eng., 28, 527, 10.1016/j.compchemeng.2003.08.005 Xi, 2018, An adaptive 2DoF P-PI controller based on an improved just-in-time learning technique for ultra-low-velocity linear stages driven by PMLSMs, Precis. Eng., 52, 392, 10.1016/j.precisioneng.2018.01.009 Subramanian, 2008, The dynamics of liquid cooling in half-coil jackets, Chem. Prod. Process Model., 3 Gruver Jr., E. Morris, R. Pike, Chem. Eng. 19 (1998) 149. Fogg, 1973, Heat transfer resistance in half tube and dimpled jackets, Chem. Eng., 69, 76 Markoritz, 1971, Picking the best vessel jacket, Chem. Eng., 15, 156 Garvin, 1999, Understand the thermal design of jacketed vessels, Chem. Eng. Prog., 95, 61 Wang, 2013, Laminar flow and heat transfer characteristics in jackets of triangular flow channels, Chinese J. Chem. Eng., 21, 1224, 10.1016/S1004-9541(13)60631-X Jamshidi, 2013, Experimental analysis of heat transfer enhancement in shell and helical tube heat exchangers, Appl. Therm. Eng., 51, 644, 10.1016/j.applthermaleng.2012.10.008 Jang, 2010, Effects of microstructure and residual stress on fatigue crack growth of stainless steel narrow gap welds, Mater. Des., 31, 1862, 10.1016/j.matdes.2009.10.062 Leggatt, 2008, Residual stresses in welded structures, Int. J. Press. Vessel. Pip., 85, 144, 10.1016/j.ijpvp.2007.10.004 chun Jiang, 2013, A study of the residual stress and deformation in the welding between half-pipe jacket and shell, Mater. Des., 43, 213, 10.1016/j.matdes.2012.07.003 E. Gubskis, Design and Modelling of Vessel with Half-Pipe Coil, (2016) 63. Watson, 2017, Optimising a helical groove seal using computational fluid dynamics, Seal. Technol., 2017, 5, 10.1016/S1350-4789(18)30012-6 Jiang, 2010, Optimization of welding joint between tower and bottom flange based on residual stress considerations in a wind turbine, Energy., 35, 461, 10.1016/j.energy.2009.10.012 Jha, 2020, Enhanced cooling in compact helical tube cross-flow heat exchanger through higher area density and flow tortuosity, Int. J. Heat Mass Transf., 150, 10.1016/j.ijheatmasstransfer.2019.119270 Jha, 2019, Enhanced heat dissipation in helically finned heat sink through swirl effects in free convection, Int. J. Heat Mass Transf., 138, 889, 10.1016/j.ijheatmasstransfer.2019.04.099 V.K. Jha, S.K. Bhaumik, Novel helically finned heat sink to achieve lower operating temperature and higher fin efficiency, in: Proceedings of the 25th National and 3rd International ISHMT- ASTFE, IIT Roorkee, 28-31 Dec, 2019, pp. 1091-1096, Doi: 10.1615/IHMTC-2019.1830. Srinivasan, 1968, Pressure drop and heat transfer in coils, Chem. Eng., 218, 113 V.K. Jha, S.K. Bhaumik, Enhanced heat transfer in helical tube condenser: CFD analysis, in: Proceedings of the 24th National and 2nd International ISHMT- ASTFE, BITS Pilani Hyderabad Campus, 27-30 Dec, 2017, pp. 1705–1712. Doi: 10.1615/IHMTC-2017.2370. Jha, 2020, Comparative assessment of mixing in compact coiled flow inverters under diffusion free laminar flow condition, Chem. Eng. Res. Des., 159, 455, 10.1016/j.cherd.2020.04.028 J.R. Couper, W.R. Penny, J.R. Fair, S.M. Walas. (2005). Chem. Process Equip.: Selection and Design (2nd edition), Burlington, Elsevier Science. Doi: 10.1016/b978-075067510-9/50040-1. Reindl, 2008, Experimental verification of a solar hot water heating system with a spiral-jacketed storage tank, J. Mech. Sci. Technol., 22, 2228, 10.1007/s12206-008-0703-3 Marvin, 1967, Convective heating in regions of large favorable pressure gradient, AIAA J., 5, 1940, 10.2514/3.4344